HfOxNy的场发射特性

用直流溅射和高温退火相结合的方法制备了HfOxNy薄膜并测试了其场发射性能,发现其具有较低的开启电场、较大的发射电流密度以及很好的发射稳定性.高压"锻炼"对提高HfOxNy场发射性能起着关键作用,这与高压"锻炼"下薄膜内部结构和表面性质的改变有关.对场发射机理的研究表明,HfOxNy的场发射符合经典的FN隧穿理论.     

加强无线电管理,日常监督检查势在必行

随着社会经济的迅速发展,无线电通信事业取得了很大进步,无线电通信广泛应用于各行各业,在经济发展、社会进步中发挥了重要的作用.但目前一些单位和个人无视国家有关频率管理和无线电设备管理的有关法规,擅自占用频率和非法设台情况比较严重,极大地损害了电磁环境和秩序,干扰了航空导航、公安、消防、护林防火、“三防”等重要通信业务,对无线电通信的可持续性发展造成了极大隐患,加强无线电管理日常监督检查势在必行.     

Flammability and thermal stability studies of ABS/Montmorillonite nanocomposite

Acrylonitrile–butadiene–styrene (ABS)/montmorillonite nanocomposites have been prepared using a direct melt intercalation technique by blending ABS and organophilic clay of two different particle sizes: OMTa (5 µm) and OMTb (38 µm). Their structure and flammability properties were characterized by X‐ray diffraction, high resolution electronic microscopy (HREM), thermogravimetric analysis (TGA) and cone calorimeter experiments. The results of HREM showed that ABS/5 wt% OMTa nanocomposite was a kind of intercalated–delaminated structure, while ABS/5 wt% OMTb nanocomposite was mainly an intercalated structure. The nanocomposites showed a lower heat release rate peak and higher thermal stability than the original ABS by TGA and cone calorimeter experiments. Also, the intercalated nanocomposite was more effective than an exfoliated–intercalated nanocomposite in fire retardancy. Copyright © 2003 Society of Chemical Industry     

一个面积和功耗优化且适用于10/100 Base-T以太网的CMOS时钟恢复电路

提出了一个新的用于10 / 10 0 Base- T以太网中面积和功耗优化的时钟恢复电路.它采用双环路的结构,加快了锁相环路的捕获和跟踪速度;采用复用的方式,通过选择信号控制电路可分别在10 Mbps或10 0 Mbps模式下独立工作且能方便地实现模式间的互换,与采用两个独立的CDR电路相比节省了一半的面积;同时,电路中采用一般的延迟单元来取代DL L,并能保证环路性能不随工艺温度等条件引起的延迟单元、延迟时间的变化而变化,从而节省了功耗.Hspice模拟结果显示,在Vdd=2 .5 V时,10 0 Mbps模式下电路的功耗约为75 m W,稳态相差为0 .3 ns;10 Mbps模式时电路功耗为5 8m W     

STRUCTURE REPRESENTATION OF THE SPECIFIC FRACTIONS FROM PINGSHUO COAL

Basic data of four fractions, PM₁, PM₆, PM₇and PM₈, derived from Pingshuo bituminous coal were obtained by ultimate analyses, mean molecular weight measure, GC/MS, ¹³C-NM R, ¹H-NM R and FTIR technigues. A method of calculating the average molecular parameters of the fractions is introduced. Based on the calculated parameters, the molecular structure models of the fractions of PM₆, PM;and PM₈are constructed. Significant structural information about the saturated hydrocarbon and aromatic hydrocarbon with heteroatom groups is given also.     

渤中28－1（BZ28－1）油田N6H水平井动态分析

本文以渤中２８－１（ＢＺ２８－１）油田Ｎ６Ｈ水平井为例，从多方面对该井的动态和产能变化进行了系统分析，所用的方法对水平井动态分析有一定的指导意义。     

微机模拟处理pH络合滴定法研究——Ⅱ.终点确定方法和最佳实验条件模拟估计程序

本文利用简便的滴定过程模型,确立了微机模拟处理实验数据,方便、准确地求解络合滴定等当点的方法。设计了最佳实验条件模拟估计程序。该法测定Zn~(2+),Pb~(2+),Cu~(2+),Fe~(3+)结果的相对误差Δ<1％。pH=6-7时,测定Ca~(2+)的相对误差为-1.61％;σ<0.001mmol,(N=5)。     

Luminescence Characterization of Mg Doped Y2O2S:Ti Long Afterglow Phosphor

Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors with long afterglow were synthesized by solid state reaction route. The photoluminescence spectra, decay curves, thermoluminescent spectra and chromaticity coordinate curves were investigated. The results show that the luminescence intensity of Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors decrease gradually with increasing Mg2 ion content, and the shape of luminescence spectra and chromaticity coordinate change as well. Furthermore, two thermoluminescent peaks in single Ti-doped Y2O2S sample are found at 91.8 and 221.5 ℃, respectively. Nevertheless, significant different spectra were found for the Mg, Ti co-doped Y2O2S samples that three thermoluminescence peaks appear at 52.3, 141.7 and 226.8 ℃, respectively. These results indicate that the co-doped Mg ion changes the inherent trap depth of single Ti-doped Y2O2S:Ti phosphor, and induces simultaneously a new trap level in the Y1.94-xMgxO2S:0.06Ti phosphor. Based on the analysis of thermoluminescent spectra, photoluminescent spectra, decay curve and crystal structure defect, it was proposed that the varied structure defect and introduced new trap level by the doped Mg2 ions should be responsible for reducing luminescence intensity and varying color in the Y1.94-xMgxO2S:0.06Ti phosphor.     

有机介质中合成二硫化钛

本文研究了硫化氢与四氯化钛在某些有机介质中的反应，并提出了一个合成二硫化钛的新方法。该法是将干燥的硫化氢通入沸腾的四氯化铁的α－氯代萘溶液中，使硫化氢和四氯化钛发生复分解反应而生成二硫化钛。方法简便易行。Ｘ－射线物相鉴定及化学分析结果表明，产物为单一物相的、符合化学计量的二硫化钛。     

坑道用水下堵漏剂的研制

坑道水下堵漏剂的研制包括F－1、F－2和F－3型。其中F－1是一种有机堵漏剂，它可以在水中固化；F－2是一种无机防水堵漏剂，施工方便；F－3是速凝型，它可在瞬间固化，能对坑道的涌水口进行堵漏。