Synchronous multicast and broadcast service in multi-rate IEEE 802.16j WiMAX relay network

IEEE 802.16j Mobile Multihop Relay Standard defines multi-hop relay operation in a WiMAX system. It uses a novel synchronous multicast and broadcast transmission mechanism to achieve macro diversity. With the newly introduced synchronous delivery constraint, the multicast data delivery algorithm should be designed differently to enhance system performance. This paper provides Multi-Rate Selection Algorithm (MRSA) for multicast and broadcast (MBS) data delivery. It could reduce the data distribution delay from the BS to all the RSs. Besides, we also propose the path selection algorithm to further improve the effectiveness of MRSA. Our simulation results show that using MRSA with our shortest-path path selection algorithm, the delay for data delivery in 802.16j MBS system could be greatly reduced. The proposed scheme could achieve the performance closed to the optimal solutions. To the authors’ best knowledge, this is the first research work to investigate the IEEE 802.16j multicast and broadcast problem.     

Dual-output switched-capacitor DC–DC converter with pseudo-three-phase swap-and-cross control and amplitude modulation mechanism

This paper presents an inductorless dual-output switched-capacitor DC–DC converter employing pseudo-three-phase swap-and-cross control (PTPSCC) and an amplitude modulation mechanism (AMM). The AMM circuit scales the amplitudes of the driving signals for the switches according to the loading conditions in order to minimize switching losses. To reduce output ripples, average charge distribution, and improve regulation, the PTPSCC circuit continuously switches power transistors to deliver enough charge to the outputs by keeping at least one flying capacitor connected to each output. The switched capacitor DC–DC converter was implemented in a standard 0.18-μm 3.3-V CMOS process. Measurements were used to verify that the proposed converter provides dual independently regulated output voltages without cross regulation. The two outputs were regulated at 2.5 and 0.8 V with input ranges of 1.7–2 V. The maximum output loading was 100 mA for both outputs. A power efficiency of 90.5% was achieved at a maximum total output power of 330 mW with a switching frequency of 500 kHz, and a maximum power efficiency of 92.1% was achieved for a total output power of 210 mW. The maximal peak-to-peak output ripple voltages for the two outputs at 100 mA load currents were suppressed to below 26 and 20 mV, respectively.     

The Adaptive Ontology-Based Personalized Recommender System

Recommender systems provide strategies that help users search or make decisions within the overwhelming information spaces nowadays. They have played an important role in various areas such as e-commerce and e-learning. In this paper, we propose a hybrid recommendation strategy of content-based and knowledge-based methods that are flexible for any field to apply. By analyzing the past rating records of every user, the system learns the user’s preferences. After acquiring users’ preferences, the semantic search-and-discovery procedure takes place starting from a highly rated item. For every found item, the system evaluates the Interest Intensity indicating to what degree the user might like it. Recommender systems train a personalized estimating module using a genetic algorithm for each user, and the personalized estimating model helps improve the precision of the estimated scores. With the recommendation strategies and personalization strategies, users may have better recommendations that are closer to their preferences. In the latter part of this paper, a real-world case, a movie-recommender system adopting proposed recommendation strategies, is implemented.     

Electrophosphorescent Polyfluorenes Containing Osmium Complexes in the Conjugated Backbone

Electrophosphorescent copolymers have been synthesized by covalent bonding of a red‐emitting osmium complex Os(bpftz), which contains two 3‐trifluoromethyl‐5‐(4‐tert‐butyl‐2‐pyridyl)triazolate (bpftz) cyclometalated ligands, into the backbone of a bipolar polyfluorene (PF) copolymer. Employing these copolymers, a highly efficient red polymer light‐emitting diode has been realised that has an external quantum efficiency of 18.0%, a maximum brightness of 38 000 cd m^?2, and an emission centered at 618 nm. In addition, after incorporating appropriate amounts of green‐emitting benzothiadiazole (BT) and the aforementioned Os(bpftz) into the bipolar PF, an efficient white‐light electroluminescent polymer is obtained that displays simultaneous blue, green, and red emissions.     

HMM-based ball hitting event exploration system for broadcast baseball video

With the dramatic growth of fandom population, a considerable amount of research efforts have been devoted to baseball video processing. However, little work focuses on the detailed follow-ups of ball hitting events. This paper proposes a HMM-based ball hitting event exploration system for broadcast baseball video. Utilizing the strictly-defined layout of the baseball field, the proposed system first detects the game-specific spatial patterns in the field, such as the field lines, the bases, the pitch mound, etc. Then, the play region—the currently camera-focused region of the baseball field is identified for frame type classification. Since the temporal patterns of presenting the game progress follow a prototypical order, we consider the classified frame types as observation symbols and recognize ball hitting events using HMM. Experiments conducted on broadcast baseball video show encouraging results in frame type classification and ball hitting event recognition. Three practical applications, including highlight clip extraction by user-designated query, storyboard construction, and similar event retrieval, are introduced to address the applicability of our system.     

