All-trans beta-carotene is absorbed preferentially to 9-cis beta-carotene, but the latter accumulates in the tissues of domestic ferrets (Mustela putorius puro)

The algae Dunaliella bardawil and Dunaliella salina naturally contain large concentrations of all-trans and 9-cis beta-carotene (betaC). The purpose of this study was to compare the relative serum and tissue accumulation of all-trans and 9-cis betaC in ferrets fed different ratios of all-trans/9-cis betaC derived from two commercial sources, D. bardawil or D. salina (Betatene). Male ferrets (7 wk old) were fed carotene-free, pelleted diets for 27 d. Beginning on d 18, groups of ferrets (n = 6 or 7) received daily, one of six oral supplements varying in ratios of 9-cis and all-trans betaC mixed with approximately 1.0mL of Ensure. Four supplements containing 5.2-8.3 micromol total betaC were prepared from a 20% Betatene preparation, D. bardawil, a high-cis Betatene preparation, and Betatene further enriched in 9-cis betaC with all-trans betaC/9-cis betaC ratios of 2.2, 1.5, 0.6 and 0.4, respectively. Two control supplements, high and low betaC, were prepared from commercial betaC beadlets. The high control supplement had an all-trans/9-cis ratio of 19.0, whereas 9-cis betaC was not detected in the low supplement. On d 27, serum and tissues were obtained for HPLC analysis of betaC and its isomers. Analysis of livers showed that all-trans betaC was the primary isomer present, but 9-cis and other isomers were also detected in all groups. The hepatic all-trans/9-cis ratios were 5.9, 4.9, 2.5, 1.4, 52.2 and47.5, respectively, for the groups listed above. Lower amounts of all-trans and 9-cis betaC were found in kidneys compared with the liver, but ratios of all-trans/9-cis were not different among groups. Only trace amounts of 9-cis betaC were found in serum. These results demonstrate that the algae D. bardawil and D. salina provide a bioavailable source of betaC isomers, but, as in humans, absorption of 9-cis betaC is poor and any 9-cis betaC absorbed is apparently cleared by the liver.     

Fractionation studies of palm oil by density gradient

The paper describes a method of fractionating vegetable, animal and fish oils, and in particular palm oil. The method involves addition of a medium comprising two common solvents to the semisolid oils. On centrifugation, the olein and stearin are separated by the medium in the middle. Thirteen media made up from binary combinations of nine solvents, viz. water, propylene glycol, glycerine, methanol, ethanol,n-propanol, isopropanol (IPA), acetone and butanone, are found to be effective in olein-stearin separation. However, only the water/IPA and water/methanol systems have been studied in detail. The aqueous IPA provides a higher yield of olein than water/ methanol but intersolubility between oil and medium is also greater. The fractionation process can be carried out at any suitable temperature. Fractionation of the special prime bleached (SPB) palm oil at 16 C yields an olein with a cloud point of 4.8 C. Some hybrid palm oils produce a large quantity of low cloud point olein which can be bleached readily. The process can be extended to include degumming and neutralization by using an alkaline medium for centrifugation. The olein fractions obtained have been found to be free of phosphatides and the free fatty acids reduced to as low as 0.02%. Metal-scavenging agents have also been added to the medium in an attempt to remove copper and iron. The development of this process into a continuous one has been demonstrated on the AlfaLaval LAPX 202 Separator. Fractionation of crude palm oil using a density gradient provides seven fractions of different characteristics. The iodine values vary from 37.5 to 57.4 and the unsaturated fatty acids range from 32.7% to 51.2%. Triglyceride analysis by carbon numbers shows great differences in the C₄₈ and C₅₂ constituents of the fractions. aThe volume ratio of oil to medium in each case was 1:1. The separation involved the oil and wax.     

Rule-based interpretation of aerial imagery

In this paper, we describe the organization of a rule-based system, SPAM, that uses map and domain-specific knowledge to interpret airport scenes. This research investigates the use of a rule-based system for the control of image processing and interpretation of results with respect to a world model, as well as the representation of the world model within an image/map database. We present results on the interpretation of a high-resolution airport scene wvhere the image segmentation has been performed by a human, and by a region-based image segmentation program. The results of the system's analysis is characterized by the labeling of individual regions in the image and the collection of these regions into consistent interpretations of the major components of an airport model. These interpretations are ranked on the basis of their overall spatial and structural consistency. Some evaluations based on the results from three evolutionary versions of SPAM are presented.     

