Selective separation of yttrium from rare earth elements by ion interaction chromatography. Analytical and larger scale applications

ABSTRACT

New ion interaction chromatographic (IIC) method employing Kromasil 100 C₁₈ column and tetra-n-butylammonium hydroxide (TBAOH) as an ion interaction reagent (IIR) is able to separate yttrium from Rare Earth Elements (REE) as anionic complexes with nitrilotriacetic acid (NTA). New method for the chromatographic determination of Y in REE mixture was devised and validated by the analysis of the certified reference material (CRM). Potential possibilities of the new chromatographic system for larger scale applications including macro-micro events were demonstrated.     

ABSORPTION AND DESORPTION TO AND FROM LIQUID FILMS ON INCLINED PLANES

Two published theoretical models are examined and applied to experimental results for absorption and desorption. The system used was CO₂/H₂O and studies were made for liquid film flow down inclined planes. Experimental results give “Reduced” values of mass ransfer rates.

Interferometric studies give interfacial concentration, penetration and film depths, and take-up of carbon dioxide. In the case of desorption the interferograms are distorted by “deflections.”

All the experimental values for absorption and desorption differ from those calculated from theoretical models.

Desorption is not a mirror image of absorption, and it is approximately 75% of the transfer rate of absorption over a wide operating range.

A comparison is made of the behaviour of static pools and flowing liquid films.     

Microstructure of high modulus solid state extruded polyethylene: 2. X-ray scattering studies of 12, 24 and 36 extrusion draw ratio

The microstructure of a series of solid state extruded polyethylene fibres was examined by wide- and small-angle X-ray scattering. By measuring absolute intensities using a two dimensional position sensitive detector, accurate values of the small-angle invariant for anisotropic samples were obtained. This measurement coupled with wide-angle X-ray scattering and d.s.c. permitted determination of the density of the noncrystalline component. The use of a two phase model for solid state extruded polyethylene is justified if consideration is given to the effective densities of the crystalline and noncrystalline phases, which change with deformation. The effective density of the crystalline phase decreases by 1% (0.999–0.990 g cm^?3) from the unextruded billet compared to a 36 draw ratio extrudate, while the noncrystalline phase density increases by 6% (0.84–0.89 g cm^?3). These changes lead to an overall decrease in the mean squared electron density fluctuation of 63%. The average axial crystallite length measured by wide-angle X-ray scattering increases with extrusion draw ratio while the SAXS long period decreases and weakens considerably. These observations and the electron microscopy results from the previous paper, (Polymer, 1982, 23, 1069), are fully consistent with the key features of the Peterlin model of fibre microstructure.     

Pathways for fatty acid elongation and desaturation in Neurospora crassa

Neurospora crassa incorporated exogenous deuterated palmitate (16∶0) and ¹⁴C-labeled oleate (18∶1^Δ9) into cell lipids. Of the exogenous 18∶1^Δ9 incorporated, 59% was desaturated to 18∶2^Δ9,12 and 18∶3^Δ9,12,15. Of the exogenous 16∶0 incorporated, 20% was elongated to 18∶0, while 37% was elongated and desaturated into 18∶1^Δ9, 18∶2^Δ9,12, and 18∶3^Δ9,12,15. The mass of unsaturated fatty acids in phospholipid and triacylglycerol is 12 times greater than the mass of 18∶0. Deuterium label incorporation in unsaturated fatty acids is only twofold greater than in 18∶0, indicating a sixfold preferential use of 16∶0 for saturated fatty acid synthesis. These results indicate that the release of 16∶0 from fatty acid synthase is a key control point that influences fatty acid composition in Neurospora.     

Synthesis and photo-induced solution properties of new rigid-rod polyimides

A series of new, substituted pyromellitic dianhydrides were synthesized from 1,2,4,5-tetramethylbenzene. New soluble rigid-rod polyimides were obtained from the dianhydrides and 2,2′-bis(trifluoromethyl)-4,4′-biphenyl (PFMB) in phenolic solvents in the presence of isoquinoline as a catalyst. The polyimides are soluble in N-methyl-2-pyrrolidone (NMP), N,N-dimethylacetamide (DMAc), m-cresol and other solvents, in spite of having no bending in their rigid structures.

