Instrumental characterization of clay by XRF,XRD and FTIR

Instrumental characterizations of the clay were performed by different techniques such as XRF, XRD and FTIR. XRF shows the chemical compositions of the clay where Al-oxide and silica oxide are present in major quantity whereas XRD confirms the presence of these minerals in clay. FTIR studies show the presence of quartz, alumina, haematite and different mineral matters.     

The influence of magnetron sputtered silver and titanium coatings on the compaction and properties of surface modified PM Ti-48Al powders

Thin layers of silver and titanium were deposited onto commercial Ti–₄₈Al particles by magnetron sputtering prior to their consolidation by hot isostatic pressing and subsequent heat treatment. Based on picnometry and electron probe microanalysis results, average values of 1.5 and 2.5 at.%, respectively, were obtained for the silver and titanium contents in the coated particles. The surface modified Ti–₄₈Al particles exhibited improved sintering ability than the unmodified ones. The consolidated samples have duplex microstructures formed by γ-TiAl and γ-TiAl + α₂-Ti₃Al grains. Ag-rich nanoprecipitates were detected in the microstructure of the compacted Ti-₄₈Al + Ag sample. The coatings are no longer visible at the grains boundaries after a subsequent homogenization heat treatment at 1200°C. The highest values of hardness and Young’s modulus were obtained for the Ti–₄₈Al + Ag sample, associated with a higher density and a lower percentage of pores.     

Further Establishment of the Field Perturbation Theory of the Pseudogaps in HTSC

Here I establish the field perturbation theory of pseudogaps in HTSC. The proposed ground state suggests an internal particle-hole field, which is normal to nesting surfaces, and having twice the Fermi wave number. It is proved that the system violates momentum conservation by the wave vector of this internal field. This violation applies to the quasi-particle propagators, as well as to the interactions. Interaction vertices via the Pauli matrix-τ₁ are established. This, in turn, establishes the validity of the pseudogap Hartree self-energy.     

曲流河沉积亚相的地震识别方法

本文提出利用三维地震资料相干数据分析研究曲流河沉积相的方法，其优点是在地质分析的基础上，对沉积体系有较为明显的识别特征，且在钻井较少的地区尤为实用。该方法在济阳拗陷东北部上第三系应用中取得了较为明显的效果。     

Kinetics and mechanism of carbothermic reduction of magnesia

The reaction between MgO and graphite powders under flowing argon atmosphere was studied using a dynamic thermogravimetric method. In the temperature range 293 to 1973 K, the effects of compacting pressure, magnesia/carbon ratio, heating rate, Ar carrier-gas flow rate, and CO-partial pressure were investigated. An experimentally determined reaction mechanism was proposed and discussed. The reduction process could be divided into two stages. The first stage includes the direct reaction between MgO and graphite particles and partial gas-solid reaction at relatively low temperature (below 1750 K). The overall reaction rate depends on the solid phase-boundary reaction between magnesia and carbon particles. The second stage is the gas-solid reaction between CO and MgO, which determines the overall reaction rate. The apparent activation energies of the two stages were estimated to be 208.29 and 374.13 kJ/mol, respectively.     

T梁预制中需要注意的问题

为确保在T梁预制时 ,其内、外的质量和安全施工 ,介绍了四个需特别注意的问题。指出在T梁预制时 ,应把质量放在首位 ,进行具体、综合的分析和计算     

The quantification of remote sensing

The paper firstly defined the remote sensing information quantification, analyzed the necessity of developing remote sensing quantification, figured out the application guidelines requirement, and pointed out the importance of quantification research. Then taking the remote sensing application research of CBERS-02 data quantification as the example, the paper described the whole quantification system of “remotely sensed digital signal-radiation information-field parameter inversion”. Finally the paper gave the prospect for the development trend of the quantitative remote sensing.     

西气东输工程用X70热轧板卷屈服强度检测值波动大的探讨

对西气东输工程用X70热轧板卷检验过程中出的屈服强度σ0.5波动大的情况进行了分析，认为拉伸试样弯曲是主要原因。这一问题可通过反复压平试样，确保试样的平直度以及适当提高钢的强度的方法加以解决。     

Performance evaluation of a biotrickling filter degrading mixtures of hydrophobic and hydrophilic compounds

The removal of a mixture of painting solvents from waste air using a biofiltration process was evaluated in this project. The pollutants removed included hydrophobic (aromatic hydrocarbons) and hydrophilic (water soluble ketones and esters) compounds. A trickle bed reactor with a defined immobilized mixed culture on polyethylene Pall rings was utilized in this biodegradation study. The removal efficiencies (RE) of the individual groups of pollutants during loading experiments were determined. An increase of the aromatic hydrocarbons loading resulted in a drop of their RE_AROM with no effect on the RE value of ketones. The overloading of ketones caused a rapid drop in RE_AROM and a small drop in RE_KET. To achieve a restoration of the biocatalyst degradation properties after the increase in loading, an addition of phosphate to the aqueous medium was implemented which successfully restored the removal efficiency.