Analysis of the effect of car size on accident injury probability using automobile insurance data

The Highway Loss Data Institute (HLDI) compiles injury and collision claim information from major insurance companies. These data have indicated that a disproportionately large number of injury claims are made for small cars. As a result, it might be concluded that small cars increase injury risk to their occupants. Recent advertisements by a major automobile manufacturer suggest a similar conclusion should be drawn from these data. In this paper it is shown that the apparent higher injury risk attributed to small cars can reflect the behavior of persons driving small cars. The number of injury claim accidents per collision claim accident is examined as an alternative measure of injury risk. Possible problems in interpretation are discussed.     

Short contact time dissolution of vitrinite and inertinite concentrates

The short contact time dissolution of vitrinite and inertinite concentrates of an Australian bituminous coal was studied under isothermal conditions with tetralin as solvent. The reactivity of the two maceral types and the yields and nature of the products were determined for a range of reaction temperatures (400, 420 and 440 °C) and reaction times (2–20 min). The dissolution of vitrinite proceeded at a significantly greater rate than for inertinite and was associated with greater selectivity to soluble non-gaseous products. At very short reaction times (2 min), the vitrinite underwent solubilizing reactions to yield products of higher molecular weight and greater oxygen functionality than was the case for inertinite, for which changes in the chemical nature of the products were negligible over the range of conditions studied. At longer reaction times (5 min), the composition of the vitrinite-derived products was similar to that of the inertinite-derived products.     

Coal liquefaction using a hydrogenated creosote oil solvent: H-atom transfer from hydrogen donor components in the solvent

The presence of hydroaromatic, hydrogen donor components in a coal-derived solvent is one of the more important factors in the successful operation of a non-catalytic coal liquefaction process. Various hydrogen donor species present in a hydrogenated creosote oil have been identified. Their rate of disappearance under conditions that are consistent with a short residence time coal liquefaction process has been used to rank the reactivities of the various hydrogen donors. 1,2,3,10b-Tetrahydrofluoranthene was found to be an exceptional donor while 4,5-dihydropyrene, the hexahydropyrenes and 9,10-dihydrophenanthrene were found to be quite active. Sym.-octahydrophenanthrene and 2a,3,4,5-tetrahydroacenaphthene exhibited moderate activity. Tetralin and the four methyltetralin isomers were found to be unreactive under the coal liquefaction conditions employed.     

Analysis of polar compound classes in SRC-II liquids: Comparison of non-aqueous titrametric,i.r. spectrometric and h.p.l.c. methods

Results for various types of polar compounds in SRC-11 coal-derived liquids and other fuels were obtained by one or more of the three analytical methods: non-aqueous titration, i.r. spectroscopy and h.p.l.c. Practical aspects as well as precision, accuracy and assumptions necessary for effective application of each of the methods are discussed. H.p.l.c. is applicable to the widest variety of compound types, is the most rapid, most sensitive and shows the best promise for increased development and improvement. Application and development of these techniques is a logical step toward improving process monitoring, catalyst development, toxicological screening and general fuel analysis.     

The Effect of Moisture Content in Epoxy Film Adhesives on their Performance. II. T-Peel and 105°C Lap Shear Strength

The benefits of adhesively bonded structures are well known. However, the most significant factor limiting the extensive application of metal bonding in primary aerospace structures is the prevailing lack of confidence in its long term durability under hostile environmental conditions.^1,2     

The growth of ambient aerosols in the conditions of the respiratory system

The effect on ambient aerosols of exposure to the conditions of the respiratory system was determined by sampling simultaneously through two dichotomous samplers in parallel. In one of the samplers the aerosol was brought to 37°C and near 100% relative humidity before passing through the virtual impactor. The results show that, as a result of humidification, about 10–15% by mass of the aerosol which would normally been collected in the fine (less than 2.5 μm aerodynamic diameter) fraction of the sample grows sufficiently when humidified to be collected with the coarse fraction. It is suggested that the direct application to inhalation studies of dichotomous sampler results should be approached with some caution.     

NMR Line Shape-Spin-Lattice Relaxation Correlation Study of Portland Cement Hydration

The proton free induction decay of a portland cement paste in an advanced stage of hydration can be roughly divided into three main components: (1) a component with a very short spin-spin relaxation time, T², representing the protons of the solid OH groups and the water of crystallization, (2) a component with an intermediate T, representing the bonded water in the gel phase, and (3) a third component with a relatively long T² representing the water in the micropores and layers. The dependences of the intensities, T²'s, and spin-lattice relaxation times (T¹'s) of these three components on the cement hardening time have been determined. The proton spin-lattice relaxation time of the "solid" component increases with hardening time whereas T¹ decreases for the other two components. The observed time dependence of the diffusion coefficient, D, of water in a tricalcium silicate paste supports the findings of the above correlation study.     

Critical Review of the Thermophysical Properties of Fast-Reactor Fuel

This paper identifies the fuel properties for which more data are needed for fast-reactor safety analysis. In addition, a brief review is given of current research on the vapor pressure over liquid UO₂ and (U, Pu)O_2-x the solid-solid phase transition in actinide oxides, and the thermal conductivity of molten urania.     

Formation and Properties of Calcium Aluminosilicate Glasses

The glass-forming region for calcium aluminosilicate glasses has been determined. A number of properties of these glasses (thermal expansion coefficient, glass transformation and dilatometric softening temperature, and refractive index) have been studied. The results of these measurements suggeq that the structures of these glasses may not as closely resemble those of alkali aluminosilicate glasses as is commonly assumed. Evidence is presented which suggests that the binary calcium aluminate glasses may be phase separated.