New trends in antineoplastic chemotherapy

The author present some possible ways how to enhance the effectiveness of chemotherapy. In addition to modification of the tactics of chemotherapy it is above all a reduction of the effects of cytostatics and overcoming the resistance to chemotherapy, while the introduction of new drugs is rather rare during the last decade. As to non-traditional ways, a part can be played by more effective prophylaxis of secondaries, induction of cell differentiation, a combination of chemotherapy with biological response modifiers (interferons and cytokines) or treatment with cytokines alone (interleukin-2, tumour necrosis factor).     

Study of etch rate characteristics of SF6/He plasmas byresponse-surface methodology: effects of interelectrode spacing

The characteristics of SF₆/He plasmas which are used to etch Si₃N₄ have been examined with experimental design and modeled empirically by response-surface methodology using a Lam Research Autoetch 480 single-wafer system. The effects of variations of process gas flow rate (20-380 sccm), reactor pressure (300-900 mtorr). RF power (50-450 W at 13.56 MHz), and interelectrode spacing (8-25 mm) on the etch rates of LPCVD (low-pressure chemical vapor deposition) Si₃N₄, thermal SiO₂, and photoresist were examined at 22±2°C. Whereas the etch rate of photoresist increases with interelectrode spacing between 8 and 19 mm and then declines between 19 and 25 mm, the etch rate of Si₃N ₄ increases smoothly from 8 to 25 mm, while the etch rate of thermal SiO₂ shows no dependence on spacing between 8 and 25 mm. The etch rates of all three films decrease with increasing reactor pressure. Contour plots of the response surfaces for etch rate and etch uniformity of Si₃N₄ as a function of spacing and flow rate at constant RF power (250 W) display complex behavior at fixed reactor pressures. A satisfactory balance of etch rate and etch uniformity for Si₃N₄ is predicted at low reactor pressure (~300 mtorr), large electrode spacing (12-25 mm), and moderate process gas flow rates (20-250 sccm)     

Effects of Sc2O3 and MgO passivation layerson the output power of AlGaN/GaN HEMTs

The low temperature (100°C) deposition of Sc₂O₃ or MgO layers is found to significantly increase the output power of AlGaN/GaN HEMTs. At 4 GHz, there was a better than 3 dB increase in output power of 0.5×100 μm² HEMTs for both types of oxide passivation layers. Both Sc₂ O₃ and MgO produced larger output power increases at 4 GHz than conventional plasma-enhanced chemical vapor deposited (PECVD) SiN_x passivation which typically showed ⩽2 dB increase on the same types of devices. The HEMT gain also in general remained linear over a wider input power range with the Sc₂O₃ or MgO passivation. These films appear promising for reducing the effects of surface states on the DC and RF performance of AlGaN/GaN HEMTs     

Performance enhancement of an induction motor by secondaryimpedance control

The paper demonstrates the use of nonresistive secondary control of an induction motor to improve efficiency, power factor and torque. A mathematical algorithm is presented to predict the control requirements in terms of secondary capacitance. The required secondary capacitance is implemented by a novel electronic switching technique that effectively increases the value of the used capacitor. This overcomes the high-capacitance demand and provides a feasible solution. Experimental verification is presented in the results obtained from a small induction motor drive