应用底饲回燃循环流化床技术改造东锅DG35/3.82-7型流化床锅炉

采用飞灰循环底饲回燃技术改造西南合成制药总厂热电分厂、天府矿务局磨心坡发电厂2台东方DG35/3.82-7型低倍率循环流化床锅炉。改造后运行结果表明,锅炉可长期、稳定运行,尾部飞灰可燃物含量大幅度降低,锅炉蒸发量提高20％左右,节煤效果明显。为燃用贫煤、无烟煤和煤矸石等劣质燃料且锅炉炉膛高度较低的电站技改,提供了一种切实可行的方法。     

密码子优化的牛精蛋白基因在大肠杆菌中的表达

以PCR的方法得到牛精蛋白基因的基因，去其内含子，得到牛精蛋白cDNA，克隆入原核表达载体pGEX-2T中，组装成表达载体pGEX-2T-PE，利用大肠杆菌偏好的编码精氨酸的密码子CGT将野生型牛精蛋白基因中编码精氨酸的稀有密码子（AGA或AGG）替换掉，通过基因合成得到密码子优化的牛精蛋白的基因，将其克隆入原核表达载体pGEX-2T中，组装成表达载体pGEX-2T-PS。将这两个表达载体分别转化入大肠杆菌表达菌株BL21中，经IPTG诱导，同样条件下，野生型牛精蛋白基因无法得到表达，密码子优化的牛精蛋白基因能够得到良好的表达，表达产物约占细菌总蛋白的18％，将表达蛋白纯化，进行DNA－蛋白结合实验，发现其能与DNA发生非特异性的结合。     

我国钢铁工业发展中存在的问题及对策研究

针对全球经济一体化进程加快，以及中国加入WTO，我国钢铁工业应如何发展，剖析了我国钢铁工业存在的主要问题，分析了制约我国钢铁工业发展的重要影响因素，并在此基础上从宏观、微观的角度提出了我国钢铁工业发展的对策。     

新生牛肝活性肽的制备及其毒性检测

目的制备新生牛肝活性肽并评价其安全性。方法采用膜法分离制备新生牛肝活性肽。将3批制品于37～40℃,75%相对湿度条件下存放3个月,以多肽含量为指标观察其稳定性,并进行急性毒性试验、小鼠骨髓细胞微核试验、Ames试验、小鼠精子畸形试验和大鼠喂养试验。结果制备的3批新生牛肝活性肽存放3个月后,多肽含量无明显下降,质量稳定。小鼠和大鼠经口灌人大于20.0g/kg体重的新生牛肝活性肽,均无急性毒性。3种致突变试验均未显示出致突变性,大鼠喂养试验各项指标均未见明显毒性。结论新生牛肝活性肽未表现出明显毒性。     

非晶Sm5Fe74.3Nb1.5Si11.7B4.5C2.5Cu0.5合金经预退火后的晶化动力学的DTA研究

研究了非晶Sm5Fe74.3Nb1.5Si11.7B4.5C2.5Cu0.5合金经400℃，保温10min预退火后的晶化动力学。结果表明；该合金的晶化相为α-Fe固溶体和Sm2Fe17Cx金属间化合物，两相的晶化表观激活能分别为557KJ/mol和514KJ/mol，当晶化体积分数为60%时，α-Fe相的晶化激活能达极大值；Sm2Fe17Cx相晶化激活能则随其晶化体积分数的增加而逐渐减小。     

An FDTD/ray-tracing analysis method for wave penetration through inhomogeneous walls

A novel method of studying wave penetration through inhomogeneous walls using the hybrid technique based on combining finite-difference time-domain (FDTD) and ray tracing methods is presented . The FDTD method is used to analyze the transmission characteristics of inhomogeneous walls. Using the knowledge of the tangential electric and magnetic field distributions along the borders of the FDTD computation domain, rays are sent out to cover the rest of the environment so that prediction of signal coverage can be made more efficiently without compromising the accuracy. Numerical results of the method have been compared and shown to agree very well with those of measurement and those of full wave analysis. Examples have shown the inadequacy of the traditional ray tracing method in the presence of walls made of concrete blocks. However, the proposed method can accurately predict signal coverage by taking into account the scattered fields by the inhomogeneity inside the walls. The method does not add much to computational complexity. Reduction in computation time is even more significant when the incident waves can be approximated to be plane waves and the wall structure is periodic.     

Ti-23Al-14Nb-3V合金氩弧焊接头的显微组织及其力学性能

研究了预热对Ｔｉ－２３Ａｌ－１４Ｎｂ－３Ｖ合金焊接性，特别是对消除氩弧焊冷裂纹的作用以及对接头显微组织和力学性能的影响。结果表明，焊前预热可有效降低该合金的冷裂倾向。经预热处理后，焊缝区的结晶层状线消失，热影响区的硬度峰得到缓和，整个焊缝的显微硬度分布趋于均匀，但焊缝区的枝晶发生粗化，热影响区有所扩大。焊件接头的拉伸试验表明，预热可使焊缝区的接头强度系数增加，但无论预热与否，接头强度均低于母材强度，且不显示宏观塑性。     

全面实施工程量清单计价之我见

随着国家《建设工程工程量清单计价规范》及各省计价依据的颁布,工程量清单计价工作已在全国开始实行,但实施的深度和广度不够。作者从管理角度,就如何全面实施工程量清单,对造价管理部门和招投标管理机构相关工作的完善阐述了几点建议和意见。     

Effect of Additives on Magnetic Properties of High Frequency MnZn Power Ferrite

In keeping with the advance of more compact and more power-saving electronic equipment, the demand is increasing for smaller and more efficient switching power supply. Therefore, it is necessary to provide the adequate magnetic power ferrite materials to satisfy the demand. Such ferrite materials have to meet the following main requirement: 1) high initial permeability (μ i ); 2) high saturation magnetic induction (Bs); 3) high Curie temperature (Tc); 4) high electrical resistivity (ρ ); 5)…