An MCT-Based Bit-Weight Extraction Technique for Embedded SAR ADC Testing and Calibration

This paper presents a self-testing and calibration technique for the embedded successive approximation register (SAR) analog-to-digital converter (ADC) in system-on-chip (SoC) designs. We first proposed a low cost design-for-test (DfT) technique that estimates the SAR ADC performance before and after calibration by characterizing its digital-to-analog converter (DAC) capacitor weights (bit weights). Utilizing major carrier transition (MCT) testing, the required analog measurement range is only about 1 LSB; this significantly reduces test circuitry complexity. Then, we develop a fully-digital calibration technique that utilizes the extracted bit weights to correct the non-ideal I/O behavior induced by capacitor mismatch. Simulation results show that (1) the proposed testing technique achieves very high test accuracy even in the presence of large noise, and (2) the proposed calibration technique effectively improves both static and dynamic performances of the SAR ADC.     

Effect of nanoimprinted surface relief on Si and Ge nucleation and ordering

Surface relief formed by nanoimprinting and etching into a thermally grown SiO₂ layer on Si was used to position the initial nuclei formed by chemically vapor deposited Si and Ge. By controlling the deposition conditions, the surface diffusion length was adjusted to be comparable to or larger than the spacing between features, thus favoring nucleation adjacent to steps, rather than random nucleation. Random nucleation was further suppressed by a two-stage deposition process. Ge nucleation on oxide by chemical vapor deposition was enhanced by coating the oxide surface with an organic self-assembled monolayer (SAM) and by the nanoimprinted surface relief. The nanoimprinted surface relief also provides long-range order in the SAM.     

Effect of rapid thermal annealing on pentacene-based thin-film transistors

The bottom contact pentacene-based thin-film transistor is fabricated, and it is treated by rapid thermal annealing (RTA) with the annealed temperature up to 240 °C for 2 min in the vacuum of 1.3 × 10⁻² torr. The morphology and structure for the pentacene films of OTFTs were examined by scanning electron microscopy and X-ray diffraction technique. The thin-film phase and a very small fraction of single-crystal phase were found in the as-deposited pentacene films. While the annealing temperature increases to 60 °C, the pentacene molecular ordering was significantly improved though the grain size only slightly increased. The device annealed at temperature of 120 °C has optimal electrical properties, being consistent with the experimental results of XRD. The post-annealing treatment results in the enhancement of field-effect mobility in pentacene-based thin-film transistors. The field-effect mobility increases from 0.243 cm²/V s to 0.62 cm²/V s. Besides, the threshold voltage of device shifts from −7 V to −3.88 V and the on/off current ratio increases from 4.0 × 10³ to 8.7 × 10³.     

Analysis of adaptive bandwidth allocation in wireless networks with multilevel degradable quality of service

A wireless/mobile network supporting multilevel quality of service (QoS) is considered. In such a network, users or applications can tolerate a certain degree of QoS degradation. Bandwidth allocation to users can, therefore, be adjusted dynamically according to the underlying network condition so as to increase bandwidth utilization and service provider's revenue. However, arbitrary QoS degradation may be unsatisfactory or unacceptable to the users, hence resulting in their subsequent defection. Instead of only focusing on bandwidth utilization or blocking/dropping probability, two new user-perceived QoS metrics, degradation ratio and upgrade/degrade frequency, are proposed. A Markov model is then provided to derive these QoS metrics. Using this model, we evaluate the effects of adaptive bandwidth allocation on user-perceived QoS and show the existence of trade offs between system performance and user-perceived QoS. We also show how to exploit adaptive bandwidth allocation to increase system utilization (for the system administrator) with controlled QoS degradation (for the users). By considering various mobility patterns, the simulation results are shown to match our analytical results, demonstrating the applicability of our analytical model to more general cases.     

Novel Optical Phase Demodulator Based on a Sampling Phase-Locked Loop

A novel phase-locked coherent demodulator, based on a sampling phase-locked loop, is presented and investigated theoretically. The demodulator is capable of operating at high frequencies, by using optical sampling to downconvert the high-frequency input radio-frequency signal to the frequency range of the baseband loop. We develop a detailed theoretical model of the (sampling) phase-locked coherent demodulator and perform detailed numerical simulations. The simulation results show that the operation of the sampling demodulator resembles the operation of the baseband demodulator for very short optical pulses (<2 ps). Furthermore, we investigate how the signal-to-noise ratio of the demodulator is affected by timing and amplitude jitter of the pulsed optical source