Evaluation of Desulphurization Flux in CaO‐Al2O3‐BaO‐CeO2‐MgO System

The flux of the CaO‐Al₂0₃‐BaO‐CeO₂‐MgO system as a desulphurization flux containing no fluorine for the secondary metallurgy process was evaluated in this study. The flux composition was designed using the eutectic compositions of the binary systems. The melting and desulphurization abilities of the fluxes were evaluated by measuring their liquidus temperatures and the distribution ratios of sulphur between the fluxes and the carbon‐saturated iron or stainless steel. The lowest liquidus temperature of 1325°C was obtained by adding 5.7 mass% MgO to the 80mass%A‐20mass%B flux. (A: 12CaO‐7Al₂O₃, B: BaCeO₃+12mass%Al₂O₃). The distribution ratios of sulphur and sulphide capacities of the fluxes in this study were higher than those of the commercial product of calcium aluminate flux. This means that the CaO‐Al₂O₃‐BaO‐CeO₂‐MgO fluxes developed in this study have higher desulphurization and melting abilities compared with the commercial product of calcium aluminate flux.     

Temperature measurements of turbid aqueous solutions using near-infrared spectroscopy

We report a method that uses near-infrared spectroscopy and multivariate analysis to measure the temperature of turbid aqueous solutions. The measurement principle is based on the fact that the peak wavelength of the water absorption band, with its center near 1440 nm, shifts with changes in temperature. This principle was used to measure the temperatures of 1 mm thick samples of aqueous solutions containing Intralipid (2%), which are often used as optical phantoms for biological tissues due to similar scattering characteristics. Temperatures of pure water and aqueous solutions containing glucose (100 mg/ml and 200 mg/ml) were also measured for comparison. For the turbid Intralipid solutions, the absorbance spectrum varied irregularly with time due to the change in scattering characteristics. However, by making use of the difference between the absorbance at 1412 nm and the temperature-independent absorbance at 1440 nm, we obtained SEPs (standard error of prediction) of 0.3 degrees C and 0.2 degrees C by univariate linear regression and partial least squares regression, respectively. These accuracies were almost the same as those for the transparent samples (pure water and glucose solution).     

Sol–gel and rf sputtered AZO thin films: analysis of oxidation kinetics in harsh environment

Al-doped ZnO (AZO) thin film, which possess the advantages of low cost, low sheet resistance and high transmittance, are one of the most promising candidates to replace indium tin oxide films as the transparent electrode. However, oxidation causes a substantial increase in the sheet resistance of AZO film after exposing in ambient and especially, damp heat environment. In this work, we compare structural, optical, electrical properties and environmental stability between films prepared by two different methods: sol–gel and rf sputtering. Experimental results indicate that the properties of film can be affected by different deposition method. From the X-ray diffraction analysis, all films have hexagonal wurtzite crystal structure with different preferable orientation in two different methods. Optical transmittance spectra of the AZO films exhibited transparency higher than about 80 % within the visible wavelength region and the optical band gap (E_g) of these films was increased in sputtered film, probably due to the increase of carrier concentration. The better environmental stability was found in AZO film prepared by sputtering method. Improved surface morphology and enhancement of crystal orientation (110) was considered for this improvement.     

Noninvasive subsurface analysis using multiple miniaturized Raman probes, part I: basic study of thin-layered transparent models of biomedical tissues

This study describes a basic theory for reconstructing pure Raman signals of materials composing a multilayer sample from Raman spectra obtained using two types of miniaturized Raman probes. An illustrative example is demonstrated using a multilayer system of samples composed of the transparent plastics polymethylmethacrylate (PMMA) and polyethylene (PE) as a model of thin-layered biomedical tissues. When the same region of an object is measured using Raman probes with different focal properties, the Raman spectra provide different depth profile information depending on the level of light penetration. Thus, a detailed comparison of the spectra can provide an interesting opportunity to probe the differences between the layers. A simple analytic form is presented for reconstructing the pure Raman spectra of the embedded layer. The method applies an understanding of the Raman sampling volume in layered transparent materials to the interpretation of Raman spectra experimentally measured by multiple probes. The basic theory described here is necessary for the expansion of the technique to turbid media, such as biological samples, where light-scattering effects must be considered. The potential applications of the proposed method include material and catalyst subsurface probing through different embedded materials, such as assessment of silicon wafers, effective noninvasive screening for catalyst synthesis, and biomedical tissue research.     

煅烧炉用喷射耐火料的近期发展趋向

开发了一种干式喷射隔热材料,其热导率与隔热板一样低.它正取代普通的隔热板,因它的安装方便,工作环境较好.另外,我们已开发了新的湿式喷射料体系,它效率高,工作环境好.     

