Cleanability of Surfaces from Active Pharmaceutical Ingredient Surrogate Riboflavin by Falling Film

Falling films in wash down process are of major interest for pharmaceutical isolators, which are used for processing of highly potent pharmaceutical products. In this study multiple process parameters were examined with common materials of isolator systems. The importance of material and surface finish in respect of cleanability and complete wetting as well as a combination of process parameters are presented and discussed. For cleaning validation an effect of high interest was discovered: swab sampling areas changed their properties over many repeated cycles and showed decreased cleanability.     

Befugnisse der Aufsichtsbehörde gegenüber Rechtsanwälten

Der Beschluss des KG Berlin hat gro?e Beachtung in der Anwaltschaft gefunden. Die Entscheidung ist damit Gegenstand vieler zustimmender Bewertungen. Die folgenden Ausführungen sollen einerseits die Fehler der Entscheidung aufzeigen und andererseits einen Gegenpol zu diesen Auseinandersetzungen darstellen.     

Silicon‐Doped LiFePO4 Single Crystals: Growth,Conductivity Behavior,and Diffusivity

Single crystals of silicon doped LiFePO₄ with a silicon content of 1% are grown successfully by the floating zone technique and characterized by single‐crystal and powder X‐ray diffraction, secondary ion mass spectroscopy, and chemical analysis. Electron paramagnetic resonance demonstrates the presence of only Fe²⁺; no traces of Fe³⁺ are found. Impedance spectroscopy as well as step‐function polarization/depolarization (DC) measurements are carried out using the cells Ti/LiFe(Si)PO₄/Ti and LiAl/LiI/LiFe(Si)PO₄/LiI/LiAl. The electronic and ionic conductivities as well as the Li‐diffusivity of the sample in the major crystallographic directions ([h00], [0k0], and [00l]) are determined. Within experimental error the transport properties along the b‐ and c‐axes are found to be the same but differ significantly from the a‐axis, which exhibits lower values. Compared to undoped LiFePO₄, Si‐doping leads to an increase of the ionic conductivity while the electronic conductivity decreases, which is in agreement with a donor effect. The activation energies of conductivities and diffusivities are interpreted in terms of defect chemistry and relevant Brouwer diagrams are given.     

The effect of the particle size and the morphology of alumina powders on the processing of green bodies by electrophoretic deposition

The electrophoretic deposition (EPD) method was investigated for the preparation of compacts from nanosized alumina powders. Ethanol suspensions of commercially available nanosized transition alumina and α-alumina powders were used. In addition, submicron powders were also considered for comparison. Besides the influence of operational pH change, the influence of the addition of three different surfactants – two branched polyethylene imines with molecular masses 1800 and 10,000, and citric acid—on the zeta-potential of the particles in ethanol and afterwards on the EPD was investigated.The packing density of the green parts prepared by the EPD of nanosized α-alumina powders at 30 V/cm was low (the green density was 27 vol. % of the theoretical density—TD), and a bimodal pore size distribution was observed. In contrast, the packing density in deposits made with the transition alumina nanopowder was much higher (the green density was 42 vol. % of the TD) and a monomodal distribution of pores was observed. In general, for all the deposits made from nanosized alumina powders, the particle-packing density was found to be lower than for those made from the submicron alumina powders (a green density equal to 59 vol. % of the TD).