Optimal Performance in Tracking Stochastic Signal Under Disturbance Rejection

The analysis method of optimal tracking performance is proposed for multiple‐input multiple‐output (MIMO) linear time‐invariant (LTI) systems under disturbance rejection. An H₂ criterion of the error signal between the output of the plant and the reference signal is used as a measure for the tracking performance. Spectral factorization is applied to obtain the optimal solution of the system tracking error. The explicit expressions are derived for this minimal tracking error with respect to random reference signals under disturbance rejection. It is shown that the nonminimum phase zeros, the zero direction, the unstable poles, the pole direction of a given plant, statistical characteristics of the reference input signal, and disturbance signal have a negative effect on a feedback system's ability to reduce the system error with disturbance rejection. The results show that the optimal tracking performance will further be damaged because of disturbance rejection. Some typical examples are given to illustrate the theoretical results.     

方柱体镦粗的两个新力学模型

在对平板间镦粗圆柱体的研究［１，２，３］基础上，进一步对普通平板间的方柱体镦粗，进行了工程力学的分析，提出了二个新力学模型，并进行了实验验证。这为形成新的拔长理论［４，６］奠定了力学基础。     

Mg-Sr牺牲阳极显微组织和电化学性能的研究

研究了Mg-Sr牺牲阳极的显微组织和电化学性能的特征.结果表明,Mg-Sr牺牲阳极的晶粒尺寸随Sr含量的增加而减小;当Sr质量分数为0.19%时,电流效率达到58.56%,开路电位达到-1.735 VSCE;Sr的质量分数再增加,Mg-Sr阳极的电流效率降低,开路电位正移.研究认为,Sr的质量分数为0.19%时,晶界析出的Mg17Sr2相（弱阴极相）和α-Mg基体（阳极相）组成电偶对,阻碍了阳极晶间腐蚀,减少了晶粒大块脱落, 且Sr能够和Mg、Fe形成弱阴极性化合物降低Fe的危害,电流效率升高,同时晶粒细化,晶界面积变大,杂质相分布更均匀,开路电位负移;Sr含量大于0.19%时,过量的Mg17Sr2相作为阴极相加大了阳极的自腐蚀,电流效率下降,开路电位正移.     

Oxidation Behavior of a Single-Crystal Ni-Base Superalloy in Air—II: At 1000, 1100, and 1150°C

The oxidation behavior of a single-crystal (SC) Ni-base superalloy was studied over the temperature range from 1000–1150°C and analysed by TGA, XRD, EDAX, and SEM. The results indicated that the SC Ni-base superalloy exhibited parabolic oxidation kinetics, which were controlled by the growth of the inner -Al₂O₃ layer. A mixed scale formed on the SC Ni-base superalloy after prolonged oxidation. The scale consisted of an outer layer of spinel, a sublayer of mainly -Al₂O₃ with small amount of spinel adjoined by a very thin and even discontinuous layer of CrTaO₄-rich oxide, and an inner -Al₂O₃ layer. The inner -Al₂O₃ layer provided good protection. No internal oxides or nitrides were observed below the inner -Al₂O₃ layer after 1000 hr at 1000°C, and after 200 hr at 1100 and 1150°C.     

不同形貌氢氧化镁的化学合成及影响因素

对不同形貌氢氧化镁的化学合成及外部生长环境进行了综述。尤其对影响氢氧化镁结晶性能和形貌起关键作用的因素，如碱性沉淀剂的选择、合成温度的确定、不同镁盐的影响、碱和镁盐的初始浓度及配比、水热处理、反应物的混合方式、晶形控制剂的加入等，进行了详细的阐述。     

HS－900有机硅密封抗渗防水剂性能的研究

ＨＳ－９００有机硅密封抗渗防水剂是一种新型的有机硅改性硅酸盐防水材料。具有良好的抗渗性能和耐酸碱腐蚀能力。将其涂于低标号混凝土材料上，效果尤其明显。     

基于结构方程模型的征地对移民福利影响分析

为了解工程征地对农村移民福利的影响,采用结构方程模型,对南水北调丹江口水库移民进行了实证分析,结果表明:搬迁前后土地面积变化、土地质量变化尤其是补偿标准高低这3方面的征地状况对水库移民福利具有比较显著的影响,其中前者为负向影响,后两者为正向影响;水库移民福利与发展机遇、经济收支、社会适应、居住条件、社会保障的关系显著。因此,水库移民安置应合理提高征地补偿标准,大力实施精准帮持改善移民的发展机遇与经济收支等状况,以确保移民福利改进与获得感增强。     

