Athermal silica-based arrayed-waveguide grating multiplexer

A temperature dependent channel wavelength shift in a silica-based arrayed-waveguide grating multiplexer is successfully suppressed from 0.95 to 0.05 nm in the 0-85°C temperature range, which means that it can be used in practical WDM systems without the need for temperature control     

IRISTER - magneto-optical disk for magnetically inducedSuperResolution

IRISTER (IRIS Thermal Eclipse Reading) is a remarkable technique for achieving superresolution in optical disks. Two applications of IRISTER are Magnetically induced SuperResolution (MSR) and Premastered optical disk by SuperResolution (PSR). Magnetically induced SuperResolution (MSR) has been realized in magneto-optical disks using exchange-coupled magnetic multilayer films. Two new detection methods have been developed. In the front aperture detection (FAD) method, the heated area in the light spot works as an optical mask so that the signal is read out only from the remaining crescent-shaped area in the spot. In the rear aperture detection (RAD) method, the signal is read out only from the heated area. The cutoff spatial frequency for both types of detection is more than two times higher than that in conventional detection. A high C/N of 42 dB is obtained in the MSR disks by both methods for a mark length of 0.3 μm, which is much shorter than the optical limit. Premastered optical disk by SuperResolution (PSR) has been realized in read-only optical disks using phase-change materials. In the front aperture detection (FAD) method for PSR, the prerecorded signal is read out only from the high reflective crescent-shaped area in the light spot, because the reflectance of the heated area is too low. A C/N of 51 dB for a mark length of 0.3 μm has been obtained for the PSR disk     

Aprotinin reduces homologous blood transfusions when pediatric cardiac surgery must be redone

The hemostatic effect of aprotinin in pediatric cardiac surgery is controversial. This study demonstrated the usefulness of aprotinin in cases undergoing additional surgery. In a retrospective study, three groups of children were investigated. In group I (n = 10), no aprotinin or Cell saver was used (control). In group II (n = 12), Cell saver was used intraoperatively. In group III (n = 14), aprotinin 30,000 KIU/kg was added to the prime of cardiopulmonary bypass, and another 10,000 KIU/kg was given every hour during extracorporeal circulation. Both blood loss and use of homologous blood during operation were significantly (p < 0.01) reduced in group III compared to those in the other two groups. In group III, blood loss both 12 and 48 hours postoperatively were one-third less than those in group I (no significant difference). The use of homologous blood 48 hours postoperatively was significantly reduced in group III compared to that in group I (p < 0.01) or group II (p < 0.05). We conclude that aprotinin administration during cardiopulmonary bypass reduced blood loss and homologous blood requirements both operatively and postoperatively when pediatric cardiac surgery must be redone.     

Temporal dynamics and drivers of lake ecosystem metabolism using high resolution observations in a shallow,tropical, eutrophic lake (Laguna Lake,Philippines)

The physical, chemical, and biological dynamics under changing atmospheric conditions of Laguna Lake, Philippines were analyzed from intensive observations. Diel measurements were conducted for 48 continuous hours for both dry and wet tropical seasons in addition to fine resolution long-term monitoring. Results revealed significant vertical and diel variations of lake variables in spite of a shallow water depth (2.5 m) caused by the intense surface heating from solar irradiance (~800 W m^?2) and accentuated by the lake's high turbidity (16–32 ftu). Late afternoon land-lake breeze (~5–7 m s^?1) regularly breaks daytime thermal stratification, and convective cooling at night maintains isothermal condition until dawn of the next day. The stratified condition demonstrated a wind-driven, density-induced 2-layer current pattern with a windward moving epilimnion (~4 folds faster) and a compensating hypolimnetic flow in the general lake circulation direction. Laguna Lake was observed to have a dominating diel cycle but also undergoes significant seasonal limnological variations brought primarily by climate, hydrology, and its interaction with the adjacent sea. Significantly correlated variations of pH, chlorophyll-a and DO in the dry season were indicative of the higher biological activity associated with the intrusion of polluted waters from Metro Manila. The non-occurrence of thermal over-turn was observed to be regularly followed by bottom hypoxic conditions (2–4 mg L^?1), indicative of the eutrophic condition of the lake and the importance of diel wind-induced mixing in the bottom supply of DO. Laguna Lake was found to be predominantly net heterotrophic (GPP:R < 1, NEP < 0).     

Cognitive model of team cooperation in en-route air traffic control

Since controller teams are in charge of en-route air traffic control, team cooperation is a key issue for good control performance. We conducted ethnographic field observation at the Tokyo Area Control Center and then analyzed the obtained data to develop a cognitive model of team cooperation in en-route air traffic control. We segmented conversational records, behavioral records, and so on by control unit, and then clarified relations between the segments and identified expert knowledge and judgment behind them. Cognitive processes of controller teams were reconstructed based on a concept of distributed cognition. The analysis revealed that the mutual belief model is applicable to team cooperation processes, the role assignment of tasks within a controller team is implicit and that control plans are implemented smoothly once team situation awareness has been established. A cognitive model of controllers?? team cooperation has been constructed based on these findings.     

