加油站油品用体积交接存在的问题及建议

叙述了目前加油站在实行按任意温度下的体积交接，由于未考虑油品体积随温度、压力、密度的变化，出现了零售损耗很大的问题。建议加油站在现阶段采用“准标准体积”交接；在由体积转换为质量计算加油站损溢时，使用油库当月发出的平均密度；当财会核销损溢时，不使用盘存的体积和固定密度进行计算的方法，而使用实际盘点的质量数，以真实反映加油站的当期损溢。     

猪场沼气工程改造技术研究

一、概况南平市种猪场位于延平区浆甲村 ,距市区 13km ,地处 316国道旁 ,面临沙溪口库湾边。年存栏猪760 0头 ,其中母猪 60 0头 ,后备种猪 2 5 0 0头 ,商品猪 4 5 0 0头 ,是闽北集种猪、商品猪生产及科研繁育于一体的副食品基地之一。该场日排猪粪便污水约140t,未建沼气工程前 ,直接排入水库 ,严重污染水体。1999年 ,种猪场采用厌氧发酵技术 ,处理猪粪便污水 ,兴建 4× 2 0 0m3沼气工程 ,技术落后 ,基本属于农村户用水压式沼气池的简单放大 ,猪粪便污水直接进入厌氧发酵池 ,出水直接排入水库。工程设计的主要问题是 :1 不设前处理装置 ,冲洗…     

Enhancement of islanding-detection of distributed generation systems via wavelet transform-based approaches

In this paper, a wavelet transform-based approach is proposed to detect the occurrence of islanding events in distributed generation systems. Thanks to time–frequency localization capabilities exhibited by wavelet transform, the approach embedded with this transform technique has grasped the appearance of the islanding event in a highly effective manner. Moreover, for those regions which are in need of a better visualization, the proposed approach would serve as an efficient aid such that the mains power disconnection can be better distinguished. To validate the feasibility of this approach, the method has been validated through several scenarios. Test results supported the effectiveness of the method for the application considered.     

Novel Hyperbranched predominantly Alternating Copolymers Made From A Charge Transfer Complex monomer pair of p-(chloromethyl)styrene and Acrylonitrile via Controlled Living Radical Copolymerization

Summary Novel hyperbranched copolymers were successfully synthesized by the controlled charge transfer complex inimer and living radical copolymerization of p-(chloromethyl)styrene (PCMS) and acrylonitrile (AN). The resulting copolymers were characterized by SEC, NMR, FTIR, DSC and elemental analysis etc.. The influences of reaction conditions, such as the polymerization temperature, the catalyst (CuBr) concentration and the monomer ratio, on the resulting copolymers were investigated in detail. The monomer reactivity ratios were evaluated to be r_PCMS=0.937 and r_AN=0.088 respectively by the Fineman-Ross method. The higher are the polymerization temperature and the ratio of catalyst to monomer, the higher is the branching degree of the resulting copolymer. When the amount of monomer AN was used in excess than that of the monomer PCMS in the raw feed, the hyperbranched predominantly alternating copolymers HP[PCMS-co-AN] could be obtained. These hyperbranched copolymers were successfully used as functional macroinitiators to synthesize the star-shaped poly(PCMS-co-AN)/poly(MMA) block copolymers.     

Plastic deformation and fracture of binary TiAl-base alloys

The mechanical behavior of binary TiAl alloys containing 46 to 60 at. pct Al has been studied in bulk materials preparedvia rapid solidification processing. Bending and tensile tests were carried out at room temperature as a function of Al concentration. A few alloys were also tested from liquid nitrogen temperature to ∼ 1000°C. Deformation substructures were studied by analytical transmission electron microscopy and fracture modes by scanning electron microscopy (SEM). It was found that both microstructure and composition strongly affect the mechanical behavior of TiAl-base alloys. A duplex structure, which contains both primary y grains and transformedγ/α ₂ lamellar grains, is more deformable than a single-phase or a fully transformed structure. The highest plasticities are observed in duplex alloys containing 48–50 at. pct Al after heat treatment in the center of theγ + α phase field. The deformation of these duplex alloys is facilitated by 1/2[110] slip and {111} twinning, but very limited superdislocation slip occurs. The twin deformation is suggested to result from a lowered stacking fault energy due to oxygen depletion or an intrinsic change in chemical bonding. Other factors, such as grain size and grain boundary chemistry and structure, are important from a fracture point of view. The results on the deformation and fracture modes as a function of test temperature are also discussed.     

