汽轮机数字电液控制系统及其应用

介绍了汽轮机数字电液控制系统（DEH）的硬件组成，着重论述了DEH的控制原理和控制过程。结合天津碱厂新建4^#机组,与前3台机组的液压控制调节方式进行比较，突出了DEH控制的优势。对DEH系统的软件作了介绍。同时对DEH的控制系统Foxboro I／A Series的系统软件和系统网络作了较详细的论述。最后，讨论了运行中可能出现的问题和解决方法。     

Chemical compositions and optical properties of HfOxNy thin films at different substrate temperatures

High-k HfO_xN_y thin films have been grown by radio frequency (rf) reactive sputtering of metal Hf target in N₂/Ar/O₂ ambient at different substrate temperatures. The chemical compositions of the films have been investigated as a function of substrate temperature by X-ray photoelectron spectroscopy (XPS). XPS measurements showed that nitrogen concentration increases with an increase in substrate temperature. Room-temperature spectroscopic ellipsometry (SE) with photon energy 0.75–6.5 eV was used to investigate the optical properties of the films. SE results demonstrated that refractive index n increases with an increase in substrate temperature. Based on TL parameters which were obtained from the best fit results used in a simulation of the measured spectra, meanwhile, we conclude that the energy band gap (E_g) decreases with an increase in substrate temperature.     

曲轴激光喷丸强化试验研究

采用实验的方法,研究了激光冲击强化对175A型柴油机曲轴疲劳寿命的影响,取得了激光冲击强化试验条件下曲轴过渡圆角处残余应力场的数据。并将激光冲击强化工艺效果和曲轴滚压强化效果做了对比性分析,结果表明：虽然激光冲击强化效果不如曲轴滚压强化,但考虑到激光工艺参数精确可控、加工质量好、成本低以及可避免滚压强化所造成的表面疲劳、撕痕等,激光冲击强化工艺可望代替滚压强化成为新型的曲轴强化手段。通过此类激光冲击强化强化实验可优化激光冲击的相关参数,使曲轴过渡圆角产生有利的残余应力场。     

基于CORBA和多Agent的模具敏捷制造的工作流管理

介绍了CORBA的工作原理，分析了模具敏捷制造的特点，提出了基于CORBA的模具敏捷制造工作流管理模型，并且将多Agent技术应用到该模型之中，使其具有清晰的结构，良好的开放性、集成性和自适应性。     

Fisher最优分割法在星星哨水库汛期分期划分中的应用

Fisher最优分割法是对有序样本进行最优化分段的一种数学方法。本文利用该方法对星星哨水库汛期进行相应的划分,结果表明该方法是可行的。因此,可利用该结果对分期实施不同的汛限水位,使水库的防洪和兴利效益达到最大。     

GS-08乙苯脱氢催化剂在广石化的应用

乙苯脱氢催化剂GS-08催化剂在广州石化总研制的首次应用。     

High‐Performance,Monolithic Polyaniline Electrochemical Actuators

New polyaniline (PANI) asymmetric membranes were fabricated using a phase‐inversion technique with hexane as the coagulation bath. These membranes exhibit a dense structure with macrovoids distributed asymmetrically throughout the cross‐section. A stress–strain study demonstrated that the Young's modulus (1.421 GPa) and strain at break (7.6 %) of the new PANI asymmetric membranes prepared from hexane are approximately 12 and 4 times higher, respectively, than the values reported previously for the PANI integrally skinned asymmetric membranes (ISAMs) (123 MPa Young's modulus and 1.8 % strain at break). Furthermore, monolithic electrochemical actuators based on a single PANI asymmetric membrane were constructed, and a bending movement of up to 20 Hz was experimentally recorded in a hydrochloric acid aqueous solution. A lifetime of over 329 500 cycles was determined for these actuators at a ± 2° angular displacement (5 Hz). The lifetime is limited by a bending fatigue that creates a transversal crack on the PANI membrane at the air–water interface. Control over the actuator movement is also manifested by the linear dependences of the bending angle on the charge and of the angular velocity on the current. These relationships are independent of both the kind of applied electric signal and the frequency used.     

乙烯-1-辛烯共聚物增韧应用研究

介绍了聚烯烃系弹性体（POE）的特点及其在PP增韧改性中的应用，同时还报道了马来酸酐接枝的POE在极性聚合物复合体系中的应用研究。     

汽车发动机电机铁芯用钢(ADW2)的研制开发

鞍钢研制开发的汽车发动机启动电机用钢是针对汽车电机铁芯用钢（定、转子）而开发的电机钢类产品。介绍了该产品的研制过程及规格、特点。通过批量试制及装机试验，产品巳满足用户的使用要求。     

秦岭金矿9~#脉主要矿物特征及矿物学标志

小秦岭地区金矿床严格受构造控制，各成矿阶段及矿物学特征明显，通过对矿物学特征的研究找出矿物学标志，认为今后找矿要注意各阶段石英的颜色、黄铁矿中金的含量以及矿石中银的含量，这些与金有密切关系.