Pt/C活性催化剂催化氢化合成6-氯-2-羟基喹喔啉

以对氯邻硝基乙酰乙酰苯胺为原料，在碱性条件下经环合及催化氢化合成6-氯-2-羟基喹喔啉。采用自制的Pt／C催化剂，考察了反应条件对产品收率的影响，在85℃，1．0～1．3MPa氢气压力下进行加氢还原反应，总收率89．6％(以对氯邻硝基乙酰乙酰苯胺转化为6-氯-2-羟基喹喔啉)。     

聚己二酸1,2-环己二醇酯的合成

采用正交实验方法,分别以钛酸四丁酯和对甲苯磺酸为催化剂,合成了聚己二酸1,2 环己二醇酯,对其合成工艺条件进行了研究,得出了最佳工艺条件。并以所得聚酯合成了具有透明度高、硬度大、耐磨、玻璃化温度高等优异性能的聚氨酯材料。     

脂肪醇聚氧乙烯醚的厌氧与好氧生物降解性

以脂肪醇聚氧乙烯醚(AEO)为目标污染物，在等同条件下做厌氧消化污泥和好氧活性污泥对其生物降解性能的对比实验，得出了同一系列AEO分子中聚氧乙烯基与整个分子的降解难易程度的关系。表明：①污泥会对AEO分子产生吸附一脱附作用而出现假降解率，克服假降解率的干扰是准确测定AEO生物降解性的关键因素；②厌氧和好氧条件下，AEO均可降解，但厌氧降解要稍优于好氧降解；③AEO中聚氧乙烯基的单元数(n)是影响其生物降解的重要因素，相同碳链的直链烷基，生物降解率随n的增加而明显降低。     

施工项目管理与贯标工作相融合的探索与实践

由于建筑工程施工的单件性、复杂性，在工程项目实施过程中贯标工作与工程项目管理工作通常不太融合，有时甚至形成“两层皮”现象。因此，针对这一现象，在承建410t／h锅炉工程中，借贯彻2000版ISO9001标准的有力时机，进行了工程项目管理与贯标工作融合性的探索与实践，取得了较好的效果。     

竹材丙酮法木质素高效分离技术研究

在一定的温度、压力条件下,利用丙酮提取竹材中的木质素,丙酮通过蒸馏回收后,可以反复利用;而通过蒸馏,得到的高纯度的木质素是重要的化工原料,整个过程形成一个封闭循环系统,基本上无三废排放;研究结果表明:当丙酮浓度为80%,液固比为10∶1,在最高反应温度160℃下保温3h,降解木质素的效果最佳;为解决制浆造纸行业废水对环境的污染问题提出了一条新的途径。     

普钙产品转化率的数值计算方法

对影响普钙产品转化率的各种因素进行了分析,利用MATLAB 软件包得到了转化率的计算公式,提出了确定未分解磷矿的比例和由倍半氧化物引起的有效磷退化幅度的方法,为生产系统的预测和调整提供了一种途径。     

HT-730改性酚醛-丁腈胶粘剂的研制

对酚醛-丁腈胶粘剂进行改性，添加5．0％的硅烷偶联剂，改善了酚醛-丁腈胶粘剂的工艺性能，提高了粘接强度，特别是降低了酚醛-丁腈胶对环境湿度的敏感性。研制的HT-730胶在环境湿度90％时仍有很高的粘接强度，同时老化性能和适用期并没有受到影响。     

A novel shaft-less double suction mini pump

A novel double suction shaft-less mini pump was developed for heat control of small energy systems in this study.The mini pump impeller with an exit diameter of 40 mm was combined with the motor rotor supported by the hybrid dynamic bearing.The specific speed of the pump was 125 min-1 m3 min-1 m.The hydraulic performance of the pump was investigated experimen-tally under four rotational speeds.From the test results,it was recognized that the pump could provide a flow discharge of 5 L/min and head of 1.5 m,w...     

Nanobubble generation and its applications in froth flotation (part Ⅲ): specially designed laboratory scale column flotation of phosphate

Froth flotation is used widely for upgrading raw phosphate. The flotation recovery of coarse phosphate (-1.18+0.425 mm) is much lower than that achieved on the -0.425+0.15 mm size fraction. Enhanced recovery of coarse phosphate particles is of great economic and environmental importance for phosphate industry. In this investigation, four different phosphate samples were aquired, characterized and tested in a specially designed laboratory-scale flotation column. Significant recovery improvement of coarse phosphate flotation was achieved using cavitation-generated nanobubble though its effects differ among the four testing phosphate samples. The laboratory-scale flotation column test results indicate that nanobubble increased P2O5 recovery by up to 10%-30% for a given Acid Insoluble (A.I.) rejection, depending on the characteristic of phosphate samples. The improvement ef-fect of nanobubble on the hard-to-float particles was more significant than that on easy-to-float particles, especially at lower col-lector dosages. Nanobubbles reduced the collector dosage by 1/3 to 1/2. Nanobubbles almost doubled the coarse phosphate flotation rate constant and increased the flotation selectivity index by up to 25%.     

Relation between structural evolution of the Longmenshan orogenic zone and sedimentation of its foreland basin

In order to determine the area for oil and gas exploration in China's north Sichuan basin, we have divided the time during which the Longmenshan foreland basin was formed into five periods, based on the sedimentary response relationship of the fore-land basin to structural evolution: 1) a late Triassic Noric period; 2) an early-Middle Jurassic period; 3) a late Jurassic to early Cre-taceous period; 4) a late Cretaceous to Paleogene-Neogene period and 5) the Quaternary period. As well, we analyzed the sedimen-tary environment and lithologic features of every basin-forming period. The results show that there are several favorable source-reservoir-cap assemblages in our study area, making it a major region for future oil and gas exploration in China's northern Sichuan basin.