Measurement of neutron emission from Ti and Pd in pressurized D2 gas and D2O electrolysis cells

Experiments using high-efficiency neutron detectors have detected neutron emission from various forms of Pd and Ti metal in pressurized D₂ gas cells and D₂O electrolysis cells. Four independent neutron detectors based on³He gas tubes were used. Both random neutrons (0.05–0.2 n/s) and time-correlated neutron bursts (10–280 n) of 100-s duration were measured using time-correlation counting techniques. The majority of the neutron burst events occurred at –30°C as the samples were warming up from the liquid nitrogen temperature.     

Designing DSS (decision support systems) and EIS (executive information systems) applications to fit executive user needs

The effectiveness of executive information systems and decision support rests on the level of understanding, commitment and use that top management devotes to the system. The author describes new technologies that help promote executive commitment to DSS/EIS.     

Color quantitation through image processing in dermatology

Classical color models and their applications to computer vision are reviewed. The performances of color quantitation from digitized images are compared with those derived from a chromameter. The color quantitation obtained from either digitized color slides or directly digitized images is proved to be more efficient than the conventional visual assessment of observers. A methodology is proposed for determining the specific color indices which are needed in dermatology. An application of this methodology is developed for designing a blanching quantitation index in order to replace the visual assessment during McKenzie tests.     

Effect of silver addition on superconductivity in the Bi1.6Pb0.4Sr1.6Ca2Cu3O10−y system

Silver/superconductor composites containing 0 to 80 vol% silver have been prepared and their properties determined. Optimum heat treatment at sintering temperatures ( 800° C) under low oxygen pressures produces material with high critical current density and improves physical properties. Magnetic susceptibility measurements have been found to be consistent with resistivity results. In order to retain a single high-T _c phase with increasing silver content, decreased oxygen partial pressures are required. Using the normal-state resistivity of these composites, a percolation threshold at a silver volume fraction of 43% was observed, while zero resistivity measurements show that a continuous superconducting network can be obtained with up to 80 vol% silver. The critical current density of 21 vol% silver-doped samples was found to be 1520 A cm^–2 at 77.3 K, compared to 260 A cm^–2 for an undoped sample.     

Training for an agricultural discrimination task

Skeleton weed, centaurea juncea, is a declared weed in Western Australia because it competes with grain crops for nutrients and moisture. When it is found during harvesting, mechanised teams search and eradicate it. In an earlier report of field trials (Hartley et al, 1989) it was reported that search teams' detection rate was poor and since search teams had usually never seen skeleton weeds, visual discrimination learning was to be expected and observed during searches. The present study investigated the nature of this discrimination learning in a laboratory by developing a training programme of colour photographic slides of weeds in stubble. Subjects receiving specific training with feedback on their performance compared with those receiving pseudo-training showed a significant improvement in detections. Subsequently the benefit of the programme was validated in a field trial.     

The piscine bioconcentration characteristics of cyclic and linear oligomeric permethylsiloxanes

Using a conventional "resaturation" method whereby aquarium water was continuously passed through a column containing sand or fine glass beads coated with cyclic and linear permethylsiloxanes, their uptake levels by rainbow trout and fathead minnows have been compared. Because of the uncertainty associated with defining the actual aqueous concentrations of such poorly soluble substances, this study was focused on defining the "attainable uptake" levels from saturated solutions rather than precise definition of actual bioconcentration factor values. Although cyclic Me2SiO-oligomers accumulated to a greater extent in fish than did comparable linear oligomers, uptake decreased sharply with increasing molecular weight. Thus, in the cyclic series (Dx), order of magnitude decreases were observed for each incremental molecular weight increase; i.e., for the compounds D4, D5, and D6 uptake levels of approximately 200, 20 and 2 ppm, respectively, were observed. Uptake of D8 was below our detection limit of 300 ppb. In the linear series, uptake of the tetramer MD2M was an order of magnitude less than observed for D4 and little or no uptake (i.e., less than 0.5 ppm) was observed for MD3M, MD4M and MD7M. The branched oligomer M3T exhibited levels comparable to its unbranched isomer MD2M, while M4Q was more comparable to the D6 uptake of 1-2 ppm. Very similar uptake levels of D5 resulted with and without a surfactant, even though the surfactant afforded a 20-fold increase in the D5 content of the water. This suggests that bio-availability is defined by the amount present in true solution as individual molecules and is not affected by the presence of aggregates or micelles. The highly inverse relationship observed in this study between uptake and molecular weight is strongly supportive of earlier estimates of a limiting molecular weight of about 600. These findings also strongly contradict a recent Japanese study, which concluded that bioconcentration not only occurred but actually increased with molecular weight in a series of commercial polydimethylsiloxane fluids. Also contrary to a recently published inference of biotransformation in fish, no evidence for such phenomena was observed in this study.     

A method for using a time interval counter to measure frequency stability

An interval timer is used in a single-mixer frequency-stability measurement system in place of an event timer. The dead-time problem is avoided with the aid of a reference pulse train and an algorithm for ambiguity resolution. The noise floor test and the unfolding algorithm are described. Advantages of the technique are high precision, convenient interfacing, and low cost. A disadvantage is the vulnerability of the technique to missing data.     

A theoretical and experimental study of low-loss SAW filters with interdigitated interdigital transducers

A study of low-loss surface-acoustic-wave (SAW) interdigitated interdigital transducer (IIDT) structures is presented. A model based on mixed scattering matrices was used in the analysis. It is shown that the inherent comb frequency response of the IIDT can be smoothed by slanting the transducers in the structure. Alternatively, the combs can be enhanced to produce a compact low-loss feedback element for potential application in multimode oscillators. Experimental verification of the analysis is provided by a 3:2 slanted-finger IIDT filter with a 10% relative bandwidth of 5.9-dB insertion loss, and a comb filter with 13.4-dB insertion loss and comb spacing of about 3 MHz. The measured responses agree quite well with the theory.     

Thermo-mechanical behaviour of wood and wood products

The dynamic mechanical behaviour of solid wood, fibreboard, and wood laminates has been examined in the temperature range –100 to +150° C. Two events are apparent in the response of the solid wood, a low-temperature (–50° C) transition which is interpreted as being associated with the onset of movement of bound water, and a higher temperature (40 to 120° C) thermal softening process. With fibreboard, the relationship between the shear storage modulus and density is shown to be described by a simple packing efficiency factor applicable over a wide range of temperature. The behaviour of the laminates is strongly dependent upon the orientation of the outer ply. A model is proposed which analyses the response of the laminate in terms of its constituent plies and allows calculation of numerical values of the component shear storage moduli. With both the fibreboard and the laminates the binder, urea-formaldehyde resin, is shown to have a significant influence on the absolute values of tan observed.     

A technique for assessment of torso kinesiology

A technique is described for monitoring and analysis of the angular displacement of the human torso. The technique is based on the use of miniature electromechanical inclinometers and video recording. The system was developed for continuous measurement of the angular displacement of spinal segments in the sagittal plane during all stages of lifting. Angular displacements of the cervical, thoracic and lumbar regions were obtained from a dynamic lifting case study using a digital processing system. The geometrical changes of the torso during five prescribed stages were measured. The system revealed good accuracy with high correlation coefficient scores for a wide range of lifting tasks in a comparative laboratory study. This paper describes the monitoring technique; the system's advantages, disadvantages and measuring accuracy are discussed.