Evaluation of the historical records of lead pollution in the annual growth rings and bark pockets of a 250-year-old Quercus crispula in Nikko,Japan

The annual growth rings and bark pockets of a 250-year-old Japanese oak (Quercus crispula), collected from the Nikko National Park, Japan in 2000 AD, were analysed by ICP mass spectrometry. The annual rings, sampled in 5-year increments, recorded Pb concentrations from 0.01 to 0.1 mg kg(-1) and there was no significant change in concentration with time. In contrast, bark pocket samples dating from 1875 to the present showed a progressive increase in Pb concentration with time, from approximately 0.1 to 10 mg kg(-1). Shoots of epiphytic moss growing on the tree trunk contained 17 mg kg(-1) Pb. The bark pockets recorded historical increases in airborne Pb pollution accompanying the industrialisation of Japan, which was initiated by the opening of Japan's borders from 1854. This increase was not reflected by the annual rings. The 206Pb/207Pb isotope ratio of the bark pockets decreased from approximately 1.18 to 1.16 from 1964 to the present, indicating changes in the sources of Pb pollution. The 206Pb/207Pb isotope ratio of the moss shoots was similar to the current bark (1.16). The data showed bark pockets to be more effective than annual rings for recording historical change in airborne lead pollution.     

Detection of genetically modified organisms in foreign-made processed foods containing corn and potato

Investigations of the validity of labeling regarding genetically modified (GM) products were conducted using polymerase chain reaction (PCR) methods for foreign-made processed foods made from corn and potato purchased in the Tokyo area and in the USA. Several kinds of GM crops were detected in 12 of 32 samples of processed corn samples. More than two GM events for which safety reviews have been completed in Japan were simultaneously detected in 10 samples. GM events MON810 and Bt11 were most frequently detected in the samples by qualitative PCR methods. MON810 was detected in 11 of the 12 samples, and Bt11 was detected in 6 of the 12 samples. In addition, Roundup Ready soy was detected in one of the 12 samples. On the other hand, CBH351, for which the safety assessment was withdrawn in Japan, was not detected in any of the 12 samples. A trial quantitative analysis was performed on six of the GM maize qualitatively positive samples. The estimated amounts of GM maize in these samples ranged from 0.2 to 2.8%, except for one sample, which contained 24.1%. For this sample, the total amount found by event-specific quantitative analysis was 23.8%. Additionally, Roundup Ready soy was detected in one sample of 21 potato-processed foods, although GM potatoes were not detected in any sample.     

Analysis and evaluations of logical instructions called in parallel digital optical operations based on optical array logic

The authors have analysed and evaluated a two-dimensional instruction set of parallel operation based on optical array logic (OAL), which is a digital optical computing paradigm, to clarify efficient composition of an optical computing system based on OAL. To evaluate parallel operation based on OAL, the author have introduced new indices and evaluated a logical instruction set of various parallel operations with the indices, so that a guideline for composing a simple and efficient OAL computing system is clarified. Also, the authors have proposed the reduced operation kernel set correlation technique to perform parallel operations more efficiently by a simple OAL computing system. It has been clarified that the technique can reduce the required hardware necessary for an OAL computing system for efficient general-purpose processing.     

InxGa1−xAs ohmic contacts to n-type GaAs with a tungsten nitride barrier

Significant reduction of the contact resistance of In_0.7Ga_0.3As/Ni/W contacts (which were previously developed by sputtering in our laboratory) was achieved by depositing a W₂N barrier layer between the Ni layer and W layer. The In_0.7Ga_0.3 As/Ni/W₂N/W contact prepared by the radio-frequency sputtering technique showed the lowest contact resistance of 0.2 Ωmm after annealing at 550°C for 10 s. This contact also provided a smooth surface, good reproducibility, and excellent thermal stability at 400°C. The polycrystalline W₂N layer was found to suppress the In diffusion to the contact surface, leading to improvement of the surface morphology and an increase in the total area of the In_xGa−As between metal and the GaAs substrate. These improvements are believed to reduce the contact resistance.     

