Radionuclide contamination of foods imported into Iraq following the Chernobyl nuclear reactor accident

Since early 1986, a monitoring program for radionuclides in imported foods has been carried out by the Iraqi Atomic Energy Commission. After the Chernobyl nuclear reactor accident in the Soviet Union, the program was expanded; our laboratory was officially designated by the Iraqi Government to measure radionuclide activity concentrations in foodstuff imported from countries known to be severely contaminated by Chernobyl radioactive fallout. Gamma-spectrometric analysis was used. Food items such as powdered milk, lamb meat, poultry, cereals and grains imported into Iraq before the Chernobyl accident did not contain any detectable fission products. However, all lamb meat, 81% of the lentil, 44% of the powdered milk and chick-pea, and 17% of the roast beef samples were contaminated with 137Cs or 134Cs and 137Cs. The highest 137Cs contamination levels found were 82, 147, 420, 6 and 4 Bq kg-1, respectively. Contamination by 134Cs was approximately 50% of the values given above.     

Chemical and physical characteristics of a eutrophic reservoir and its tributaries: Long Lake, Washington

Surveillance on the Spokane River and its tributaries has shown that a major source of nutrients influencing the eutrophication of Long Lake was the effluent of the Spokane primary sewage treatment plant. Existing concentrations of nitrate nitrogen and orthophosphate increased threefold and tenfold, respectively, below the effluent. Of the influent phosphate phosphorus, 19 per cent was retained in the reservoir.A density current system was evident in Long Lake which altered vertical and longitudinal distribution of physical and chemical parameters. This current isolated a wedge of water on the reservoir bottom which became anaerobic. During the period of anaerobiosis, phosphate phosphorus and nitrogen maxima were present in the hypolimnion.     

Reaction processes effecting the analysis of chloroform by direct aqueous injection gas chromatography

Several important reaction processes which influence the analysis of chloroform by direct aqueous injection (DAI) gas chromatography have been identified through an investigation of the chlorination reactions of humic acid and a series of simple polyhydroxyaromatic and diketone model compounds in dilute solution. The reaction of chlorine with each substrate system was studied over the pH range 2–12. Gas chromatographic analysis by the DAI and organic solvent liquid-liquid extraction (LLE) procedures gave different measurements for the yield of CHCl₃ depending on the pH of the reaction solution and the chemical structure of the substrate. Under acidic and neutral conditions, a variety of trichloromethyl-substituted intermediates were identified at high concentrations in addition to chloroform by GC/MS. Chloral hydrate, trichloroacetic acid, pentachloroacetone and hexachloroacetone undergo hydrolysis and/or decarboxylation to form CHCl₃ at the high injection port temperatures employed in aqueous injection GC analysis. The results obtained in the current study indicate that the decomposition of these and structurally-related species accounts for differences previously observed upon application of the DAI and either the LLE or purge-and-trap techniques for the determination of CHCl₃ in chlorinated natural waters.     

Radon and 'King Solomon's Miners': Faynan Orefield, Jordanian Desert

Concentrations of 222Rn were measured in ancient copper mines which exploited the Faynan Orefield in the South-Western Jordanian Desert. The concentrations of radon gas detected indicate that the ancient metal workers would have been exposed to a significant health risk and indicate that any future attempt to exploit the copper ores must deal with the hazard identified. Seasonal variations in radon concentrations are noted and these are linked to the ventilation of the mines. These modern data are used to explore the differential exposure to radon and the health of ancient mining communities.     

Development of a thermal scheme for a cogeneration combined-cycle unit with an SVBR-100 reactor

At present, the prospects for development of district heating that can increase the effectiveness of nuclear power stations (NPS), cut down their payback period, and improve protection of the environment against harmful emissions are being examined in the nuclear power industry of Russia. It is noted that the efficiency of nuclear cogeneration power stations (NCPS) is drastically affected by the expenses for heat networks and heat losses during transportation of a heat carrier through them, since NPSs are usually located far away from urban area boundaries as required for radiation safety of the population. The prospects for using cogeneration power units with small or medium power reactors at NPSs, including combined-cycle units and their performance indices, are described. The developed thermal scheme of a cogeneration combined-cycle unit (CCU) with an SBVR-100 nuclear reactor (NCCU) is presented. This NCCU should use a GE 6FA gasturbine unit (GTU) and a steam-turbine unit (STU) with a two-stage district heating plant. Saturated steam from the nuclear reactor is superheated in a heat-recovery steam generator (HRSG) to 560–580°C so that a separator–superheater can be excluded from the thermal cycle of the turbine unit. In addition, supplemental fuel firing in HRSG is examined. NCCU effectiveness indices are given as a function of the ambient air temperature. Results of calculations of the thermal cycle performance under condensing operating conditions indicate that the gross electric efficiency η _{el NCCU} ^gr of = 48% and N _{el NCCU} ^gr = 345 MW can be achieved. This efficiency is at maximum for NCCU with an SVBR-100 reactor. The conclusion is made that the cost of NCCU installed kW should be estimated, and the issue associated with NCCUs siting with reference to urban area boundaries must be solved.     

Ultrafast terahertz responses in monolayer graphene

ABSTRACT

We theoretically investigate the ultrafast terahertz (THz) properties of monolayer graphene. The analytical formulations of the photon carrier, electric polarization and optical current are obtained by solving the Bloch-equations in present of the ultrafast THz Gaussian pulse. Graphene shows a large nonlinear and ultrafast optical response at THz frequencies due to the gapless and relativistic Dirac particles with nearly linear energy dispersion. It is found that the photon carrier density, electric polarization and optical current density increase with increasing the frequency of the THz pulse. These theoretical results are in agreement with recent experimental findings. This study confirms further that graphene exhibits important features and is relevant to the applications in the ultrafast THz fields.     

Energy-efficient algorithms for assessment of the rail-circuit operation

The voltage in a rail circuit is determined for reliable detection of the mobile unit or a train on the section of the railway track. It is proposed to use the structures of the automatic block system based on the time-division channels of status scanning of the rail circuits with subsequent signal processing by two parameters. The first parameter includes the assessment of correspondence of the code signals transmitted to the rail circuit and received from the rail circuit. The second parameter is obtained based on the analysis of the voltage at the rail-circuit output within the current and previous measurements considering the voltagechange rate. This latter parameter makes it possible to distinguish reliably the state when the rail track is occupied by the train from the random changes of the rail-circuit parameters from the influence of the external factors. The proposed algorithms permit one to reduce significantly consumption of electric energy providing operation of rail circuits.     

The Effects of Annealing After Equal Channel Angular Extrusion (ECAE) on Mechanical and Magnetic Properties of 49Fe-49Co-2V Alloy

Metallurgical and Materials Transactions A - Equal channel angular extrusion (ECAE) of 49Fe-49Co-2V, also known as Hiperco® 50A or Permendur-2V, greatly improves the strength and ductility of...     

Microdistortions,Hardness, and Young’s Modulus of Multicomponent Bcc Solid Solutions

Powder Metallurgy and Metal Ceramics - The phase composition, type II microstresses, and coherent scattering domains (CSDs) of multicomponent (medium- and high-entropy) bcc solid solutions with an...     

Forest fires in cork oak (Quercus suber L.) stands in Portugal

Fire and cork can be considered both the most serious problem and the most valuable resource of Portuguese forests. The existence of important areas of burned cork oak stands resulting from severe fire seasons in recent years is an environmental problem which deserves special attention. This paper makes a multidisciplinary survey of the problem of burned cork oak stands focusing on: the dimensions of the problem in Portugal, the remarkable resistance of cork oak to fire, the post‐fire management of cork oak stands, and the economic and ecological effects of fire in cork oak stands. Particular emphasis is given to knowledge gaps in this context.