The chemical composition of muscles from steers which experienced compensatory growth

The psoas major and semitendinosus muscles from ten Hereford Shorthorn steers were analysed. Five of the steers had been severely restricted in their diet during an Irish winter period (temperature range 3–13°) of 20 weeks. The remaining five were used as controls and were adequately fed throughout their lives. After the restriction period the five diet-restricted animals were adequately fed for 22 weeks. All ten steers were then slaughtered at the age of 20 months. Within each type of muscle there were no significant differences between treatments in the components, moisture, intramuscular fat, total protein, ash, intramuscular collagen, hexosamine hydrochloride, or in Warner Bratzler shear values. The correlations between intramuscular fat and shear values, and between hexosamine hydrochloride and shear values were low and not significant. Collagen contents correlated significantly with shear values at the 10% level of significance. There was no evidence that variation in tenderness (as measured by shear values) could be attributed to the pre-slaughter treatment or that any deterioration in meat quality was caused by this treatment.     

Structures revealed in zone refined aluminum by tritium decoration

A method is described for decorating structures in solid aluminum by precipitation of hydrogen onto them. Radioactive hydrogen is employed so that the deposition sites can be revealed by the use of autoradiographic techniques. The study was conducted with zone refined aluminum, and the primary structure that was revealed was that remaining after directional solidification during the last zone pass. The tritium was added to the specimen at 600°C and its precipitation was brought about by quenching the sample. As little as 0.05 ppm of tritium was sufficient to reveal complex structures in the cast metal that are attributed to association of unidentified residual impurity atoms with low angle subgrain boundaries that are thought to have resulted from polygonization occurring immediately behind the advancing solid-liquid interface. Wide-angle grain boundaries were also decorated. New structures were introduced by various levels of strain that accompanied different upsetting operations. Grain and subgrain boundaries that developed during strain anneals were “antisites” for hydrogen deposition. This opposite behavior is attributed to the absence of impurity atoms in these “new” boundaries. An explanation for the behavior of hydrogen in aluminum is given in terms of the condensation of vacancies vs their loss to vacancy sinks. These phenomena are shown to be involved in the enlargement of hydrogen-filled pores in aluminum.     

Effect of season of application on the adhesion, retention and recontamination of herbage by potentially toxic metals and sewage sludge

Grassland in the United Kingdom can accept sewage sludge when, as a result of cropping restrictions, arable land cannot. However, one of the uncertainties associated with the application of sewage sludge to grassland is the potential exposure of the grazing ruminant to sewage sludge particulates adhered to the grass or deposited on the soil surface. The implications of elevated levels of sludge particulates and associated potentially toxic metals (PTMs) are the potential accumulation of PTMs into edible tissues of the grazing animal. Two experiments were performed to investigate the effect of season of application on the adhesion, retention and recontamination of herbage by sewage sludge and PTMs. In each experiment, three treatments were installed, an untreated control, application of sludge in the autumn and application of sludge in the spring. Sewage sludge particulates and PTMs were eluted sequentially 21 days after the application of sludge using water and detergent and the residual (tissue) concentrations were monitored. Total concentrations in each fraction and adhesion indices were calculated. Soil samples taken from the sward treatments after each application showed no elevated concentrations of PTMs or concentrations that approached the maximum concentrations allowed for soils amended with sewage sludge. The amounts of sludge adhered to herbage ranged from 114 to 360 g sludge DM/kg herbage DM. There was evidence of preferential retention of PTMs to herbage. However, during the 21-day no grazing period there was a general decline in concentration of all PTMs. Copper was retained on the herbage for greater periods of time compared to Zn, CD, Pb and Fe (P < 0.01). The proportion of Pb recovered from the water phase increased during the 21-day no grazing period in comparison to Cu, Zn and Fe (P < 0.001). It is concluded that the concentrations of PTMs adhered and integral to herbage as a result of surface application of sewage sludge are likely to fall to acceptable levels in well-managed permanent grassland.     

The variation in biological effectiveness of X-rays and gamma rays with energy

The ICRP has attributed the same relative risk for all low-LET (linear energy transfer) radiations, including X and gamma radiations of all energies. However, very low energy X-rays are expected to be more biologically effective, per unit absorbed dose, than high energy X-rays or gamma rays due to the production of lower energy secondary electrons, with a correspondingly higher LET. This increase in relative biological effectiveness (RBE) is also seen experimentally for a range of biological end-points, however, a wide range of RBE values have been reported. The assessment of risks is particularly important due to the use of low energy X-rays for mammography screening. A review of the published data on the variation in biological effectiveness with energy is presented here.     

Effect of environmental hydrogen pressure on the hydrogen yield from x-irradiated polyethylenes

An experimental assembly incorporating a capacitance-type, differential pressure transducer, which provides resolutions of 3 × 10^?4 torr at pressures extending to 30 torr, has been employed to monitor the effect of hydrogen environmental pressure on the hydrogen yield from x-irradiated polyethylenes. Contrary to the observations of previous investigators, the hydrogen yield is found to be independent of hydrogen environmental pressures extending over the critical range up to at least 30 torr. It is demonstrated that neglecting the temperature and density gradients inherent in closed-volume irradiation assemblies employing cryogenic traps to separate liberated gases into condensable and noncondensable fractions may lead to erroneous conclusions with respect to gas yields arising from the irradiation of materials. A homogeneous, variable-plate separation ion chamber consisting of a polyethylene body and utilizing flowing ethylene as the cavity gas was employed to obtain total volatile G values of 3.6 ± 0.4, 3.8 ± 0.4, and 4.0 ± 0.4 molecules/100 e.v., for Marlex 6002, Dow Ziegler (Q 917.5), and DuPont A-1410 polyethylenes, respectively. A hydrogen contribution of approximately 98 mole-% was obtained with this experimental method.     

Fracture toughness of tooth acrylics

The hardness, fracture toughness, toughness, flexural strength and Youngs moduli of three acrylic tooth polymers were investigated. The first polymer was based on a conventional homopolymer poly(methylmethacrylate). The second was based on cross-linked poly(methylmethacrylate) with an uncross-linked poly(methylmethacrylate) coating. The third material was based on an interpenetrating polymer network (IPN) of a cross-linked and uncross-linked poly(methylmethacrylate). All three polymers had similar hardness values. The cross-linked and IPN polymers had higher fracture toughness (K_IC) and toughness (G_IC) values than the conventional homopolymer poly(methylmethacrylate) polymer and lower flexural strengths (_f). The toughness of the cross-linked and IPN polymers was higher due to crack deflection around the polymer bead structure and the polymer beads acting as crack pinning sites.     

Rutherford backscattering spectrometry and computer simulation for the in-depth analysis of chemically modified poly(vinylidene fluoride)

The alkaline treatment of poly(vinylidene fluoride) (PVdF), in the presence of phase transfer catalysts (PTCs) has been investigated. Rutherford backscattering spectrometry (RBS) has been used to determine the depth of modification achieved and to provide compositional depth profiles of modified PVdF samples. The complex chemical nature of the modified substrate, and the overlap of the elemental scattering edges within the depths involved (up to 1.4 m), create RBS spectra which are difficult to interpret. The DataFurnace software has been applied to the data, leading to excellent results. Defluorination and oxygenation of PVdF occurs on treatment with NaOH and PTC. Through the use of samples prepared with the aim of establishing the kinetics of the modification, a mechanism concerning elimination of fluorine followed by oxygenation, is shown to occur. The RBS analysis indicates that the kinetics of the defluorination reaction follows the Case 1 (Fickian) diffusion law, and that the depth of treatment is of the order of 1.4 m.