Natural convection heat transfer in the open space between two horizontal circular planes with different temperatures

A vertical cylinder maintained at room temperature is located right above a horizontal circular heated plane to constitute a narrow air space between the plane and the cylinder bottom surface. Natural convection heat transfer in the space is experimentally investigated. Average heat transfer coefficients of the heated plane are presented with the variation of space distance and Rayleigh number, and are compared with the predictions of the correlation equations which have been proposed for the space between two infinite parallel plates. Visualized flow patterns above the heated plane are also shown. The relation between the flow pattern and the heat transfer coefficient is discussed to clarify the mechanism of heat transfer in the narrow space. As a result, a heat transfer correlation is proposed, which is applicable over a wide range of space distances. © 2001 Scripta Technica, Heat Trans Asian Res, 30(6): 521–531, 2001     

Catalytic performance of a high-cell-density Ni honeycomb catalyst for methane steam reforming

The catalysis of methane steam reforming (MSR) by pure Ni honeycombs with high cell density of 2300 cells per square inch (cpsi) was investigated to develop efficient and inexpensive catalysts for hydrogen production. The Ni honeycomb catalyst was assembled using 30-μm-thick Ni foils, and showed much higher activity than that of a Ni honeycomb catalyst with cell density of 700 cpsi at a steam-to-carbon ratio of 1.36 and a gas hourly space velocity of 6400 h^?1 in a temperature range of 873–1173 K. Notably, the activity increased approximately proportional to the increasing geometric specific surface area of the honeycombs. The turnover rate of the Ni honeycomb catalyst was higher than that of supported Ni catalysts. The changes in chemical state of the Ni catalyst during hydrogen reduction and MSR reaction were analyzed by in situ X-ray absorption fine structure spectroscopy, which revealed that deactivation was mainly due to oxidation of the surface Ni atoms. These results demonstrated that the high-cell-density Ni honeycomb catalyst exhibits good performance for MSR reaction, and easy regeneration of the deactivated Ni honeycomb catalyst is possible only via hydrogen reduction.     

Functionalized imidazolium ionic liquids as electrolyte components of lithium batteries

Some basic properties and compatibility toward lithium electrode for electrolytes based on substituted imidazolium ionic liquid have been investigated. The ionic liquids having imidazolium cation substituted by methylcarboxyl or cyano group suffers from low conductivity. However, reversible lithium deposition–dissolution process was observed in electrolytes based on these electrolytes. In particular, lithium salt solution in cyanomethyl-substituted imidazolium ionic liquid provided similar cycle efficiency to conventional organic solvent electrolyte at constant-current condition. The mixed ionic liquid electrolyte containing the cyanomethyl-substituted ionic liquid also provided good cycle performance despite of containing large amount of 1-ethyl-3-methyl imidazolium (EMI)-based ionic liquid. Such mixed electrolyte system serves both the stability of lithium electrode process and valid conductivity for practical use.     

Neutron spectrum change with thermal moderator temperature in a compact electron accelerator-driven neutron source and its effects on spectroscopic neutron transmission imaging

Recently, Compact Accelerator-driven Neutron Sources (CANSs) are attracting attention. In CANSs, a simple thermal neutron moderator such as polyethylene is often used from the viewpoints of cost, simplicity and maintainability. In most cases, the temperature of such a moderator has not been controlled although it is natural that the moderator temperature and the neutron spectrum will change with accelerator-operation. Thus, we simultaneously measured neutron spectra and the temperature of a polyethylene moderator at the Hokkaido University Neutron Source (HUNS) driven by a compact electron accelerator to observe the effect of any temperature change on the reliability of spectroscopic transmission measurement. The ratio of the neutron effective temperature and the moderator temperature was constant in HUNS case, although both increased by 4–5 K within one hour after the start of accelerator-operation. This indicated that the neutron effective temperature was well estimated by the moderator temperature. The effect of the temperature change can be easily avoided by excluding data collection before the moderator warms up. These results suggested that the monitoring of moderator temperature is recommended in compact electron accelerator-driven neutron sources with a thermal neutron moderator to guarantee reliability of spectroscopic transmission measurement without sacrifices of cost, simplicity and maintainability.     

