深圳市福田水闸改造设计

文章介绍了深圳市福田水闸改造中自动化设计情况,通过闸门结构、启闭机的选型、电气设备控制,将其由防洪意义的“挡潮闸”转变为截污意义的“挡潮闸”,从而实现了工程管理的现代化。     

特低渗透油气藏成岩储集相的定量评价方法

针对陕北斜坡东部特低渗透储层受沉积作用和成岩作用两大因素控制的特点，利用灰色系统理论对成岩储集相进行了研究。分析了成岩作用综合效应及其相应的视压实率、视肢结率、视微孔率、成岩综合系数等定量指标和岩心分析数据，建立了成岩储集相综合评价参数、指标和分析方法。通过在安塞油田低孔隙度特低渗透长6。油藏储层的实际应用，对目的层段开展了Ⅰ，Ⅱ，Ⅲ和Ⅳ类成岩储集相的定量评价和油气富集描述，有机地集成和综合了多种信息，实现了成岩储集相对沉积学、岩石学和成岩作用等特征的综合表征，并划分出有利成岩储集相区域，为指导油田有利含油区块的筛选和开发决策提供了重要依据。     

A Golden Section approach to optimization of automotive friction materials

A Golden Section approach combined with relational grade analysis is proposed as an experimental design tool helpful in the development of new automotive friction materials. Golden Section was used to design the volume fraction of the components systematically. The changes in friction performance (friction coefficient and wear) measured using Friction Assessment and Screening Test (FAST) can be correlated with component variations by use of relational grade analysis. This approach was utilized to optimize a non-metallic friction material containing seven ingredients including two fibers (aramid and slag fiber), four fillers (Al₂O₃, BaSO₄, graphite and nitrile rubber) and one binder (benzoxazine). The volume fraction of seven components was varied simultaneously in order to optimize the parameters of friction coefficient and wear with a minimum number of tests. Three phases were performed to find the optimal proportion of the components. The optimized friction performance was obtained after doing 19 formulation experiments.     

A 4.5-GHz 130-nm 32-KB L0 cache with a leakage-tolerant self reverse-bias bitline scheme

This paper describes a 32-KB two-read, one-write ported L0 cache for 4.5-GHz operation in 1.2-V 130-nm dual-V/sub TH/ CMOS technology. The local bitline uses a leakage-tolerant self reverse-bias (SRB) scheme with nMOS source-follower pullup access transistors, while preserving robust full-swing operation. Gate-source underdrive of -220 mV on the bitline read-select transistors is established without external bias voltages or gate-oxide overstress. Device-level measurements in the 130-nm technology show 72/spl times/ bitline active leakage reduction, enabling low-V/sub TH/ usage, 40% bitline keeper downsizing, and 16 bitcells/bitline. 11% faster read delay and 2/spl times/ higher dc noise robustness are achieved compared with high-performance dual-V/sub TH/ bitline scheme. Sustained performance and robustness benefits of the SRB technique against conventional dynamic bitline with scaling to 100- and 70-nm technology is also presented.     

TD-SCDMA技术及市场分析

TD-SCDMA技术优势 2000年5月,在土耳其伊斯坦布尔召开的国际电联大会上,TD-SCDMA被国际电联接纳为第三代移动通信系统标准之一,这标志着中国在移动通信技术领域已经进入世界先进行列.     

电控平行排列液晶光栅的光衍射特性研究

对电控平行液晶光栅的理论进行了分析,并配以结构原理图。通过对平行排列及90°扭曲排列液晶指向矢的计算,得出液晶盒中相应的折射率、相位差与电压之间的关系图,两者经比较证明平行排列更具适用性,并在实验中观测到了平行排列液晶光栅衍射特性与电压的关系。     

无线网状网技术与应用

无线网状网(WMNs)由网状路由器节点和客户机节点组成,其中的网状路由器节点组成了无线网状网的网络骨干,其移动性很小。他们一起为无线网状网和其他常规无线网络的客户机节点提供网络的无线接入。WMNs技术结合了中心式控制的蜂窝网与分布式控制的无线自组织网的优点,可有效克服这两种技术的缺陷并显著提高无线网络的性能,已经成为下一代无线通信网络的研究热点之一。WMNs可为无线个域网、局域网、校园网、城域网的一系列应用提供高速无线宽带接入服务。虽然目前WMNs技术发展很快,但其协议栈各层仍存在许多有待研究的课题。首先简要介绍了无线网状网的结构与特点;随后重点分析了其主要的几个应用领域;最后探讨了WMNs各协议层的研究现状与关键技术,并分析了该技术存在的问题及未来的研究方向。     

Hydrogenated amorphous silicon thin-film transistor arrays fabricated by digital lithography

A jet-printed digital-lithographic method, in place of conventional photolithography, was used to fabricate 64 /spl times/ 64 pixel (300 /spl mu/m pitch) matrix addressing thin-film transistor (TFT) arrays. The average hydrogenated amorphous silicon TFT device within an array had a threshold voltage of /spl sim/3.5 V, carrier mobility of 0.7 cm/sup 2//V/spl middot/s, subthreshold slope of 0.76 V/decade, and an on/off ratio of 10/sup 8/.     

小功率行波管可靠性数字仿真的研究

基于对实际器件的测试数据,采用模糊数学和最可能故障法建立整个器件的可靠性模型.引入可靠性分布密度函数,将实际测试得到的离散数据拟合成随时间变化的连续函数,不仅可得到小功率行波管测试性能的评估,而且还可以对其可靠性进行预测;进一步研究,还可以给出预测的准确度概率.本文主要讨论小功率行波管可靠度评估模型的建立、数据处理与精度分析等,并对预测与准确度的概率给予简要的介绍.