Burner Performance Evaluation Using Test Code

Development of new burner technology is common practice nowadays. Standardized test codes are available to conduct tests to determine operating characteristics and thermal performance of different parts of steam generating units. This paper describes the results of testing performed to evaluate thermal efficiency of a 74.5?kW fire-tube steam generator fired with a new premixed flame burner in comparison to a typical standard-retrofit diffusion flame burner system. Two premixed flame burners sized at 7.6 and 10.1?cm were tested. Testing was performed in accordance with the ASME PTC 4.1 Power Test Code. The evaluation was conducted in the range of small- to mid-sized, natural gas-fired applications, from 1.06?to?2.64×106?kJ/h. The environmental nitrogen oxide (NOx) emissions performance was also compared for both burner technologies. The results of this evaluation indicate that firing the test boiler with the 7.6?cm new burner slightly improves unit thermal efficiency by 4.0–3.3% for a unit load ranging from approximately 1.06?to?1.79×106?kJ/h, respectively. Operation with the 10.1?cm new burner improves the thermal efficiency by approximately 1.6% at 2.32×106?kJ/h. The uncertainty in the measurements used in the efficiency calculations should account for approximately ±1.5% uncertainty in the reported gross efficiency. Reductions in NOx emissions of the order of 10% resulted from operation with the new premixed flame burners.     

Lithiasis of the prostatic loge

Lithiasis may develop in the prostate loge following prostate surgery. Calculus formation in the prostate can be ascribed basically to foreign bodies, residual adenomatous spheroids and clots or fragments of sphacelous mucosa in the presence of a stenotic area after surgery and/or infection. The diagnosis is based on the physical examination and particularly on the radiological findings. Treatment is by open surgery or endoscopic or extracorporeal lithotripsy.     

In-laboratory removal of femoral sheath following protamine administration in patients having intracoronary stent implantation

Two hundred twenty-eight patients with successful coronary stent implantation were randomized either to protamine administration and femoral sheath removal (group I, n = 117) or no heparin neutralization and delayed sheath removal (group II, n = 111). The hospital stay after treatment was shorter in patients receiving protamine; therefore, protamine use for neutralizing circulating heparin may be safely administered immediately after stent implantation.     

Kinetic model for water/oil absorption of mesquite gum (Prosopis juliflora) and gum arabic (Acacia senegal)

The water and oil uptake of mesquite and arabic gums in powdered form was studied at temperatures of 23, 35 and 45°C. A previously proposed equation to predict osmotic equilibrium was tested using the experimental data with both gums and a good statistical fit was obtained. Mesquite gum showed the highest water and oil absorption at all temperatures studied. Temperature dependence of the reciprocal of the S₁ and WL_∞ were determined using an Arrhenius equation. The activation energy for water and oil absorption for gum arabic was 21.98 and 39.57 kJ mol⁻¹, compared to that of mesquite gum having values of 15.79 and 46.16 kJ mol⁻¹, respectively. A second order kinetic model was obtained for water and oil absorption for both gums.     

Membrane-bound calmodulin in Xenopus laevis oocytes as a novel binding site for melatonin

Melatonin has been suggested as a physiological antagonist of calmodulin. In this work, we have characterized melatonin binding sites in Xenopus laevis oocyte membranes. Binding of [125I]melatonin by X. laevis oocyte membranes fulfills all criteria for binding to a receptor site. Binding was dependent on time, temperature, and membrane concentration and was stable, reversible, saturable, and specific. The binding site was also pharmacologically characterized. Stoichiometric studies showed a high-affinity binding site with a Kd of 1.18 nM. These data are in close agreement with data obtained from kinetic studies (Kd=0.12 nM). In competition studies, we observed a low-affinity binding site (Kd=63.41 microM). Moreover, the binding site was characterized as calmodulin. Thus, binding was dependent on calcium and blocked by anti-CaM antibodies in a concentration-dependent manner. Calmodulin inhibitor chlorpromazine also inhibited binding of the tracer. From these results, it is suggested that membrane-bound calmodulin acts as a melatonin binding site in Xenopus laevis oocytes, where it might couple cellular activities to rhythmic circulating levels of melatonin. This hypothesis correlates with the previous findings describing melatonin as a physiological antagonist of calmodulin.     

Detection of failure sites by focused ion beam and nano-probing in the interconnect of three-dimensional stacked circuit structures

Focused ion beam (FIB) and nano-probing were applied for failure analysis of three-dimensional stacked circuits with copper through-silicon-vias between the stacked chips. The failure analysis was done after high temperature storage and thermal cycling tests. Passive voltage contrast in FIB allowed to pinpoint the open sites. FIB cross-sections showed the presence of opens at the bottom of the copper vias. The failure cause was suspected to be an interlayer particle, which was confirmed by optical profilometry. Nano-probing was used on another sample to pinpoint the failure location through the measurement of the local resistance within the daisy chains. The failure was traced out to be related with surface contamination.     

Optical and electrical characterization of fluorine doped cadmium oxide thin films prepared by the sol-gel method

Highly transparent and conducting fluorine (F) doped cadmium oxide (CdO) thin films were deposited on glass slides by the sol-gel method. The films were doped by the addition of ammonium fluoride to the precursor solution whose optimum concentration was determined. The films were fired in an open atmosphere at 350 °C and after that, exposed to annealing treatments in different atmospheres (N₂, N₂/H₂ mixture and Ar) at the same temperature. The films were characterized by ultraviolet-visible spectroscopy, X‐ray diffraction and scanning electron microscopy. The resistivity was determined by the four probes method and current-voltage measurements in accordance with the standard Van der Pauw configuration. The CdO:F thin films obtained, showed high polycrystalline quality and high transmission in the visible region (≥ 90%), shifting towards the blue region of the absorption edge as the fluorine concentration in the precursor solution was increased from 0 to 30 at.%. The lowest resistivity values were reached for the samples with F content higher or equal to 5% and annealed in either N₂ or a 96/4 N₂/H₂ gas mixture. Our resistivity value reached in the CdO:F layers was 4.5 × 10^{− 4} Ω cm (20 Ω/square).     

Microstructural and textural characterization of a hot-rolled IF steel

The present paper reports the experimental results on the microstructural and textural characterization of a hot-rolled IF steel. The IF steel was hot-rolled in multiple passes in the austenitic field (1,070 °C) followed by air-cooling. SEM, TEM, and LOM were used to image the microstructure of the material. The global texture was determined by X-ray diffraction (XRD) technique. The mesotexture of selected regions was investigated by electron backscatter diffraction (EBSD). Results show the presence of a diffuse (nearly random) and weak texture in the hot-band that consists of recrystallized polygonal grains and subgrains. The fraction of boundaries with misorientations comprised in the interval 2° ≤ ψ < 15° was found to be lower than 5%. It can be concluded that these low angle boundaries and the presence of subgrains can be associated to the existence of a few areas softened by recovery during or after hot rolling in austenitic field.     

A comparative cerebral blood flow study in a baboon model with acetazolamide provocation: 99mTc-HMPAO vs 123I(IMP)

Pharmacological interactions are important when nuclear medical procedures are applied to patients under drug therapy, or drug provocation. This study compares in baboon models (regional) cerebral blood flow [(r)CBF] results from 99mTc-HMPAO and 123I-iodoamphetamine [123I(IMP)] each with and without acetazolamide, the latter a suggested drug for testing cerebrovascular reserve. Expected differences in cerebral uptake were observed between the two radio-tracers without acetazolamide. The increase in tracer uptake resulting from acetazolamide is significantly enhanced for 123I(IMP), which could have diagnostic implications.