Numerical simulation model of vibration responses of rectangular plates embedded with piezoelectric actuators

A numerical simulation model for random large amplitude vibration control of composite plate using piezoelectric material is presented. The H_∞ control design is employed to suppress the large amplitude vibrations of composites plates under random loading. The numerical simulation model is developed and based on the finite element method. The finite element governing equation includes fully coupled structural and electrical nodal degrees of freedom, and consider the von Karman large amplitude vibration. The modal reduction method using the structural modes is adopted to reduce the finite element equations into a set of modal equations with fewer degrees of freedom. The modal equations are then employed for controller design and time domain simulation. In the simulations without control, the value of the linear mode to the nonlinear deflection is quantified; and the minimum number of linear modes needed for accurate model is obtained. In the simulations with control, it is shown that the truncated modes, which are neglected in the control design, deteriorate the controller performance. Generally, the vibration reduction level is not monotonically increasing with the size of the piezoelectric actuator. The optimal piezoelectric actuator size depends on the excitation level. For higher excitation level, optimal actuator size is larger. The H_∞ controller based on the linear finite element formulation gives better vibration reduction for small amplitude vibration, but it still gives reasonable performance for large amplitude vibration provided that the piezoelectric actuator is big and powerful enough.     

Characterization and comparison of PECVD silicon nitride and silicon oxynitride dielectric for MIM capacitors

In this letter, we report on the electrical characteristic and the comparison of the metal-insulator-metal (MIM) capacitors with PECVD silicon nitride (SiN) and silicon oxynitride (SiON). Both capacitors are found to exhibit low leakage and high breakdown field strength, as well as absence of dispersive behavior, good linearity, and comparable quality factor behaviors.     

Field dependence of impact ionization coefficients in In/sub 0.53/Ga/sub 0.47/As

Electron and hole ionization coefficients in In/sub 0.53/Ga/sub 0.47/As are deduced from mixed carrier avalanche photomultiplication measurements on a series of p-i-n diode layers, eliminating other effects that can lead to an increase in photocurrent with reverse bias. Low field ionization is observed for electrons but not for holes, resulting in a larger ratio of ionization coefficients, even at moderately high electric fields than previously reported. The measured ionization coefficients are marginally lower than those of GaAs for fields above 250 kVcm/sup -1/, supporting reports of slightly higher avalanche breakdown voltages in In/sub 0.53/Ga/sub 0.47/As than in GaAs p-i-n diodes.     

The Effect of Moisture Content on the Conversion of Ergosterol to Vitamin D in Shiitake Mushrooms

The distribution of ergosterol in different parts of shiitake mushrooms was studied in order to optimize the conversion of ergosterol to vitamin D₂ during drying. The effect of moisture on the conversion of ergosterol to vitamin D₂ was also investigated by adjusting the moisture content of fresh mushrooms to different levels in a large vacuum desiccator and subjecting them to UV irradiation at 290-320 nm wavelength, for 2 h. The moisture, ergosterol and vitamin D₂ contents were determined using standard procedures. It was found that the ergosterol content on a dry matter basis of fresh shiitake mushroom was highest in the gills (10.6 ± 0.99 mg/g DM), followed by the cap or pileus (5.34 ± 0.64 mg/g DM) and was least in the stalk or stipe (2.97 ± 0.56). The moisture content had a marked influence on the conversion of ergosterol to vitamin D₂, the best conversion taking place at a moisture content of about 70% on a wet basis.     

Efficient Computation of EXIT Functions for Nonbinary Iterative Decoding

The calculation of nonbinary extrinsic information transfer charts for the iterative decoding of concatenated index-based codes is addressed. We show that the extrinsic information at the output of a constituent a posteriori probability decoder can be calculated with very low complexity, where expensive histogram measurements are not required any more. An example for turbo trellis-coded modulation demonstrates the capabilities of the proposed approach     

Single-photon avalanche diode detectors for quantum key distribution

The application of quantum key distribution (QKD) has raised particular demands for single-photon detectors. One of the most promising candidates at the low-loss optical fibre communications windows is the planar geometry InGaAs/InP single-photon avalanche diode. These detectors have been modelled, fabricated and characterised at 1.55 mum wavelength. Their performance in terms of single-photon detection efficiency, dark count rate, timing jitter and afterpulsing behaviour are reported and compared with the best commercially available, linear multiplication avalanche photodiodes operated in Geiger-mode. Their use in the application of QKD is discussed.     

Scalar quantisation of LSF parameters using vector measurement

A new form of line spectral frequency (LSF), bounded line spectral frequency, is presented. It is shown that the new representation is more efficient than the direct line spectral frequency and the differential line spectral frequency (DLSF). By using a vector measure, the scalar quantisation of tenth-order linear predictive coding (LPC) parameters can be coded at 28 bit/frame with a transparent quantisation quality     

Variants of chromosome 9 in phenotypically normal individuals

The human chromosome 9 displays the highest degree of structural variability. Four different types of variants are described including pericentric inversion, extra G-positive band in the q arm, additional G-positive band in the p arm and duplication of band 9q21-q22. It is important to demonstrate inheritance from a phenotypically normal individual in order to differentiate between a variant chromosome and an abnormal chromosome.     

Improved strained HEMT characteristics using double-heterojunctionIn0.65Ga0.35As/In0.52Al0.48As design

The DC and microwave properties of strained In_0.65Ga _0.35As/In₀₅₂Al_0.48As HEMTs (high electron-mobility transistors) with double-heterojunction design are presented. The high sheet carrier density and good carrier confinement give rise to excellent device performance with very low output conductance. For 1×150-μm² long-gate HEMTs, the measured cutoff frequency f_T and maximum frequency of oscillation f_max are as high as 37 and 66 GHz, respectively