A Study of AlN Films Prepared by Arc Ion Plating

Hexagonal AlN films have been obtained by arc ion plating at different negative biases ,X-ray diffraction and scanning electron microscopy results show that AlN films with smooth surfaces and (002) preferred orientation are obtained at low biases ,whereas those with coarse surfaces and (100) preferred orientation are obtained at high biases,The formation mechanism of AlN is analyzed and the experiment results are discussed,The effect of bias on adhesion strength has also been examined.     

液化气催化氧化脱硫工艺的工业应用

介绍了MOYOX法液化气催化氧化脱硫工艺的工业应用情况。应用结果表明，该工艺流程简单，操作灵活，脱硫效果显著，硫含量可降至3mg／m^3，含硫平均脱除率由74．2％提高为97．7％，铜片腐蚀也得到了明显改善。     

Analytical modeling and experimental study of tensile strength of asphalt concrete composite at low temperatures

In this study, analytical modeling of the tensile strength of hot-mix asphalt (HMA) mixtures at low temperatures was developed. To do this, HMA mixtures were treated as a two-phase composite material with aggregates (coarse and fine) dispersed in an asphalt mastic matrix. A two-phase composite model, which was similar to Papanicolaou and Bakos's [J. Reinforced Plast. Compos. 11 (1992) 104] model with a particle embedded in an infinite matrix, was proposed. Unlike Papanicolaou and Bakos's model, an axial stress was introduced to the fiber end to consider the load transferred from the asphalt mastic the aggregate. Efforts were also made to consider the effect of aggregate gradation, asphalt mastic degradation, and interfacial damage between the aggregates and asphalt mastic matrix on the tensile strength of the HMA mixtures. Experimental investigations were conducted to validate the developed theoretical relations. A reasonable agreement was found between the predicted tensile strength and the experimental results at low temperatures. Parameters affecting the tensile strength of asphalt mixtures were discussed based on the calculated results.     

Prediction of the effects on dynamic response due to distributed structural modification with additional degrees of freedom

The aim of this study is to investigate means of efficiently assessing the effects of distributed structural modification on the dynamic properties of a complex structure. The dynamic properties of the modified structure can be determined by experimental testing or numerical simulation, both of which are complex, expensive and time-consuming. Assuming that the original dynamic characteristics are already established and that the modification is a relatively simple attachment, the modified dynamic properties may be determined numerically without solving the equations of motion of the full-modified structure. The frequency response functions (FRFs) of the modified structure can be computed by coupling the original FRFs and a delta dynamic stiffness matrix for the modification introduced. The validity of this approach is investigated by applying it to a cantilever beam to which a smaller beam is attached as modification. The original FRFs were obtained experimentally as well as numerically. The delta dynamic stiffness matrix was determined numerically by modeling the attachment and part of the original structure including the attachment points. The FRFs of the modified beam were then computed. Good agreement is obtained by comparing the results to the FRFs of the modified beam determined experimentally as well as by numerical modeling of the complete modified structure.     

反复荷载下钢筋混凝土剪力墙的非线性有限元分析

本文介绍了反复荷载下非线性有限元分析程序,该程序针对钢筋混凝土剪力墙类结构的特点,采用了钢筋与混凝土复合单元计算模型,考虑混凝土裂面接触效应的反复加载混凝土应力-应变关系。在钢筋应力-应变关系中,还同时考虑了混凝土开裂后钢筋的拉伸强化效应及反复荷载下钢筋的Bausinger效应。本文还介绍了作者利用该程序对反复荷载试验的试件及Ger-venka的剪力墙板进行的计算分析。结果表明,本文所采用的分析模型是合理、准确的;和国内外以往的分析比较,本文的方法成功地消去了力-位移滞回曲线中的拐点现象,而且计算的混凝土裂缝开闭也能和实测较好地吻合。表明本文方法能为分析反复荷载下钢筋混凝土剪力墙类结构性能提供一个准确、有力的工具。     

穿孔顶头表面氧化膜浅析

分析了穿孔顶头表面氧化膜的形成过程、性质、作用、界面行为，以及对顶头使用寿命的影响。指出了提高该氧化膜耐久性的途径。     

废塑料改性沥青的性能研究

通过沥青基本性能测试、荧光显微镜观察研究了废塑料（PE）对改性沥青高温性能的影响及其机理,并通过对改性沥青混合料的马歇尔稳定度测试及对沥青混合料断口观察研究了混合料的强度及高温性能。结果表明：废PE达到一定剂量时,在沥青中形成网状结构,增强了改性沥青的高温性能；加入废PE后,沥青与矿料的结合强度提高,提高了沥青混合料的高温稳定性。     

火灾中考虑整体性的钢梁破坏形态研究

1990年英国broadgate火灾之后,结构整体性以及由于温度而在整体结构中产生的附加应力得到了人们的重视。处于整体结构中的梁的破坏形态与单个构件的梁的破坏形态有较大差别,当考虑梁的悬链线效应时其抗火承载力明显提高。文章采用大型通用有限元程序ANSYS,对T.C.HLiu所做试验进行了验证,表明了有限元计算悬链线效应的可靠性,同时通过计算分析,提出了处于整体结构中钢梁在火灾中破坏的5个阶段,并给出了钢结构防火的概念设计建议。     

含钒铁水中硅,钛含量对炼钢,炼铁工序指标的影响

利用生产实践数据，分析了铁水中Ｓｉ＋Ｔｉ含理对炼铁焦比、产量、生铁Ｓ以及提钒时的钒回收率、钒渣品位、白灰消耗等工序指标的影响，提出了适合于承钢铁水的Ｓｉ＋Ｔｉ含量。     

高精度合成地震记录制作技术研究

制作高精度的合成地震记录是精细储层描述的基础，本文在分析合成地震记录原理的基础上，从地震剖面的极性判断、平均速度的选取，反射系数的准确提取，子波的精确估算等方面对制作合成记录的要点进行了分析，通过提高以上四方面的精度，提高了制作合成地震记录的精度，并提出了一套可行的合成地震记录的检查方法。