A perceptual evaluation of grating frequencies and velocities in the analysis of dynamic images

Dynamic images that possess beauty and are user-friendly can increase the use of digital technology. In addition to information conveyance, dynamic images also act as a communication bridge in the human–machine interface. Dynamic images are widely used in the application of digital media. Therefore, understanding the visual effects of dynamic images on viewers is a very important issue. From a visual communication design perspective, dynamic images influence not only image quality, but also the viewers’ perception and impression of the displayed image. In the contemporary age characterized by universal usage of dynamic images, designers should attain synchronized knowledge and understanding of relevant media technology so as to present preferred design quality in the management of digital design such as animation design, Web page design, multimedia design, and so on. The current study noted that psychological effects such as viewers’ visual attention, preferences, and understanding were more important than image quality. Therefore, this study adopted the viewpoint of “visual design” and conducted a perceptual evaluation of grating frequency and grating velocity. The pair-comparison method and scale method were adopted in the research methodology to simplify perceptual evaluations and enhance their validity. The purpose of this study was: (1) To propose recommendations for displaying dynamic images and improving image performance using perceptual evaluation methods. (2) To examine the influence of psychological factors on viewer’s comfort when they experience dynamic images. (3) To identify the best grating feature combinations that meet viewer’s psychological characteristics and propose recommendations for dynamic images design. The study concludes that it is useful to establish criteria for evaluating users’ perception and to, develop perceptual evaluations of dynamic images. It is recommended that designers find a balance between watching a moving imaging display “clearly” and watching it “comfortably” for successful reception by the viewer.     

Development of polarization ratio model for sea surface wind field retrieval from TerraSAR-X HH polarization data

In this article, the polarization ratio (PR) of TerraSAR-X (TS-X) vertical–vertical (VV) and horizontal–horizontal (HH) polarization data acquired over the ocean is investigated. Similar to the PR of C-band synthetic aperture radar (SAR), the PR of X-band SAR data also shows significant dependence on incidence angle. The normalized radar cross-section (NRCS) in VV polarization data is generally larger than that in HH polarization for incidence angles above 23°. Based on the analysis, two PR models proposed for C-band SAR were retuned using TS-X dual-polarization data. A new PR model, called X-PR hereafter, is proposed as well to convert the NRCS of TS-X in HH polarization to that in VV polarization. By using the developed geophysical model functions of XMOD1 and XMOD2 and the tuned PR models, the sea surface field is retrieved from the TS-X data in HH polarization. The comparisons with in situ buoy measurements show that the combination of XMOD2 and X-PR models yields a good retrieval with a root mean square error (RMSE) of 2.03 m s^–1 and scatter index (SI) of 22.4%. A further comparison with a high-resolution analysis wind model in the North Sea is also presented, which shows better agreement with RMSE of 1.76 m s^–1 and SI of 20.3%. We also find that the difference between the fitting of the X-PR model and the PR derived from TS-X dual-polarization data is close to a constant. By adding the constant to the X-PR model, the accuracy of HH polarization sea surface wind speed is further improved with the bias reduced by 0.3 m s^–1. A case acquired at the offshore wind farm in the East China Sea further demonstrates that the improvement tends to be more effective for incidence angles above 40°.     

Dynamic response of Ti3SiC2 under shock compression up to 112 GPa

Ti₃SiC₂ is of interest due to its unique dual nature reminiscent of both brittle ceramics and ductile metals at ambient conditions. In this work, plate-impact experiments have been performed to study the dynamic behavior of Ti₃SiC₂ under shock compression up to 112 GPa by using laser velocity interferometer and electric pin techniques. Hugoniot elastic limits (HEL), spall strength, and Hugoniot equations of state have been obtained based on measured particle velocity profiles and shock wave velocities. The ratio of spall strength to HEL for Ti₃SiC₂ is larger than brittle ceramics but smaller than metals. This result indicates that the dual nature of Ti₃SiC₂ remains at least up to 10 GPa. On the other hand, the linearity of the Hugoniot equation of state, $D=6.9\text{0}1(22)+1.153(53)u_{\text{p}}$, suggests that the initial structure of Ti₃SiC₂ should be stable up to 112 GPa, in contrast to the result reported by Jordan et al. [J. Appl. Phys., 93 (2003) 9639].