Eutectic Morphology of Al-7Si-0.3Mg Alloys with Scandium Additions

The mechanisms of Al-Si eutectic refinement due to scandium (Sc) additions have been studied in an Al-7Si-0.3Mg foundry alloy. The evolution of eutectic microstructure is studied by thermal analysis and interrupted solidification, and the distribution of Sc is studied by synchrotron micro-XRF mapping. Sc is shown to cause significant refinement of the eutectic silicon. The results show that Sc additions strongly suppress the nucleation of eutectic silicon due to the formation of ScP instead of AlP. Sc additions change the macroscopic eutectic growth mode to the propagation of a defined eutectic front from the mold walls opposite to the heat flux direction similar to past work with Na, Ca, and Y additions. It is found that Sc segregates to the eutectic aluminum and AlSi₂Sc₂ phases and not to eutectic silicon, suggesting that impurity-induced twinning does not operate. The results suggest that Sc refinement is mostly caused by the significantly reduced silicon nucleation frequency and the resulting increase in mean interface growth rate.     

In Situ Observation of Deformation in Semi-solid Fe-C Alloys at High Shear Rate

Synchrotron X-ray radiography at 125 frames per second was used to study deformation mechanisms in semi-solid Fe-C alloys at high solid fraction and shear strain rates of 10^?1/s. An image correlation approach was also used to quantify the shear strain fields and study shear-induced dilation and the origin of shear cracking. It was shown that, at high solid fraction (90 to 93 pct solid), rearrangement including rotation and translation of solid particles became restricted and shear strain localized into narrow liquid-filled channels/fissures. Shear cracking was shown to originate from inadequate liquid flow into the expanding spaces between solid particles caused by shear-induced dilation. At lower solid fraction (~85 pct solid), solid particles rearranged with a significantly higher component of rotation leading to more shear-induced dilation and a wider shear band.     

Complex-Valued Neural Networks: A Comprehensive Survey

Complex-valued neural networks(CVNNs) have shown their excellent efficiency compared to their real counterparts in speech enhancement, image and signal processing.Researchers throughout the years have made many efforts to improve the learning algorithms and activation functions of CVNNs. Since CVNNs have proven to have better performance in handling the naturally complex-valued data and signals, this area of study will grow and expect the arrival of some effective improvements in the future. The...     

Effect of active oxygen species on the productivity of torularhodin by Rhodotorula glutinis No. 21

The effect of active oxygen species on the productivity of torularhodin, an effective antioxidant, by soil yeast, Rhodotorula glutinis no. 21, was examined. Methylene blue, methyviologen and AAPH [2,2'-azobis(2-amidinopropane) dihydrochloride] were used as generators of singlet oxygen, superoxide anion radicals and peroxy radicals, respectively. All of them indicated effectiveness at a dose of 1.0 x 10(-10) to 3.0 x 10(-6) M. Addition of these generators to the culture medium had almost no influence on the biosynthesis of beta-carotene, whereas it had marked enhancement on those of torulene and torularhodin. Production of uric acid by xanthineoxidase remained unchanged at a torularhodin concentration of up to 100 microM. This result suggests that torularhodin does not directly affect the productivity of superoxide anions. It has been proved that torularhodin has a more potent effect on the scavenging of peroxyl radicals and inhibits substrate degradation by singlet oxygen more effectively than beta-carotene does. Continuous addition of methylene blue enhanced the torularhodin accumulation more markedly than single addition.     

Effect of cellular inositol content on ethanol tolerance of Saccharomyces cerevisiae in sake brewing

The effect of cellular inositol content on the ethanol tolerance of sake yeast was investigated. In a static culture of strain K901 in a synthetic medium, when cells were grown in the presence of inositol in limited amount (L-cells), the inositol content of cells decreased by one-third that of cells grown in the presence of inositol in sufficient amount (H-cells). L-cells exhibited a higher death rate constant than H-cells in the presence of 12-20% ethanol, while no difference in specific ethanol production rate in the presence of 0-18% ethanol between the two cell types was observed. L-cells leaked more intracellular components, such as nucleotides, phosphate and potassium, in the presence of ethanol than H-cells. L-cells exhibited a lower intracellular pH value than H-cells, which represented the lowering of cell vitality by the decrease in H(+) extrusion activity. Furthermore, the plasma membrane H(+)-ATPase activity of L-cells was approximately one-half of that of H-cells. Therefore, it was considered that the decrease in viability in the presence of ethanol due to inositol limitation results from the lowering of H(+)-ATPase activity, which maintains the permeability barrier of the yeast membrane, ensuring the homeostasis of ions in the cytoplasm of yeast cells. It is assumed that the lowering of H(+)-ATPase activity due to inositol limitation is caused by the change in lipid environment of the enzyme, which is affected by inositol-containing glycerophospholipids such as phosphatidylinositol (PI), because in the PI-saturated mixed micellar assay system, the difference in H(+)-ATPase activity between L- and H-cells disappeared. In the early stage of sake mash, inositol limitation lowers the ethanol tolerance due to the decrease in H(+)-ATPase activity as in static culture. In the final stage of sake mash, the disruption of the ino1 gene responsible for inositol synthesis, resulted in a decrease in cell density. Furthermore, the ino1 disruptant, which was not capable of increasing the cellular inositol level in the final stage, exhibited a significantly higher methylene blue-staining ratio than the parental strain. It was suggested that the yeast cellular inositol level is one of the important factors which contribute to the high ethanol tolerance implied by the increased cell viability in the presence of ethanol.