Temperature Dependence of Ultra-Low-Frequency Dielectric Relaxation of Barium Titanate Ceramic

Based on a linear voltage ramp method, ultraslow dielectric relaxation of undoped BaTiO₃ ceramic has been carefully measured over the temperature range between − 180° and +120°C. Temperature dependence of the dielectric constant in the frequency range from 10 ⁻⁵ to 10⁻¹ Hz can be obtained using Kramers–Kronig equations. Close to the Curie temperature, the dielectric constant increases so rapidly that the Curie peak is overwhelmed. Two kinds of relaxation processes were observed in this experiment. Ferroelectric domain and mobile charge are proposed to be responsible for the relaxation over the temperature range. With temperature increasing, Maxwell–Wagner relaxation associated with mobile charge gradually dominates. From relaxation time constants at various temperatures, relaxation activation energies about 0.06 and 0.09 eV are identified.     

Magnetism in SiC implanted with high doses of Fe and Mn

High concentrations (0.1–5 at.%) of Mn or Fe were introduced into the near-surface region (≤2000 Å) of 6H-SiC substrates by direct implantation at ～300°C. After annealing at temperatures up to 1000°C, the structural properties were examined by transmission electron microscopy (TEM) and selected-area diffraction pattern (SADP) analysis. The magnetic properties were examined by SQUID magnetometry. While the Mn-implanted samples were paramagnetic over the entire dose range investigated, the Fe-implanted material displayed a ferromagnetic contribution present at <175 K for the highest dose conditions. No secondary phases were detected, at least not to the sensitivity of TEM or SADP.     

Extensive thrombophlebitis with reactive thrombocytosis in a high risk Chinese parturient associated with retained placenta increta: a case report

Forty-three patients with spastic quadriplegia (mean age 7.9 years, range 3.3 to 17.2 years) underwent bone mineral density (BMD) measurement of the lumbar spine and were evaluated between 2.6 and 5.5 years (mean 3.8) later to determine whether this measurement had predicted risk of fracture over the subsequent period of observation. Other potential risk factors that were evaluated include body weight z score, serum vitamin D levels, previous fracture, and hip spica casting. The baseline measurements showed that BMD falls further below normal with increasing age and was more than one standard deviation below age-matched normal mean in 38 of the 43 patients. Fracture rate did not differ between those with low and those with very low spinal BMD. Similarly, serum vitamin D levels and body weight z scores were not predictive of fracture. However, fracture rate was over fourfold greater following spica casting and more than threefold greater following an initial fracture. Fracture rates in the study group were similar to those reported for age- and sex-matched normal children, though generally the location of the fractures and mechanisms of injury differed.     

Hyperdynamic circulation of cirrhotic rats: role of substance P and its relationship to nitric oxide

BACKGROUND: It has been suggested that excessive formation of nitric oxide (NO) is responsible for the hyperdynamic circulation observed in portal hypertension. Substance P is a neuropeptide partly cleared by the liver and causes vasodilatation through the activation of the endothelial NO pathway. However, there are no previously published data concerning the plasma level of substance P in cirrhotic rats and its relationship to NO. METHODS: Plasma concentrations of substance P and nitrate/nitrite (an index of NO production) were determined in control rats and cirrhotic rats with or without ascites using an enzyme-linked immununosorbent assay and a colorimetric assay, respectively. In addition, systemic and portal hemodynamics were evaluated by a thermodilution technique and catheterization. RESULTS: Cirrhotic rats with and without ascites had a lower systemic vascular resistance (2.6 +/- 0.2 and 3.9 +/- 0.4 mmHg ml(-1) x min x 100 g body weight, respectively) and higher portal pressure (14.6 +/- 0.6 and 11.3 +/- 1.8 mmHg) than control rats (6.5 +/- 0.3 mmHg x ml(-1) x min x 100 g BW and 6.8 +/- 0.2 mmHg, respectively, P < 0.05), and cirrhotic rats with ascites had the lowest systemic vascular resistance. Plasma levels of nitrate/nitrite progressively increased in relation to the severity of liver dysfunction (control rats, 2.7 +/- 0.5 nmol/ml; cirrhotic rats without ascites, 5.6 +/- 1.3 nmol/ml; cirrhotic rats with ascites, 8.3 +/- 2.2 nmol/ml; P < 0.05). Cirrhotic rats with ascites displayed higher plasma values of substance P (57.7 +/- 5.9 pg/ml) than cirrhotic rats without ascites (37.9 +/- 3.1 pg/ml, P < 0.05) and control rats (30.1 +/- 1.0 pg/ml, P < 0.05). There was no significant difference in plasma substance P values between control rats and cirrhotic rats without ascites (P > 0.05). No correlation was found between plasma levels of substance P and nitrate/nitrite (r = 0.318, P > 0.05). CONCLUSIONS: Excessive formation of NO may be responsible, at least partly, for the hemodynamic derangements in cirrhosis. Although substance P may not participate in the initiation of a hyperdynamic circulation in cirrhosis, it may contribute to the maintenance of the hyperdynamic circulation observed in cirrhotic rats with ascites.     