Enumeration of fungi in fruits by the most probable number method

In this study, enumeration methods for fungi in foods were evaluated using fruits that are often contaminated by fungi in the field and rot because of fungal contaminants. As the test methods, we used the standard most probable number (MPN) method with liquid medium in test tubes, which is traditionally used as the enumeration method for bacteria, and the plate-MPN method with agar plate media, in addition to the surface plating method as the traditional enumeration method for fungi. We tested 27 samples of 9 commercial domestic fruits using their surface skin. The results indicated that the standard MPN method showed slow recovery of fungi in test tubes and lower counts than the surface plating method and the plate-MPN method in almost all samples. The fungal count on the 4th d of incubation was approximately the same as on the 10th d by the surface plating method or the plate-MPN method, indicating no significant differences between the fungal counts by these 2 methods. This result indicated that the plate-MPN method had a number agreement with the traditional enumeration method. Moreover, the plate-MPN method has a little laborious without counting colonies, because fungal counts are estimated based on the number of plates with growing colonies. These advantages demonstrated that the plate-MPN method is a comparatively superior and rapid method for enumeration of fungi.     

Development of a quantitative real-time PCR method for estimation of the total number of Vibrio parahaemolyticus in contaminated shellfish and seawater

A real-time PCR method targeting the toxR gene of Vibrio parahaemolyticus was developed to quantify the number of V. parahaemolyticus cells, including those of both the hemolysin-producing and nonproducing strains. The specificity of the primer and probe set was confirmed using 25 strains of V. parahaemolyticus and 30 strains of other microbial species. We determined the threshold cycle number using the real-time PCR and the number of V. parahaemolyticus cells by plate count using serially diluted pure culture and developed a standard curve for quantification. Standard curves for V. parahaemolyticus in seawater and seafood were established using artificially inoculated samples. The threshold cycle number and the number of V. parahaemolyticus cells were correlated with 10(1) to 10(7) CFU/ml in pure culture, seawater, and shellfish homogenate. The real-time PCR method developed in this study was compared with the most-probable-number method in seafood samples that were naturally contaminated. The differences in the number of V. parahaemolyticus cells as determined by the culture method and the PCR method were less than 10-fold.     

Growth kinetics of Vibrio parahaemolyticus O3:K6 under varying conditions of pH, NaCl concentration and temperature

The growth responses of Vibrio parahamolyticus to pH, NaCl concentration and temperature changes were studied using serotype O3:K6 and other strains. Growth curves were obtained for 27 different sets of conditions, comprised of three levels of NaCl concentration, pH and temperature. The temperature, pH and NaCl concentrations most favorable for growth were in the order of 25 degrees C, 20 degrees C and 15 degrees C, pH 8, 7 and 5.8, and 1%, 3% and 7%, respectively. The bacteria grew most rapidly at 25 degrees C, at a pH of 7 or 8 in the presence of 1% or 3% NaCl, with the population (initial, ca. 2.5 log CFU/mL) reaching a level log 7 CFU/mL at 12 h. A growth predictive model using the Gompertz equation was generated from the experimental data for any combination of NaCl concentration, pH and temperature within the range used in this study.     

Increase of inductance ratio of flat type fault current limiter with high‐Tc superconducting disk

Fault current limiters (FCLs) are expected to reduce fault current and improve stability of power systems. A flat type fault current limiter consisting of the pancake primary winding and a high‐T_c superconducting (HTS) disk was proposed as a modified version of a conventional magnetic shield type of the FCL with the superconducting cylinder. The flat type FCL has the advantage of being manufactured smaller than the cylinder type FCL. It is pointed out, from a magnetic field analysis, that the volume of the flat type FCL is smaller than that of the cylinder type FCL with same magnitude of the limiting inductance. Further, the magnetic field analysis suggests that a high inductance ratio can be realized by radially enlarging both the primary winding and the HTS disk, stacking the FCL modules in layers and sandwiching the primary winding with superconducting disks. © 2006 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc.