拉伸速率对PP/GB复合材料力学性能的影响

应用Instron材料试验机考察了室温下拉伸速率对玻璃微珠填充聚丙烯复合材料的弹性模量和屈服强度的影响，结果表明，随着微珠含量的增加，试样的弹性模量（Ec）增大，且与拉伸应变速率呈近乎幂律函数关系，而屈服强度（бyc）则随着微珠体积分数（Φf）的增加呈线性函数形式下降，并随着拉伸应变速率的增加呈幂律函数形式提高，此外，讨论了Ec、Φf与бyc三者之间的关系。     

竹坑水库大坝安全鉴定分析

在竹坑水库大坝安全鉴定中,认真分析了该工程存在的主要问题,并针对大坝的结构稳定和渗流稳定作了详细的分析论证.     

CO_2激光对兔脑组织血脑屏障的影响

同等功率和照射时间条件下,在14只家兔大脑皮质运用伊文思蓝染料和超微结构观察方法进行血脑屏障改变的研究。结果表明:CO_2激光作用十分表浅,且激光作用后的水肿层血脑屏障改变是可逆的。     

Ca原子的Penning离化

用614.3nm染料激光照射以Ne为缓冲气体的Ca空心阴极灯,观察到了Ca原子的Pen-ning离化效应。对比在Li空心阴极灯中获得的光电流信号,解释了Ca原子的彭宁离化。     

自适应相位制中波同步广播及现场试验

在本试验中，采用智能同步广播激励器和ＣＣＴＶ传输的１ＭＨｚ标频，实现了中波同步广播同频保护率趋于０ｄＢ．并提出了自适应相位跟踪同步的概念。     

光纤的淬冷增强原理

本文从拉丝工艺技术的角度出发，讨论了高速、高温拉丝工艺方法对光纤的淬冷增强原理。     

Enhancement of oxide break-up by implantation of fluorine inpoly-Si emitter contacted p+-n shallow junctionformation

In this study, it is demonstrated that the incorporation of fluorine can enhance poly-Si/Si interfacial oxide break-up in the poly-Si emitter contacted p⁺-n shallow junction formation. The annealing temperature for breaking up the poly-Si/Si interfacial oxide has been found to be as low as 900°C. As a result, the junction depth of the BF₂-implanted device is much larger than that of the boron-implanted device     

内燃机车曲轴中频淬火过程的数值模拟

借助 ANSYS大型有限元分析软件 ,实现了 16 V2 4 0曲轴淬火过程的计算机模拟 ,模拟结果可直观地显示出任一时刻曲轴表面及内部的温度分布、冷却曲线以及淬火结束后的残余应力分布 ,并能预测淬硬层深度。同时对比了轴颈内圆角处进行淬火和不进行淬火两种工艺的效果 ,为现场提供了用虚拟现实方法详尽分析和研究淬火工艺的工具。     

Performance analysis of adaptive interleaving for OFDM systems

We proposed a novel interleaving technique for orthogonal frequency division multiplexing (OFDM), namely adaptive interleaving, which can break the bursty channel errors more effectively than traditional block interleaving. The technique rearranges the symbols according to instantaneous channel state information of the OFDM subcarriers so as to reduce or minimize the bit error rate (BER) of each OFDM frame. It is well suited to OFDM systems because the channel state information (CSI) values of the whole frame could be estimated at once when transmitted symbols are framed in the frequency dimension. Extensive simulations show that the proposed scheme can greatly improve the performance of the coded modulation systems utilizing block interleaving. Furthermore, we show that the adaptive interleaving out performs any other static interleaving schemes, even in the fast fading channel (with independent fading between symbols). We derived a semi-analytical bound for the BER of the adaptive interleaving scheme under correlated Rayleigh fading channels. Furthermore, we discussed the transmitter-receiver (interleaving pattern) synchronization problem     

机械合金化Zr-Al-Ni-Cu-Ag非晶合金的晶化行为

研究了机械合金化非晶态Zr65Al7.5Ni10Cu7.5Ag10合金的晶化过程，由于存在扩散不均匀区，机械合金化非晶合金在深过冷液相区的退火组织不同于快淬合金，在深过冷液相区退火，析出二十面体准晶相及一些知相：在靠近第一个放热峰的温度退火，近出Zr2Cu相：第二个放热峰对应残余非晶相及准晶相向Zr2Ni,Zr2-Al3的转变。