Analytical results for the plectonemic response of supercoiled DNA

The DNA molecule is modeled as an elastic rod with bending and twisting rigidities, subjected to external tension and twist applied at one end, the other end being clamped. We study the plectonemic equilibrium of such a rod, taking into account the impenetrability constraint. Numerical solutions of this boundary value problem have previously shown that purely elastic models can reproduce the supercoiling response of the DNA molecule. Using a variational approach, we derive analytical formulae for the elastic response of the filament, and extend former numerical results.     

Bioavailability and Toxicity of Metal Nutrients during Anaerobic Digestion

This paper investigates the effect of chelating agents on the bioavailability of Fe and Cu during anaerobic digestion. The results on metal speciation and methane production in anaerobic serum bottles showed that biomass was able to grow in the presence of citrate 1?mM and nitrilotriacetic acid (NTA) 1?mM, suggesting that the binding sites at the cell surface competed efficiently for the metals with the chelating agents added. The presence of free ethylenediaminetetraacetic acid 1?mM inhibited methanogenesis, and this seemed to be related to a loss in metal uptake capacity. Although the addition of soluble microbial products (SMP) did not change metal distribution in anaerobic systems, it caused an increase in the rate of methane production, and it is believed that direct uptake of Cu-SMP complexes was responsible for this increase. The best protection against Cu toxicity occurred when stoichiometric amounts of NTA, which should complex and solubilize most of the Cu, was added, and it is likely that NTA prevented lethal concentrations of Cu from being adsorbed onto the cell and hence internalized.     

Structural Response of Nuclear Containment Shield Buildings with Construction Openings

Steam generator replacement at nuclear power plants requires large construction openings in nuclear containment structures. This study examines the effects of such openings placed in a 61?cm (2?ft) thick dome of a shield building. The dome is cast in two layers, and the limiting cases of the two layers acting as one and the lower layer carrying the entire load are considered. Without openings, the stresses due to dead load in the structure are very low when compared to the material strength. With openings, the loads are easily redistributed around the opening, and the maximum stresses for the conservative case are between three and four and one-half times larger than in the original structure with no openings. The extent of the affected area around the holes is relatively small. Smooth corners in the openings are necessary to avoid high local stress concentrations.     

Real-time control of video surveillance systems with program supervision techniques

In this article, we describe a knowledge-based controlled platform using program supervision techniques. This platform eases the creation and the configuration of video surveillance systems. Several issues need to be addressed to provide a correct system configuration: (1) to choose, among a library of programs, those which are best satisfying a given user request, (2) to assign a correct value for each program parameter, (3) to evaluate performances and to guarantee a performance rate which is satisfactory regarding end-user requirements. This platform is composed of three main components: the library of programs, the knowledge base and the control component. The knowledge is either given by experts or learnt by the system. The control is generic in the sense that it is independent of any application. To validate this platform, we have built and evaluated six video surveillance systems which are featured with three properties: adaptability, reliability and real-time processing.     

Variation de la plombemie en fonction de la contamination par le plomb de l'eau livree a la consommation: Variation of the blood lead level as a result of lead contamination of the subjects drinking water

