On‐Line Detection Of State‐Of‐Charge In Lead Acid Battery Using Radial Basis Function Neural Network

To realize a stable supply of electric power in an automobile, an accurate and reliable detection method of SOC (state‐of‐charge) in a lead acid battery is required. However the dynamics of the battery is very complicated. The characteristics of the battery greatly change due to its degradation. Moreover a automobile has many driving patterns, which are unknown beforehand. Thus it is not easy to detect the SOC analytically. In this paper, to overcome this problem, a new on‐line SOC detection method with a radial basis function neural network is proposed. In order to increase the detection accuracy of degraded batteries, physical values related to the degradation degree are used as input signal in the neural network. The detection accuracies for different sized batteries and various degradation states are investigated.     

Development of cable fault location method using fiber optic distributed temperature sensor

When ground-fault problems occur on a cable line, immediate fault location and restoration are required. Therefore, various new methods to locate the fault point instantaneously have been investigated to replace such conventional methods as the Murray loop method and the pulse radar method [1]. These methods require a long time to locate the fault point. One possible fault location method is to sense the temperature rise following a ground fault using a fiber optic distributed temperature sensor. Application of this method was found feasible through sensing the temperature rise at a ground-fault test using a thermocouple as a temperature sensor with test cables [4]. A power/optical composite cable was prepared experimentally and after verifying its thermal mechanical performance, the temperature rise at an incidence of a fault was determined and the anticipated performance was demonstrated in a ground-fault test. This article describes the outline of the test.     

Temperature Dependence of the Raman Spectrum in Lithium Oxide Single Crystal

Temperature dependence of the Raman spectrum of lithium oxide single crystal has been measured over a temperature range of 80 to 1073 K. The frequency shift and the line width of the Raman spectrum in lithium oxide were about 531 and 4.5 cm^-1 at 80 K, respectively. At 1073 K, the frequency shift and the line width attained the values of 464 and 112 cm^-1, respectively. The strong temperature dependence of the frequency shift and line width was compared with data from some crystals with a fluorite structure.     

Microstructural change of ultrafine-grained aluminum during high-speed plastic deformation

Effect of strain rate on microstructural change in deformation of the ultrafine grained (UFG) aluminum produced by severe plastic deformation (SPD) was studied. Commercial purity 1100 aluminum sheets were highly strained up to an equivalent strain of 4.8 by the Accumulative Roll-Bonding (ARB) process at ambient temperature. The ARB-processed sheets were found to be filled with pancake-shaped ultrafine grains surrounded by high-angle grain boundaries. The ultrafine grains had a mean grain thickness of 200 nm and a mean grain length of 1100 nm. The ultrafine-grained aluminum sheets were deformed at various strain rates ranging from 2 to 6.0×10⁴ s⁻¹ by conventional rolling, ultra-high-speed rolling, and impact compression. High-speed plastic deformation generates a large amount of heat, inducing coarsening of the ultrafine grains during and after deformation. On the other hand, it was also suggested that high-speed plastic deformation is effective for grain-subdivision, in other words, ultra-grain refinement, if the effect of heat generation is extracted.     

The blocking barrier effect on aluminum electromigration due totitanium layers in multilayered interconnects of LSI's

Experimental evidence of an increase in the resistance of a cathode-side metal line without any void generation is presented for a multilayered metal structure terminated by via-holes during electromigration tests. This resistance increase is reversed to the initial value by high temperature storage after electromigration testing. The increase in the resistance of multilayered metal structures is attributed to the vacancy accumulation in the cathode side due to the blocking barrier effect of the refractory metal layer in the via-hole     

A novel technique for a DC brushless motor without position sensors

A dc brushless motor is a kind of synchronous motor driven by an inverter and requires sensors to detect the rotor position. As one of the methods, the induced voltages of a brushless motor have been utilized in practice. However, there are some problems in this method, e.g., the motor can obtain insufficient torque due to the low induced voltages in a low-speed range. This paper proposes a new method which controls the inverter angular frequency ω₁ by using inherent characteristics wherein the torque current i_r is almost proportional to the internal phase angle φ where the primary flux of a synchronous motor is controlled to be constant. If the parameters of a motor are given exactly, the speed regulation is quite small and the transient characteristics with high response and high starting torque are obtained. Furthermore, it is possible to operate a synchronous motor in the field-weakening range. Here, the principle of the control method and the performance characteristics of a dc brushless motor having no position sensors are discussed. The simulation and the experimental results of the tested machine show that the proposed method is very useful for practical applications.     

Prediction of spinal cord ischemia with a retrievable stent graft on endovascular treatment for a case of thoracic aortic aneurysm

OBJECTIVE: To determine the pharmacokinetics and absolute bioavailability of ciprofloxacin in 12 critically ill patients receiving continuous enteral feeding. Design: a prospective, cross-over study. SETTING: 12-bed surgical intensive care unit in a University Hospital. PATIENTS: 12 stable critically ill patients on mechanical ventilation and receiving continuous enteral feeding (Normoreal fibres) without diarrhea or excessive residual gastric contents ( < 200 ml/4 h). None had gastro-intestinal disease, renal insufficiency (estimated creatinine clearance > or = 50 ml/min) or was receiving medications that could interfere with ciprofloxacin absorption or metabolism. MEASUREMENTS AND MAIN RESULTS: The study was carried out after the fourth (steady state) b. i. d. intravenous (i. v.) 1-h infusion of 400 mg and the second b. i. d. nasogastric (NG) dose of 750 mg (crushed tablet in suspension). Plasma concentrations were measured by high-performance liquid chromatography. The median (range) peak concentration after i. v. infusion was 4.1 (1.5-7.4) mg/l, and that after NG administration was 2.3 (0.7-5.8) mg/l, occurring 1.25 (0.75-3.33) h after dosing. The median [range] areas under plasma concentration-time curves were similar for the two administration routes (10.3 [3.3-34.6] and 8.4 [3.6-53.4] for i.v. infusion and NG administration, respectively). Ciprofloxacin bioavailability ranges from 31 to 82 % (median, 44%). CONCLUSIONS: In tube-fed critically ill patients, a switch to the NG ciprofloxacin after initial i. v. therapy to simplify the treatment of severe infections is restricted to those for whom serial assessments of ciprofloxacin levels are routinely available.     

Vivid image projection system using e‐Paper active screen

Projected image on a screen is not always vivid enough when it is projected in a bright room. We generally have to choose either vivid image in a dark room or dull image in a bright room. We have suggested a new projection system which can realize high contrast image projection in a bright room. It is consisted of electronic paper screen, projector, and light‐emitting diode room light. The electronic paper (e‐Paper) screen alternates its whole surface white/black with 120 Hz. Room lights are controlled with the same frequency of 120 Hz with the opposite phase as that of the e‐Paper screen. We have confirmed that our new system has achieved higher contrast than the conventional projection system and also enough readability of paper documents in the room simultaneously. We have thus confirmed that our new system can bring an ideal condition, for audience, which can realize a vivid image projection in a bright room.