Peripheral nerve injury as a complication from orthopedic operation

We report a case of pulmonary carcinosarcoma. Surgery is required for this rare mixed type, biphasic tumor. It is generally considered to be a malignant formation issuing from a single cell line but with a two-way differentiation into epithelial and conjunctive components. There is a differentiation continuum between spindle-cell carcinomas (also called monophasic sarcomatoid carcinoma) and carcinosarcoma (or biphasic sarcomatoid carcinoma) leading to debate concerning the immunohistochemical and ultrastructural features.     

The changes of lipid metabolism and hemorrheology in intrahepatic cholestasis during pregnancy

OBJECTIVE: To identify the influence of the increased level of serum cholyglycine (CG) on lipid metabolism and hemorrheology in patients with intrahepatic cholestasis during pregnancy (ICP). METHODS: The concentrations of serum CG, total cholesterol (CH), triglycerides (TG), high density lipoprotein-cholesterol (HDL-C), low density lipoprotein-cholesterol (LDL-C), high shear and low shear of blood specific viscosity (HS and LS), plasma specific viscosity (PV) and hematocrit (HCT) were measured in 68 cases of primiparas with single pregnancy and 30 healthy nonpregnant women respectively. The group of ICP was composed of 35 cases with CG > 6 mumol/L, the group of normal pregnancy, 33 cases with CG < 6 mumol/L. RESULTS: The means of CG and the lipidic parameters in the two pregnant groups were significantly higher than those in the non-pregnancy group (P < 0.02-0.001) except the means of HDL-C between the groups of ICP and non-pregnancy. The levels of LDL-C, LDL-C/HDL-C, LS, PV and HCT in the ICP were significantly higher than those in the normal pregnancy group (P < 0.02-0.001). CONCLUSIONS: There are significant changes of lipid metabolism and hemorrheology in patients with ICP. However, these changes could be corrected after pregnancy termination, when the level of serum CG returned to normal. The results suggest that the pathophysiologic changes of ICP are associated with increased level of serum CG.     

实炉底节能连续式加热炉

轧钢生产使用实炉底连续式加热炉加热钢坯，炉内双纵滑管用耐热耐高温材料，无水冷，起到节约水、电的作用，达到节能增效的目的。     

高频数字锁相环的研究

论文阐述了１００ＭＨｚ数字锁相环的设计过程，用１０ＭＨｚ晶体振荡器对１００ＭＨｚ数字压控振荡器进行锁相，使１００ＭＨｚ输出信号指标得到很大改善。论文还分析了各单元电路，关键点时域波形测试，频谱测试。     

机械合金化过程中Fe70B30粉末晶粒尺寸和微观应变的研究

用Ｘ射线和电镜研究了Ｆｅ＿（７０）Ｂ＿（３０）粉末经不同时间高能球磨后晶粒尺寸和微观应力的变化。在机械合金化过程中，粉末的Ｘ射线衍射谱的宽度随球磨时间的增加逐渐加宽，这是晶粒细化和内部微观应力共同作用的结果。Ｘ射线衍射结果表明：随着机械合金化的进行，粉末的晶粒尺寸逐渐减小，球磨初期晶粒尺寸下降较快，经１５ｈ球磨，晶粒尺寸为２５ｎｍ，机械合金化进行到一定时间后晶粒尺寸下降缓慢，８０ｈ球磨后晶粒尺寸可达５ｎｍ。在机械合金化过程中球磨所造成的微观应变不大，球磨初期粉末的内应力随球磨时间增加而增加，当粉末粒子尺寸很小时，随球磨的进行粉末中的微观应变显著下降。