Fungal products. Part XVII. Microbiological hydroxylation of gibberellin A9 and its methyl ester

Angiotensin II (A II) and analogues were tested for their ability to restore electrical and mechanical activity to cardiac muscle preparations in which the fast Na+ channels had been inactivated by partial depolarization (22-27 mM K+) or by tetrodotoxin (TTX). The partially depolarized or TTX-blocked preparations were chosen because under these conditions electrical and mechanical responses are primarily Ca2+ -dependent. In depolarized rabbit right atria, A II restored spontaneous mechanical and electrical activity (measured by both intracellular and extracellular recording techniques). The frequency of action potential discharge was concentration-dependent; the threshold concentration of A II was 10(-10) M, the ED50 was 8 X 10(-9) M, and the maximum effect was observed at 5 X 10(-8) M. In contrast, depolarized guinea pig atria were insensitive to A II, Sar1-angiotensin II, and des-Asp1-angiotensin II, even at concentrations as high as 10(-5) M. Rabbit papillary muscle (TTX-blocked), embryonic (18-day) chick heart (partially depolarized) and chick heart reaggregates (TTX-blocked) responded similarly to rabbit atria in that A II (9.6 X 10(-7) M) restored both electrical and mechanical activity. We found that in these preparations the action of A II was unaffected by propranolol (5.0 X 10(-6) M to 5.0 X 10(-5) M) but was blocked by Mn2+ (10(-3) M), D-600 (1 X 10(-7) g/ml) and the specific A II antagonists Sar1-Ala8-angiotensin II (P-113) (5.0 X 10(-5) M) and Sar1-Ile8-angiotensin II (5.28 X 10(-5) M). We conclude that the positive inotropic effect of A II on the myocardium is due to its ability to increase transmembrane ion movements in or through the cell membrane. The ability of Mn2+ and D-600 to block this effect suggests that this ion movement is via the so-called "slow channels."     

Normalizing Behavior of Unsaturated Granular Pavement Materials

One of the important components of a flexible pavement structure is granular material layers. Unsaturated granular pavement materials (UGPMs) in these layers influence stresses and strains throughout the pavement structure, and have a large effect on asphalt concrete fatigue and pavement rutting (two of the primary failure mechanisms for flexible pavements). The behavior of UGPMs is dependent on water content, but this effect has been traditionally difficult to quantify using either empirical or mechanistic methods. This paper presents a practical mechanistic framework for determining the behavior of UGPMs within the range of water contents, densities, and stress states likely to be encountered under field conditions. Both soil suction and generated pore pressures are determined and compared to confinement under typical field loading conditions. The framework utilizes a simple soil suction model that has three density-independent parameters, and can be determined using conventional triaxial equipment that is available in many pavement engineering laboratories.     

Pulse-driven Josephson digital/analog converter [voltage standard]

The authors have designed and demonstrated a pulse-driven Josephson digital/analog converter. When used as a programmable voltage standard, this device can synthesize metrologically accurate ac waveforms as well as stable dc voltages. We show through simulations that Josephson quantization produces a nearly ideal quantization noise spectrum when a junction is driven with a typical waveform produced by a digital code generator. This technique has been demonstrated in preliminary experiments with arrays of 1000 junctions clocked at frequencies up to 6 Gb/s, where sine waves of a few millivolts in amplitude were synthesized at frequencies up to 1 MHz     

Characterization of 1.55-μm pulses from a self-seededgain-switched Fabry-Perot laser diode using frequency-resolved opticalgating

The intensity and frequency chirp of picosecond pulses from a self-seeded gain-switched Fabry-Perot laser diode have been directly measured using the technique of frequency-resolved optical gating. Measurements over an output sidemode suppression ratio (SMSR) range of 15-35 dB show that higher SMSR's are associated with an increasingly linear frequency chirp across the output pulses. This complete pulse characterization allows the conditions for optimum pulse compression to be determined accurately, and indicates that transform-limited, pedestal free pulses can be obtained at an SMSR of 35 dB     

Intangible assets as determinants of advanced manufacturingtechnology adoption in SME's: toward an evolutionary model

This paper investigates the relationship between intangible assets and further advanced manufacturing technology (AMT) adoption in 116 small manufacturing firms. Results indicate that the technical skills of blue-collar workers, the influence of customers and vendors, and strategic motivations focused on process improvement and customers are the strongest determinants of subsequent levels of adoption. Further, it is shown that strategic motivations moderate the relationships between technical skills and influences and further AMT adoption. Preliminary support for an evolutionary model is also found, leading to a revised conceptual framework     

Dietary patterns vs. dietary recommendations: Identifying the gaps for complex carbohydrate

Dietary guidelines of the U.S. and Canada recommend that 55% of dietary calories of individuals should come from carbohydrates, especially complex carbohydrates. However, they generally fail to describe how much should come from complex carbohydrates. Undoubtedly, this is because of confusion about the composition of complex carbohydrate foods and incomplete knowledge of the health benefits of all components of grain products. With the intent of shifting dietary food selection to increase carbohydrate consumption above the current 46% of calories, food guides recommend 5 to 12 servings per day from grain products. Current estimated intake for adults is between four to five servings of grain products, of which less than one is from whole grain, in an average 2000‐kcal adult diet. To follow the advice of the U.S. Food Guide Pyramid, which suggests half the bread (grains) group should be whole‐grain products, adult Americans should increase their intake of whole‐grain products four‐ to fivefold and double their intake of total grain products.