Selective and nonselective wet etching of Zn0.9Mg0.1O/ZnO

Wet etch rates at 25°C for Zn_0.9Mg_0.1O grown on sapphire substrates by pulsed laser deposition (PLD) were in the range 300–1100 nm · min⁻¹ with HCl/H₂O (5×10⁻³−2×10⁻² M) and 120–300 nm · min⁻¹ with H₃PO₄/H₂O (5×10⁻³−2×10⁻² M). Both of these dilute mixtures exhibited diffusion-limited etching, with thermal activation energies of 2–3 kCal · mol⁻¹. By sharp contrast, the etch rates for ZnO also grown on sapphire by PLD were much slower in similar solutions, with rates of 1.2–50 nm · min⁻¹ in HCl/H₂O (0.01–1.2 M) and 12–54 nm · min⁻¹ in H₃PO₄/H₂O (0.02–0.15 M). The etching was reaction limited over the temperature range 25–75°C, with activation energies close to 6 kCal · mol⁻¹. The resulting selectivity of Zn_0.9Mg_0.1O over ZnO can be a high as ∼400 with HCl and ∼30 with H₃PO₄.     

Characterization and comparison of PECVD silicon nitride and silicon oxynitride dielectric for MIM capacitors

In this letter, we report on the electrical characteristic and the comparison of the metal-insulator-metal (MIM) capacitors with PECVD silicon nitride (SiN) and silicon oxynitride (SiON). Both capacitors are found to exhibit low leakage and high breakdown field strength, as well as absence of dispersive behavior, good linearity, and comparable quality factor behaviors.     

Fabrication and characteristics of high-speed implant-confined index-guided lateral-current 850-nm vertical cavity surface-emitting lasers

Process technology of high-speed implant-apertured index-guide lateral-current-injection top dielectric-mirror quantum-well 850-nm vertical cavity surface-emitting lasers (VCSELs) has been developed. Oxygen and helium implantation for aperture definition and extrinsic capacitance reduction, dielectric mirror formation, p- and n-ohmic contact formation, VCSEL resistance, and thermal analysis were investigated. Employing this technology, GaAs/AlGaAs-based 850-nm VCSELs with small signal modulation bandwidths up to 11.5 Gb/s and an eye diagram generated at 12 Gb/s by a pseudorandom bit sequence of 2/sup 31/-1 were achieved. The bit-error rates were below 10/sup -13/. The threshold current is as low as 0.8 mA for 7-/spl mu/m-diameter current apertures and typical slope efficiencies of 0.45-0.5 mA/mW were obtained.     

Estimating block selectivities for physical database design

Access path deployment is a critical issue in physical database design. Access paths typically include a clustered index as the primary access path and a set of secondary indexes as auxiliary access paths. To deploy the right access paths requires an effective algorithm and accurate estimation of the parameters used by the algorithm. One parameter central to any index-selection algorithm is the block selectivity of a query. Existing methods for estimating block selectivities are limited by restrictive assumptions. Furthermore, most existing methods produce estimates useful for aiding the selection of secondary indexes only. Little research has been done in the area of estimating block selectivities for supporting the selection of the clustered index. The paper presents a set of methods that do not depend on any specific assumption, produce accurate estimates, and can be used to aid in selecting the clustered index as well as secondary indexes     

Very high-order microring resonator filters for WDM applications

High-order microring resonators having from 1 to 11 coupled cavities are demonstrated. These filters exhibit low loss, flat tops, and out-of-band rejection ratios that can exceed 80 dB. They achieve performance that is suitable for commercial applications.