Cure of malignant ascites and generation of protective immunity by monoclonal antibody-targeted activation of a glucuronide prodrug in rats

We examined the in vivo efficacy of targeting beta-glucuronidase (betaG) to activate a glucuronide prodrug (BHAMG) of p-hydroxyaniline mustard (pHAM) at hepatoma ascites in Sprague-Dawley rats. Injection i.p. of 500 microg RH1-betaG, a conjugate formed between recombinant betaG and monoclonal antibody RH1 with specificity for an antigen expressed on AS-30D rat hepatoma cells, into rats bearing AS-30D ascites resulted in the accumulation of 54 microg conjugate per 10(9) tumor cells after 2 hr. Ascites fluid and serum contained 0.53 and 0 microg/ml, respectively, RH1-betaG 2 hr after injection of the conjugate. Conjugate binding to AS-30D cells was heterogeneous and non-saturated, as determined by flow cytometry. BHAMG was less toxic than pHAM to SD rats based on measures of animal mortality, weight loss and hematological toxicity. Treatment of rats bearing established hepatoma ascites with 500 microg RH1-betaG followed 2 hr later with a single i.p. injection of 30 mg/kg BHAMG or 3 i.p. injections of 10 mg/kg BHAMG 2, 3 and 4 hr later resulted in the cure of 6/8 and 8/8 animals, respectively. Treatment with BHAMG or pHAM alone did not produce cures, whereas treatment with a control antibody-betaG conjugate and BHAMG produced significantly greater hematological toxicity compared to treatment with RH1-betaG and BHAMG. All cured rats were completely protected from rechallenge with 2 x 10(7) AS-30D cells, indicating that successful treatment of animals induced protective immunity.     

Analysis of volatiles evolved during high-temperature treatment of thermally stable polymers. I. Nitrogen-containing acetylene-terminated resin

Cured samples of a nitrogen-containing acetylene-terminated resin, N,N′-(1,3-phenylene-dimethylidene)bis(3-ethynylaniline), have been heated at 10°C/min up to 900°C in a pyroprobe attached to a gas chromatograph/mass spectrometer (GC/MS). Analysis of the volatiles evolved during heating identified both gases and higher boiling compounds. The major higher boiling compounds are benzene, toluene, xylene, aniline, benzonitrile, m-methylaniline, and m-methylbenzonitrile; the gases include ammonia, methane, and traces of carbon dioxide. Correlations between sample temperature and the evolution of each of these compounds have been made. The onset of all volatile formation occurs between 450 and 500°C. The higher boiling volatiles peak, then end by approximately 700°C, while the gases peak then fall off but are still being evolved at 900°C. Average weight loss measurements of 13.6% at 700°C and 15.7% at 900°C agree with previously published thermogravimetric analysis (TGA) data. © 1993 John Wiley & Sons, Inc.     

Presupposition failure — A comedy of errors

Presuppositions of utterances are the pieces of information you convey with an utterance no matter whether your utterance is true or not. We first study presupposition in a very simple framework of updating propositional information, with examples of how presuppositions of complex propositional updates can be calculated. Next we move on to presuppositions and quantification, in the context of a dynamic version of predicate logic, suitably modified to allow for presupposition failure. In both the propositional and the quantificational case, presupposition failure can be viewed as error abortion of procedures. Thus, a dynamic assertion logic which describes the preconditions for error abortion is the suitable tool for analysing presupposition.     

Epidermal growth factor induces terminal differentiation in human epidermoid carcinoma cells

In this study, spermatogenesis in the adult Djungarian hamster is described. Undifferentiated spermatogonia topographically arranged as Asingle (A(s)), Apaired (Apr), and Aaligned (Aal) spermatogonia were observed, as were six generations of differentiating spermatogonia (A1, A2, A3, intermediate, B1, and B2). The differentiating spermatogonia divided at regular intervals during the cycle of the seminiferous epithelium. Mitosis of these cells was observed at the transition from stage IX to stage X (mitosis of A1 into A2 spermatogonia), at the transition from stage XII to stage I, at the transition from stage II to stage III, at the transition from stage IV to stage V, at the end of stage VI, and at approximately the middle of stage VII. Cellular associations in the cycle of the seminiferous epithelium are described. The seminiferous epithelium was divided into 12 stages, based upon the developmental steps in spermiogenesis, and the frequency of these stages was determined. The duration of the cycle of the seminiferous epithelium, determined by [3H]thymidine incorporation, was shown to be 7.90 +/- 0.01 (mean +/- SEM) days.     