Properties of Va metal-B films prepared by r.f.-sputtering

Ta_100-x B _x alloy films were prepared by r.f.-sputtering in the chemical composition range 45 x 77. Ta_100-x B _x (45 x 58) films consist of the amorphous phase, while the TaB₂ crystal phase was observed in Ta_100-x B _x (66 x 77) films. A remarkable preferred orientation with the (001) plane of TaB₂ parallel to the film surface was observed in Ta₃₄B₆₆. The d.c. electrical conductivity of Ta_100-x B _x (45 x 77) films decreases with increasing boron content in the range 6.7 × 10³ to 1.3 × 10^3–1 cm^–1. The micro-Vickers hardness of Ta_100-x B _x (45 x 77) films was in the range 2200 to 2600 kg mm^–2.     

Residual Stress in Siliceous Glass Between Mullite Crystals

A birefringence of siliceous glass, which is coexisting with mullite crystals, was studied by an optical polarizing microscope. The cause of the birefringence was assumed to be the residual stress induced by a large contraction difference between the mullite and glass on cooling. The stress has been evaluated to be as high as—0.3 GPa, and to correspond to the elastic one which began to develop at the glass transition point.     

Adhesive properties of cured epoxide resin containing the intermolecular compound of 2,4-diamino-6-vinyl-s-triazine and isocyanuric acid

The intermolecular compound of 2,4-diamino-6-vinyl-s-triazine and isocyanuric acid was synthesized, and the glass transition temperature and the adhesive properties of the cured epoxide resin containing the above compound were studied. Epoxide reacted with amino groups of 2,4-diamino-6-vinyl-s-triazine and isocyanuric acid at the curing conditions of 150 to 180°C for 60 min and formed the cured compounds. The infrared spectra showed that epoxide reacted with isocyanuric acid in the presence of imidazole compounds and converted to 2-oxazolidinone compound on the curing process. The glass transition temperatures of the cured compounds having isocyanurate and 2-oxazolidinone rings in their structures were higher than that of the epoxide resin cured with imidazole and rise as the curing temperature rises, but fall as 2-oxazolidinone ring content increases in their cured compounds. The tensile shear and peel strengths of the steel and steel bonded with the cured compounds and the cured epoxide resin were measured at 25 and 150°C. The adhesive strengths were improved due to isocyanurate and 2-oxazolidinone rings formed in their cured compounds.     

Fat splitting by the twitchell process at low temperature

Summary A study was made of the degree of splitting of coconut and soybean oils by the Twitchell process at 35±0.1°C. with no shaking or stirring, using an agent consisting mainly of tetrabutyl naphthalene sulfonic acid with water or dilute sulfuric acid. The degree of splitting was greater with sulfuric acid than with water. In general, the degree of splitting of soybean oil was greater when the sulfonic acid was dissolved in the oil layer than when it was in water. The reverse was true with coconut oil. Although addition of glycerol had no effect on the degree of splitting, addition of glacial acetic acid to the coconut oil system decreased fat splitting to a considerable extent. Addition of coconut fatty acids to the coconut oil system had little effect, but soybean fatty acids added to the soybean oil system markedly increased the degree of splitting. For the first time it has been demonstrated that, at 35±0.1°C., splitting of a fat by the Twitchell process occurs in a stepwise way. Coconut oil in contact with 1N sulfuric acid containing the sulfonic acid, corresponding to 1% by the weight of the oil, was about 90% split in 15 to 30 days, depending on the area of contact of the two layers. The diglyceride concentration reached a maximum during the early days of the reaction and then decreased somewhat. Monoglyceride concentration appeared to reach a maximum more slowly and then continued at that level as the concentrations of free fatty acids and glycerol steadily increased. Presented at the symposia on fat of the Chemical Society of Japan, Nov. 10, 1954, and Nov. 8, 1955, Nagoya, Japan; and the 8th annual meeting of the Chemical Society of Japan, Apr. 2, 1955, Tokyo, Japan.     

A Practical Model for the Interactions Between Hydrating Portland Cements and Poly-β-Naphthalene Sulfonate Condensate Superplasticizers

The performance of poly-β-naphthalene sulfonate condensate superplasticizer (BNS) as a dispersant for cement in concrete is affected severely by slight differences in the characteristics of the cement. In order to be able to predict these effects, a model for estimating the fluidity of cement paste containing BNS is proposed. This model is based on an assumption that the fluidity of cement paste is proportional to the BNS adsorption amount per surface area of hydrated cement (Ad/Hy). BNS is known to show two types of sorption on hydrated cement: one is the bulk absorption into initial hydrates and the other one is the superficial adsorption onto hydrates. Only the superficially adsorbed BNS is expected to work as a dispersant. By assuming a competitive Langmuir-type adsorption on hydrates between BNS and SO₄²⁻, a simple method to estimate Ad/Hy is developed, with the concentrations of BNS and SO₄²⁻ as the only two independent parameters. The resulting estimates of Ad/Hy show a good correlation with paste flow and its change with elapsed time for a broad range of cements. The SO₄²⁻ concentration in the aqueous phase of the cement paste just after the beginning of the mixing is known to affect the performance of BNS as a dispersant. By using the proposed model to discriminate between the superficial adsorption and bulk absorption of BNS, this phenomenon is explained quantitatively.