低剂量率γ射线杀伤肿瘤细胞机制的实验研究

用60Co源以1Gy/min剂量率照射Hela细胞,剂量分别为1、2、5、10、15Gy.用AnnexinV和PI双染法观察凋亡细胞形态;DNA梯形条带证实凋亡存在;克隆形成分析细胞增殖能力.结果显示:(1)Hela细胞凋亡率随照射剂量和时间的增加呈上升趋势,照射后168h组各剂量点凋亡率高于其他各时间组.2Gy以下时凋亡率改变不大,达5Gy时凋亡率显著增加,且达峰值(72.57±2.04)%(P＜0.001).(2)早期凋亡细胞,PS外翻,胞膜呈绿色荧光圈.凋亡晚期出现Annexin V-FITC及PI染色均阳性的外绿内红的细胞图像.坏死细胞则为红色.(3)凋亡细胞碎片呈"梯状"条带.(4)1Gy/min的剂量率照射,剂量为2-15Gy,克隆形成率由(58.95±0.36)%降至(1.67±0.35)%(P＜0.001).表明低剂量率γ射线照射可诱导Hela细胞凋亡,其凋亡率与照射剂量相关,在5Gy时凋亡率最高.     

Fly ash as a sorbent for boron removal from aqueous solutions: Equilibrium and thermodynamic studies

ABSTRACT

This study presents the application of fly ash from brown coal and biomass burning power plant as a sorbent for the removal of boron ions from an aqueous solution. The adsorption process efficiency depended on the parameters, such as adsorbent dosage, pH, temperature, agitation time and initial boron concentration. The experimental data fitted well with the Freundlich isotherm model and the maximum capacity was found to be 16.14 mg g^?1. The adsorption kinetics followed the pseudo-second-order model. Also, the intra-particle diffusion model parameters were calculated. Thermodynamic parameters such as change in free energy (ΔG°), enthalpy (ΔH°), entropy (ΔS°) revealed on exothermic nature of boron adsorption onto the fly ash.     

铁炭微电解—混凝沉淀—MBBR工艺处理腈纶废水

腈纶废水对微生物活性具有不良影响,采用铁炭微电解—混凝沉淀-MBBR工艺对其进行处理.通过正交试验,探索了铁炭微电解预处理腈纶废水的最佳工艺条件;再以MBBR为生物反应器,进一步处理经过铁炭微电解预处理的腈纶废水.结果表明,最终出水COD可稳定至100 mg/L以下,氨氮接近15 mg/L.该工艺是处理腈纶废水的有效方...     

Development and numerical validation of a new model for walls with phase change materials implemented in TRNSYS

This paper presents a model of a wall with variable properties dedicated to modelling phase change materials (PCMs) in building envelopes. The model is implemented in the TRNSYS simulation tool and referred to as Type 3258. The 1-D conduction heat transfer equation is solved using an explicit finite-difference method coupled with an enthalpy method to consider the variable PCM thermal capacity. This model includes temperature-dependent thermal conductivity and PCM-specific effects like hysteresis and supercooling. The stability conditions are discussed and the algorithm implemented in TRNSYS is described. A numerical validation performed on wall test cases proposed by the International Energy Agency is presented, showing that the developed model is in agreement with reference models. The paper also discusses the impact of temporal and spatial discretization on the model performance. Modelling problems encountered when using an effective heat capacity method (compared to an enthalpy method) and when representing supercooling are also discussed.     

Properties of Light MMCs Modified with Cordierite Synthesized from Fly Ash

This paper presents novel opportunities for management of fly ash by synthesizing the material into cordierite ceramics and using it as a reinforcing phase for light metal alloys. Metal matrix composites (based on magnesium alloy and aluminum alloy) were produced by squeeze casting. The magnesium matrix composites with a suitably selected reinforcing phase content (2 wt.%) exhibited much better strength properties than the unmodified alloy (AM60). It was also demonstrated that the wettability (or the lack thereof) in the metal-ceramic system is critical to successful production of the composites based on the AK7 alloy with cordierite. Light alloy matrix composites reinforced with cordierite ceramics particles are innovative materials that combine high strength with low weight, which may be a key factor of merit for numerous applications of the composite in various branches of industries.     

High resolution SEM characterization of nano‐precipitates in ODS steels

The performance of the present‐day scanning electron microscopy (SEM) extends far beyond delivering electronic images of the surface topography. Oxide dispersion strengthened (ODS) steel is on of the most promising materials for the future nuclear fusion reactor because of its good radiation resistance, and higher operation temperature up to 750°C. The microstructure of ODS should not exceed tens of nm, therefore there is a strong need in a fast and reliable technique for their characterization. In this work, the results of low‐kV SEM characterization of nanoprecipitates formed in the ODS matrix are presented. Application of highly sensitive photo‐diode BSE detector in SEM imaging allowed for the registration of single nm‐sized precipitates in the vicinity of the ODS alloys. The composition of the precipitates has been confirmed by TEM‐EDS.     

一种基于移动代理的SIP移动性结构设计

研究了移动代理的预先执行认证程序技术,提出了在无线局域网中采用基于EAP-SIM的AAA关键字管理方式,实现在无线局域网(WLAN)与移动通信网(UMTS)环境中的无缝语音漫游服务的方法。     

The influence of protein–flavonoid interactions on protein digestibility in vitro and the antioxidant quality of breads enriched with onion skin

Different types of breads enriched with onion skin were studied. The objectives were twofold: to show and examine protein–phenolic interactions and to discuss results concerning phenolic content, antioxidant activity and protein digestibility in the light of in vitro bioaccessibility. Phenolic contents and antiradical abilities were linked with the level of onion skin supplement however, the amounts determined were significantly lower than expected. Fortification influenced protein digestibility (a reduction from 78.4% for control breads to 55% for breads with a 4% supplement). Electrophoretic and chromatographic studies showed the presence of indigestible protein–flavonoid complexes – with molecular weights about 25 kDa and 14.5 kDa; however, the reduction of free amino group levels and the increase in chromatogram areas suggest that flavonoids also bind to other bread proteins. The interaction of phenolics with proteins affects antioxidant efficacy and protein digestibility; thus, they have multiple effects on food quality and pro-health properties.