Should industrial/organizational psychologists be licensed?

A historical review of licensing among industrial/organizational (I/O) psychologists demonstrates that the American Psychological Association (APA) policy on such licensing is inconsistent. Arguments for and against licensure for this group are presented. Job analysis and APA data are drawn upon to show that few I/O activities may pose the personal risk that would seem to require the protection of a license. Alternatives are discussed for changes in present APA policy and state licensing requirements. (16 ref) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

A novel cyclic process using CaSO<Subscript>4</Subscript>/CaS pellets for converting sulfur dioxide to elemental sulfur without generating secondary pollutants: Part I. Feasibility and kinetics of the reduction of sulfur dioxide with calcium-sulfide pellets

Certain new sulfide-smelting processes and coal-gasification processes generate high-strength sulfur dioxide streams, for which a new process for converting sulfur dioxide to elemental sulfur needs to be developed because no process exists that is generally and economically applicable to the treatment of such streams. A thermodynamic and experimental investigation to develop a new process for converting sulfur dioxide to elemental sulfur by a cyclic process involving calcium sulfide and calcium sulfate without generating secondary pollutants was carried out. In this process, the starting raw material, calcium sulfate, is reduced by a suitable reducing agent, such as hydrogen, to produce calcium sulfide, which is used to reduce sulfur dioxide to elemental sulfur vapor and calcium sulfate. The latter is, in turn, reduced to regenerate calcium sulfide. In this Part I, detailed experimental results are presented on the kinetics of the reaction between sulfur dioxide and calcium-sulfide pellets, which produces elemental sulfur and calcium sulfate. The experiments were carried out at temperatures between 1023 and 1088 K and sulfur-dioxide partial pressures between 9 and 60 kPa by the use of a thermogravimetric analysis (TGA) technique. The rate of this reaction was demonstrated by the conversion of 40 pct calcium-sulfide pellets obtained from the hydrogen reduction of fresh calcium sulfate in 10 minutes at 1073 K under a sulfur-dioxide partial pressure of 43 kPa. The reactivity decreased somewhat during the first three cycles but remained largely unchanged thereafter up to the tenth cycle. This characteristic of the pellets is important because the solids must be reusable for repeated cycles to avoid generating secondary pollutants. A pore-blocking model was found to fit the reaction rate. The reaction is first order with respect to sulfur-dioxide partial pressure and has an activation energy of 101 to 134 kJ/mol (24 to 32 kcal/mol) for calcium-sulfide pellets reacted and regenerated several different times. Sulfur dioxide-containing streams from certain sources, such as the regenerator off-gas from an integrated-gasification, combined-cycle, desulfurization unit and new sulfide-smelting plants, contain much higher partial pressures of SO₂. In these cases, the rate of the first reaction is expected to be proportionally higher than in the test conditions reported in this article. The reduction kinetics of calcium-sulfate pellets with hydrogen gas is reported in the accompanying Part II.     

Microbiological denitrification of red beet juice

The purpose of study was the determination of optimal conditions for red beet juice denitrification by Paracoccus denitrificans bacteria as well as the evaluation of the usefulness of microbiologically treated juice for the production of a natural colouring preparation for foods. Total reduction of nitrates was found during bacterial culturing at 25 and 30 °C, at an initial pH of 7.0-8.0 and juice osmotic pressure of 900-1100 mOsm/kg. Microbiological denitrification procedure affected colour, taste and aroma of the juice. However, the use of juice as food colouring and component was made feasible by acidification and partial evaporation of water together with volatile substances.