Optical CO2 sensor with the combination of colorimetric change of α-naphtholphthalein and internal reference fluorescent porphyrin dye

A new optical CO₂ sensor based on the overlay of the CO₂ induced absorbance change of pH indicator dye α-naphtholphthalein with the fluorescence of tetraphenylporphyrin (TPP) was developed. The observed luminescence intensity from TPP at 655 nm increased with increasing the CO₂ concentration. The ratio I₁₀₀/I₀ values of the sensing films consisting of α-naphtholphthalein in ethyl cellulose layer and TPP in polystyrene layer, where I₀ and I₁₀₀ represent the detected luminescence intensities from a layer exposed to 100% nitrogen and 100% CO₂, respectively, that the sensitivity of the sensor, are more than 53.9. The response and recovery times of the sensing films consisting of α-naphtholphthalein in ethyl cellulose layer and TPP in polystyrene layer were less than 5 s for switching from nitrogen to CO₂, and for switching from CO₂ to nitrogen. The signal changes were fully reversible and no hysterisis was observed during the measurements. The highly sensitive optical CO₂ sensor based on fluorescence intensity changes of TPP due to the absorption change of α-naphtholphthalein with CO₂ was achieved.     

Influence of the introduction of flexible alkyl chains on the thermal behavior and mechanical properties of mesogenic epoxy thermosets

A mesogenic epoxy resin (DGETAM) was cured with a series of curing agents having different lengths of long alkyl chain (nBAB, n = 4, 8, 12). Properties of the curings were compared with those of the DGEBA cured with the same curing agents revealing the achievement of a balance between certain levels of thermal properties and excellent mechanical properties. Moreover, some curing systems were prepared with twin mesogenic type epoxy resins (DGEnMA, n = 4, 6, 8, 10, 12) having different lengths of alkyl chain as a flexible spacer and the same curing agents (n′BABs). Combinations of the same concentrations of chemical structures in the basic units of the network structure were applied, and the thermal and mechanical properties of their curing systems were investigated. The fracture energy of each system increased considerably with the increase of the alkyl chain length that adjoins the two mesogenic groups in the epoxy resins. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2016 , 133, 44244.     

Heavy-ion-induced luminescence of amorphous SiO2 during nanoparticle formation

Silica glass was implanted with negative 60 keV Cu ions at an ion flux from 5 to 75 μA/cm² up to a fluence of 1 × 10¹⁷ ions/cm² at initial sample temperatures of 300, 573 and 773 K. Spectra of ion-induced photon emission (IIPE) were collected in situ in the range from 250 to 850 nm. Optical absorption spectra of implanted specimens were ex situ measured in the range from 190 to 2500 nm.

IIPE spectra showed a broad band centered around 560 nm (2.2 eV) that was assigned to Cu⁺ solutes. The band appeared at the onset of irradiation, increased in intensity up to a fluence of about 5 × 10¹⁵ ions/cm² and then gradually decreased indicating three stage of the ion beam synthesis of nanoclusters: accumulation of implants, nucleation and growth nanoclusters. The IIPE intensity normalized on the ion flux is independent on the ion flux below 20 μA/cm²at higher fluences. The intensity of the band increased with increasing samples temperature, when optical absorption spectra reveal the increase of Cu nanoparticles size.     

Temperature Dependence of the Raman Spectrum in Lithium Oxide Single Crystal

Temperature dependence of the Raman spectrum of lithium oxide single crystal has been measured over a temperature range of 80 to 1073 K. The frequency shift and the line width of the Raman spectrum in lithium oxide were about 531 and 4.5 cm^-1 at 80 K, respectively. At 1073 K, the frequency shift and the line width attained the values of 464 and 112 cm^-1, respectively. The strong temperature dependence of the frequency shift and line width was compared with data from some crystals with a fluorite structure.     

Return Link Systems for Wireless Mobile Camera Using 42 GHz-Band with Frequency and Space Diversity Techniques

In this paper, return link systems for wireless mobile camera using 42 GHz-band in multipath fading environments are proposed. The return link systems for wireless mobile camera require wireless transmission with high reliability as same as the conventional wired camera systems. The proposed return link systems achieve transmission with high reliability by taking into consideration frequency and space diversity techniques. The proposed systems can be classified as 3 three types of return link systems according to diversity techniques： FD （frequency diversity） systems, SD （space diversity） systems and FD＋SD system （frequency and space diversity）. Computer simulations are carried out in order to confirm the effectiveness of the proposed return link systems. It is confirmed that the proposed three types of return link systems have an advantage about BER performances and effectively exploit frequency and space resources.