A method to determine direct‐ and quadrature‐axis inductances of permanent magnet synchronous motors

The equivalent circuit constants of permanent magnet synchronous motors are needed in the calculation of operation characteristics, construction of a control system, etc. These constants can be computed from the data on structural form and materials. However, measurements are necessary to obtain highly precise values. Methods for measurement of the d‐ and q‐axis inductances can be roughly divided into rotational and standstill methods. The standstill methods have the advantage that they are easy to carry out. However, it is difficult to consider magnetic saturation and distortion of the change in the armature winding inductance. The accuracy of the standstill method can be improved if these effects can be readily taken into account. This paper describes a standstill method for measuring accurate d‐ and q‐axis synchronous inductances of permanent magnet synchronous motors. By utilizing the fact that the EMF interference terms in the motor voltage equation considering the distortion of the inductance change are equal to zero when the rotor is in a specific position, the proposed method determines the inductances considering both magnetic saturation and inductance distortion effects from simple off‐line standstill testing. In addition, this method is capable of taking cross‐magnetic saturation into account when used with the necessary testing equipment. The proposed method was implemented on a 0.4‐kW interior permanent magnet synchronous motor with concentrated stator winding. The validity of the proposed method was demonstrated by comparing the measured and calculated results of the no‐load and on‐load characteristics. © 2010 Wiley Periodicals, Inc. Electr Eng Jpn, 171(3): 41–50, 2010; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20969     

Synthesis and photophysical properties of structural isomers of novel 2,10-disubstituted benzofuro[2,3-e]naphthoxazole-type fluorescent dyes

Structural isomers of novel 2,10-disubstituted benzofuro[2,3-e]naphthoxazole fluorescent dyes have been synthesized. The phtophysical properties have been investigated in solution and in the solid state. The absorption and fluorescence intensities of the naphth[1,2-d]oxazoles are much stronger than those of the naphth[2,1-d]oxazoles in solution. Moreover, in the solid state, the emission intensities of the former are typically much stronger than those of latter isomers. To understand the differences in photophysical properties, semi-empirical molecular orbital calculations and the X-ray crystallographic analyses have been performed.     

Morphological changes of Candida albicans induced by micafungin (FK463), a water-soluble echinocandin-like lipopeptide

Micafungin (FK463), a novel water-soluble echinocandin-like lipopeptide, exerted fungicidal action toward growing cells of Candida albicans at concentrations of 0.1 microg ml(-1) or above. The drug at these levels induced osmotically fragile cells and the resulting fungicidal effect was partially reversed when cultures were grown in the presence of an osmotic stabilizer. Candida cells incubated with fungicidal concentrations of micafungin gradually increased in size and/or became deformed. An electron microscopic study of such micafungin-treated cells revealed morphological alterations in the cell wall; deformation in contour, abnormal septum formation and decrease in thickness of the intermediate layer of the cell wall were prominent. In addition, the structure of cell membranes as well as of membranous cytoplasmic organelles was slightly impaired. These data suggest that micafungin principally affects the normal formation of the cell wall in growing Candida cells.     

4He Impurity Effect on the Positive Ion Mobility in Liquid 3He

The behaviour of ⁴ He impurities has been investigated through positive ion mobility measurements in liquid ³ He at milliKelvin temperatures. In spite of the enormous surface area of the cell, the influence of ⁴ He lasted for hundreds of hours at temperatures of 20 mK. However below 10 mK, the ⁴ He impurities were quickly frozen out on the cell walls and we were free from the impurity problem. Nevertheless the multiple ion signal occasionally appeared even at a few mK, although it disappeared for a number of ionization pulses.     

Microdosimetric distribution of protons,Ep = 19-65 MeV,measured with a low pressure proportional counter

Microdosimetric measurements of 19, 32, 43, 55, and 65 MeV protons were carried out with the A-150-walled low pressure proportional counter (LPPC). The spectra are deconvoluted into three components, which are energy loss by directly incident protons, secondary electrons, and scattered protons and heavy charged particle (including protons) produced by proton nuclear reactions with the TE wall. Dose-mean lineal energies of protons are large as usual, because larger lineal energies by proton reaction events are affected.     