UV irradiation changed color of the polyimide solutions and also their viscosity. We observed new absorbance in the 700-nm region and an ESR signal by UV irradiation. The new visible absorbance and the ESR signal are derived from the same origin. They are attributed to the anion radical of the diimide moiety in the polyimide as deduced from the hyper fine structure of the ESR signal. In addition, UV irradiation diminishes the solution viscosity.     

Simple approach for the plasma treatment of polymeric membranes and investigation of the aging effect

The modification of the surface characteristics after treatment with plasma in polymeric materials, such as the aging phenomenon, calls the attention of research in the area of nonthermal plasma technology. In this work, a direct treatment with dielectric-barrier discharge plasma was used on the surfaces of ultrafiltration membranes. The measurements of the contact angle with water, attenuated total reflectance accessory, zeta potential, atomic force microscopy and scanning electron microscopy-MEV were performed on the surfaces to verify changes after plasma treatment and to understand the occurrence and timing of the plasma aging effect. In the analysis of the membrane performance, hydraulic permeation and protein retention tests were performed. The results showed an improvement in wettability and hydrophilic properties in the post-treated membranes. The study of reversibility/aging of the post-plasma surface is important for research that deals with the modification of polymeric membranes. Changes in surface morphology, topography and wettability of the membranes were observed up to seven days after treatment, with a tendency to return to the initial characteristics of the membranes.     

Sustainable end-of-life vehicle recycling: R&;D collaboration between industry and the U.S. DOE

Approximately 15 million cars and trucks reach the end of their useful life in the United States each year. More than 75% of the materials from end-of-life vehicles are profitably recovered and recycled by the private sector; automotive materials recycling is a success story. To achieve greater fuel efficiency and safety, today’s cars incorporate an increasing share of innovative light-weight materials. While these materials greatly enhance efficiency during vehicle use, they can present special challenges for recycling. These challenges will persist as automotive designs and the mix of materials used in vehicles continue evolving to further improve safety and performance. To meet the challenges of automotive materials recycling, the U.S. Department of Energy has recently expanded its collaborative research with industry in this area. This article discusses this collaborative government/industry approach to sustainable end-of-life vehicle recycling. For more information, contact Edward J. Daniels, Argonne National Laboratory, 9700 S. Cass Avenue, Building 362, Room C393, Argonne, IL 60439-4815; (630) 252-5279; fax (630) 252-1342; e-mail edaniels@anl.gov.     

Extended Reflexive Ontologies for the Generation of Clinical Recommendations

Decision recommendations are a set of alternative options for clinical decisions (e.g., diagnosis, prognosis, treatment selection, follow-up, and prevention) that are provided to decision makers by knowledge-based Clinical Decision Support Systems (k-CDSS) as aids. We propose to follow a “reasoning over domain” approach for the generation of decision recommendations by gathering and inferring conclusions from production rules. In order to rationalize our approach, we present a specification that will sustain the logic models supported in the knowledge bases we use for persistence. We introduce first the underlying knowledge model and then the necessary extensions that will convey toward the solution of the reported needs. The starting point of our approach is the proposition of Reflexive Ontologies (RO). Here, we go a step further, proposing an extension of RO that includes the handling and reasoning that production rules provide. Our approach speeds up the recommendation generation process.     

A noise immunity controlled quantum teleportation protocol

Quantum Information Processing - With the advent of the Internet and information and communication technology, quantum teleportation has become an important field in information security and its...     

Food-water security and virtual water trade in the Middle East and North Africa

The purpose of this study is to analyze the political economy of food-water security in the water-scarce Middle East and North Africa region. The study deploys the lens of virtual water trade to determine how the region's economies have met their rising food-water requirements over the past three decades. It is shown that the region's water and food security currently depend to a considerable extent on water from outside the region, ‘embedded’ in food imports and accessed through trade. The analysis includes blue (surface and groundwater) and green water resources.