Stochastic stabilization of differential systems with general decay rate

Some sufficient conditions concerning stability of solutions of stochastic differential evolution equations with general decay rate are first proved. Then, these results are interpreted as suitable stabilization ones for deterministic and stochastic systems. Also, they permit us to construct appropriate linear stabilizers in some particular situations.     

Dynamics of coupled and uncoupled two-phase flows in a slab mold

Two-phase flows in a mold of a slab caster are studied using water modeling, particle-image velocimetry (PIV), and computational fluid-dynamics techniques. Two-way coupled flows are observed in liquidgas systems, because both phases influence each other’s momentum transfer. In addition to this concept, PIV measurements indicate the existence of structurally coupled flows, where the velocity vectors of both phases observe similar orientations. When the drag forces of the liquid, exerted on the bubbles, exceed a certain value of the inertial forces of the liquid phase, at high mass loads of gas (ratio of mass flow rates of the gas phase and the liquid phase), the flow becomes structurally coupled. These types of flows promote large oscillations of the meniscus level. Two jets, liquid and bubble, were identified; the latter always reported larger angles than the first, independent of the gas load. Thus, a gas-rich jet is located closer to the lower edge of the submerged entry nozzle (SEN) port, and the liquid-rich jet is found above this position. The liquid-jet angle approaches that of the SEN port when the flow becomes structurally coupled. Structurally uncoupled flows report gas jets that follow torrent-type patterns which are well explained using a multiphase fluid-dynamics model. Structurally coupled flows yield gas jets with a continuous pattern.     

新型多苯并咪唑环芳识别氨基酸甲酯的分子动力学和密度泛函研究

采用Gaussian 03在B3LYP/6-31G(d)水平上分别优化新型多苯并咪唑环芳(MBICP)受体和氨基酸甲酯(AAME)配体,再用基于模拟退火的分子动力学方法 CDOCKER将配体与受体对接,对每一个复合物获得了一组最低能量的初始构象。最后用Turbomole在BLYP/def-TZVP水平对初始构象进一步优化,并对收敛后的复合物最低能量构象作NBO分析。以密度泛函理论计算获得的相互作用能作为核心参数,采用组合策略建立了表达MBICP-AAME复合物结合常数的定量关系模型,计算了该类复合物的结合常数。对MBICP受体和AAME配体间的作用模式以及影响MBICP受体识别AAME配体的主要因素,作了深入讨论。     

Dietetic study of pregnant women of Santa Maria Cauqué, Guatemala. I. Variability of protein indicators and analysis by the time of meals

The distribution of the protein energy ratio indicators (Pe%), amino acid score and protein value (NDpCal%) in the three daily meals (breakfast, lunch and dinner) of the diet of pregnant women from Santa María Cauqué, Guatemala, was studied. The results were compared with those obtained for the total daily food intake. The differences observed were not significant, confirming the validity of the determination of amino acid score, Pe% and NDpCal% in the foods consumed during the whole day in this type of populations. It also reflects the nutritional benefit of the food pattern, since protein utilization would not be decreased by a different distribution of protein quality and concentration throughout the three daily meals. The variability among individuals of Pe% intake, amino acid score and NDpCal% gave the following values: 16.0, 9.3 and 15.6, respectively. It is noteworthy to add that the variability of Pe% observed is similar to that reported for populations of developed countries.     

Increased socioeconomic differences in mortality in eight Spanish provinces

In Spain, the study of socioeconomic differences in mortality has been limited by the fact that death certificates often do not include complete information on occupation. In this study, we chose those geographic areas with the highest quality information on occupation of the deceased in order to study socioeconomic differences in mortality from various causes of death. We used information from the death certificates of males who died between 30 and 64 years of age in eight Spanish provinces to compare mortality from the leading causes of death in professionals and managers (group I) and in manual laborers (group II) in 1980-82 and 1988-90. In each period the standardized mortality ratios (SMRs) were higher in group II, except for ischaemic heart disease during the first period, and cancer of the colon and rectum in both, although in the latter case the differences were not statistically significant. The ratio between the SMR from all causes in group II and group I was 1.27 in 1980-82, and 1.72 in 1988-90; for cancer of the colon and rectum the ratio went from 0.98 to 0.84, and for ischaemic heart disease, from 0.80 to 1.31. Except for cancer of the colon and rectum, which resulted in higher mortality in occupational group I, the excess mortality in occupational group II increased between the first and second period. The relation between socioeconomic level and mortality for ischaemic heart disease was reversed, a phenomenon similar to that which took place in the 1960s and 1970s in the developed countries.(ABSTRACT TRUNCATED AT 250 WORDS)     

Elastic behaviour of polyvinyl chloride melts

A study has been made of the elastic behaviour of Polyvinylchloride commercial samples at high shear stresses, under similar conditions to those used in the processing industry, by means of an extrusion capillary rheometer.The influence in the die swell of variables as molecular weight, temperature and shear rate has been studied. Results are in agreement with general literature data.Smooth extrudates are obtained only in the zone of intermediate shear rates. In this zone it is observed that the die swell increases with shear rate.     

Optical, electrical and structural characteristics of Al:ZnO thin films with various thicknesses deposited by DC sputtering at room temperature and annealed in air or vacuum

Transparent and conductive Al-doped ZnO (AZO) films have been grown with various thicknesses between 0.3 and 1.1 μm by magnetron sputtering at room temperature onto soda lime glass substrates. After deposition, the samples have been annealed at temperatures ranging from 150 to 450 °C in air or vacuum. The optical, electrical, and structural characteristics of the AZO coatings have been analyzed as a function of the film thickness and the annealing parameters by spectrophotometry, Hall effect measurements, and X-ray diffraction. As-grown layers are found polycrystalline, with hexagonal structure that shows some elongation of the unit cells along the c-axis, having visible transmittance ∼85-90% and resistivity ∼1.6-2.0 mΩ cm, both parameters slightly decreasing when the film thickness increases. Heating in air or vacuum produces further elongation of the crystalline lattice together with some increase of the visible transmittance and a decrease of the electrical resistance that depends on the heating temperature and atmosphere. The best characteristics have been obtained after treatment in vacuum at 350 °C, where the highest carrier concentrations are achieved, giving visible transmittance ∼90-95% and resistivity ∼0.8-0.9 mΩ cm for the AZO layers with various thicknesses. Some relationships between the analyzed properties have been established, showing the dependence of the lattice distortion, the band gap energy and the mobility on the carrier concentration.