Proportional hazards models with random effects to examine centre effects in multicentre cancer clinical trials

In randomized clinical trials comparing treatment effects on diseases such as cancer, a multicentre trial is usually conducted to accrue the required number of patients within a reasonable period of time. The fundamental point of conducting a multicentre trial is that all participating investigators must agree to follow the common study protocol. However, even with every attempt having been made to standardize the methods for diagnosing severity of disease and evaluating response to treatment, for example, they might be applied differently at different centres, and these may vary from comprehensive cancer centres to university hospitals to community hospitals. Therefore, in multicentre trials there is likely to be some degree of variation (heterogeneity) among centres in both the baseline risks and the treatment effects. While we estimate the overall treatment effect using a summary measure such as hazard ratio and usually interpret it as an average treatment effect over the centre, it is necessary to examine the homogeneity of the observed treatment effects across centres, that is, treatment-by-centre interaction. If the data are reasonably consistent with homogeneity of the observed treatment effects across centres, a single summary measure is adequate to describe the trial results and those results will contribute to the scientific generalization, the process of synthesizing knowledge from observations. On the other hand, if heterogeneity of treatment effects is found, we should carefully interpret the trial results and investigate the reason why the variation is seen. In the analyses of multicentre trials, a random effects approach is often used to model the centre effects. In this article, we focus on the proportional hazards models with random effects to examine centre variation in the treatment effects as well as the baseline risks, and review the parameter estimation procedures, frequentist approach-penalized maximum likelihood method--and Bayesian approach--Gibbs sampling method. We also briefly review the models for bivariate responses. We present a few real data examples from the biometrical literature to highlight the issues.     

Amae in Japan and the United States: An exploration of a "culturally unique" emotion.

The experience of an emotion considered to be culturally unique (i.e., Japanese Amae) was tested in the United States, where there is no word to describe the concept. North American and Japanese participants read scenarios in which a friend made an inappropriate request (Amae), made no request, or made the request to another friend. Both American and Japanese participants felt more positive emotion and perceived the requester as feeling closer to them in the Amae condition than in the other two conditions. However, Americans felt more in control when asked for a favor than when not asked, a pattern that did not emerge among the Japanese. Cultural specificity of hypocognized emotions is discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

The application of the multiple transient technique for the experimental determination of the relative abundances and decay constants of delayed neutrons of the IPEN/MB-01 reactor

An in-pile experiment for the determination of the relative abundances and decay constants of delayed neutrons has been successfully performed at the IPEN/MB-01 research reactor facility. The experimental data are of good quality and can be used to validate theoretical predictions of the delayed neutron group constants based on the current knowledge of the fission products yields and emission probabilities for known precursors. The theory/experiment comparison shows that the current release of ENDF/B-VI, namely release 8, shows severe discrepancies in both relative abundances and in its first decay constant. The version revised at LANL shows very good progress in both aspects. JENDL3.3 shows the best performance in the C/E comparison. One of the main achievements of the experiment was the consistency of the measured first decay constant to that of ⁸⁷Br. Finally, it is also shown preliminary experimental results for an eight-group model.     

Selective and in-situ determination of carbonate and oxide particles in aqueous solution using laser-induced breakdown spectroscopy (LIBS) for wearable information equipment

Laser-induced breakdown spectroscopy (LIBS) has been applied for quantitative analysis of Al₂O₃, CaCO₃ and MgO particles suspended in water. In the single elemental system, the plasma emission intensities of Al, Ca and Mg were linearly increased with concentration of elements in the range of 1.0×10^?5–1.0×10^?3  M, 1.0×10^?4–2.0×10^?3 M and 8.0×10^?5 –4.0×10^?3 M, respectively. We also investigated the concentration dependence of breakdown spectra for suspended mixtures of Al₂O₃, CaCO₃ and MgO particles. The emission lines, such as Al I, Ca I, Ca II and Mg I, were appeared in the LIBS spectrum simultaneously, and each emission peak could be deconvoluted. The plasma emission intensities of Al, Ca and Mg in the multielemental system were also linearly increased with their concentrations in the range of 1.0×10^?5–1.0×10^?3 M, 1.0×10^?4–2.0×10^?3 M and 4.0×10^?4–2.0×10^?3 M, respectively. LIBS was found to be available for quantitative and qualitative measurement of the concentrations of Al₂O₃, CaCO₃ and MgO particles suspended in water. The present results suggest that LIBS is a potentially useful tool for in-situ analysis on particles composition and concentrations for environmental monitoring by the wearable information equipments.