The combination of the chemical aggressivity of water and lead piping, as is well known, can cause severe cases of lead poisoning in those who consume such water. After a great number of observations and epidemiological studies which have strongly incriminated this metal in a wide range of pathologic conditions, other materials have been gradually substituted for lead; however, the problem remains.In compliance with a European Directive to survey the risk of lead poisoning (Council Directive, 1977), a random sample of 321 residents was selected from the Vosgian Mountains of France. This region is noted for its high incidence of cases of lead poisoning: 150 reported during 8 months in 1983 (Barbier et al., 1983).During the course of a health evaluation, a blood sample was taken from each subject for lead analysis. At the same time, a sample of tap-water (after running for 5 s) was taken from each subject home. Both lead analyses (blood and water) were performed by electrothermal atomization-atomic absorption spectrophotometry. Because of the log-normality of the distributions of the blood lead levels and the concentrations of lead in the drinking water, a logarithmic transformation was performed so that the results are expressed as the geometric mean, which for the amount of lead in the drinking water of our sample was found to be 0.16 mg l^?1.Among the subjects of this study, 28% are served by water containing more than 0.10 mg l^?1 of lead (the standard for France) and 48% by water containing more than 0.05 mg l^?1 (the European and WHO standard). In concurrence with numerous authors, our study indicates that, among our subjects, the blood lead level is much higher in men than in women (geometric means 22.9 and 15.0 μg dl^?1 respectively); this difference is highly significant (t-test:P < 0.001). Table 1 summarizes the results, by sex, obtained in this region compared with those from a study (Huel, 1982) concerning an urban French population whose geometric mean blood lead levels were 15.9 μg dl^?1 for men and 11.4 μg dl^?1 for women. The irrespective of sex, is highly significant (P < 0.001). Table 2 shows the significance of the relation between these subjects, high blood lead levels and the concentration of lead in their drinking water, while Fig. 1 shows that for contamination levels up to 0.02 mg l^?1 of lead in water, the blood lead level remains relatively stable, while above this apparent “threshold” value, the blood lead level begins to increase finally reaching quite high values in response to high contamination levels, suggesting a direct translation of increases in the water above the 0.02 mg l^?1 level to increases in the blood.     

A site selection model for high technology manufacturing firms in the United States

This article offers a quantitative model for site selection by high technology manufacturing firms. In the past, site selection studies have usually been qualitative in nature, and very subjective. This is an attempt to introduce a more objective quantitative approach. The site selection factors most important to high technology manufacturing firms were identified, ranked and weighted based on a US Joint Economic Committe survey of such firms. The eight most important factors were: the availability of technical and professional workers, labor costs, tax climate, academic institutions, cost of living, transportation for people, and access to markets. Demographic data on these factors were collected and analyzed for 32 developing high technology areas in the United States. By using the quantitative model, a score was developed for each area, allowing them to be ranked as R & D manufacturing environments. This model should prove a useful tool for both regional planners and high-tech companies seeking to relocate.     

Thoracic and abdominal SPECT-CT image fusion without external markers in endocrine carcinomas. The Group of Thyroid Tumoral Pathology of Champagne-Ardenne

Superimposition of SPECT and computed tomography (CT) slices from the thoracoabdominal region was achieved without the use of external markers for 14 studies in 13 patients with endocrine carcinoma. Technical feasibility and clinical validation of this retrospective fusion method were assessed. METHODS: Patients had a history of thyroid cancer or of carcinoid tumor. To detect tumor sites, CT scan and dual-isotope tomoscintigraphy were performed, with 99mTc-hydroxymethylene diphosphonate for bone scintigraphy and with 111In-pentetreotide, 131I or 131I-metaiodobenzylguanidine for tumor scintigraphy (TS). A superimposition method previously developed for the pelvic region was adapted to the nonrigid thoraco-abdominal region. CT-bone scintigraphy and CT-TS superimposed images were obtained. Clinical validation of the information obtained from the superimposed images was obtained from surgery or follow-up imaging studies performed after clinical evolution of the disease process. RESULTS: Reliable and reproducible registration was achieved in all patients. CT-TS superimposed images produced accurate localization of abnormal TS foci. Accuracy was limited primarily by variable relative displacements of the thoracoabdominal organs. For 10 sites in 8 patients, localization and/or characterization obtained from CT-TS images was confirmed by a reference technique. Superimposition enabled the localization of tumor sites that otherwise could not have been suspected from CT alone and allowed the characterization of CT suspicious masses and the confirmation of CT positive sites. Nonspecific tumor TS uptake sites were also localized. CONCLUSION: With standard CT and dual-isotope SPECT acquisitions, SPECT-CT fusion is feasible in the thoracoabdominal region without the use of external markers. Fused images were validated in 8 patients for 10 sites. The use of this technique could probably improve the management and care of patients with endocrine carcinoma.