施加复合电磁搅拌对A357合金微观组织的影响

在半固态加工技术中，电磁搅拌是最早应用于制备非枝晶浆料的方法之一，同时也是半固态触变压铸技术最早获得工业应用的重要技术基础之一。采用自行开发的电磁搅拌器，研究了多种不同电磁搅拌方式在不同工艺条件下，单独施加或复合施加对A357合金微观组织的影响。试验结果表明：单一施加旋转感应电磁搅拌时，浆料径向组织很不均匀；单一施加无芯感应电磁搅拌。当搅拌电流较小时，径向组织也不均匀，增大电流，浆料质量有明显改善；采用（旋转感应＋无芯感应）复合电磁场进行复合电磁搅拌时，可在电流较小时获得满意的浆料质量。     

船艇电站仿真与综合管理系统

论文介绍了船艇电站模拟器的组成和实时仿真功能,着重描述了多层次的图形管理系统及其仿真界面。课题将多媒体课件制作与模拟器有机地结合,涵盖了船舶主要电气设备的控制电路,既利于实践训练又便于原理的讲解,并在实践中取得了良好的效果。     

~（60）Co辐照对聚四氟乙烯表面润湿性的影响

研究了具有低表面能的氟聚合物聚四氟乙烯（ＰＴＦＥ），经６０Ｃｏγ射线辐照后表面状态的变化，以及其对液体介质蒸馏水的润湿性。较详细地论述了辐照后表面粗糙度、结晶度以及表面化学基因等不同因素对ＰＴＦＥ表面润湿性的影响。通过对ＰＴＦＥ及其表面的红外、Ｘ光衍射，表面粗糙度的分析，弄清了辐照后ＰＴＦＥ表面化学基团的改变对有机氟聚合物表加的润湿性影响很大，而粗糙度和结晶度的变化对润湿性影响较小。     

光学全交叉网络与SW榕树（F＝S＝2）网络拓扑等价的多样性

本文对有关互连网络拓扑等价的分析方法作了简单评述。并采用互连网络拓扑等价的图分析法分析了自由空间光学互连全交叉网络与ＳＷ榕树网络的拓扑等价及其多样性，拓展了全交叉网络在数字光计算、光子交换及多处理机系统的潜在应用。     

6M32(51)氮氢气压缩机系统的技术改造

1 机组简介 6M32(51)-190/320-BX型氮氢气压缩机的基础件采用德国博尔格公司的专有技术,具体参数如下: 压缩介质:氮氢气,压缩级数:6级;转速:375rpm;行程:320mm,轴功率:2920kW,容积流量:190m~3/min;气量调节:回路调节,冷却填料润滑油:1.95 kg/h;重量:主机69.45t,     

Performance of trellis coded-8PSK with cochannel interference

The performance of trellis coded-8PSK in the presence of cochannel interference is analyzed and compared with the performance of uncoded QPSK. The analytical expressions are derived and supported by simulating the bit error rate performance of different TC-8PSK systems. The analytical and simulation results show that TC-8PSK is slightly more robust to cochannel interference than uncoded QPSK     

立式旋风锅炉的燃烧自适应控制

分析了立式旋风锅炉的燃烧特点和燃烧系统动态特性，讨论了它的软硬件构成及其功能。     

An important factor affecting synergism on coprocessing of Taiheiyo coal with Athabasca oil sand bitumen

A series of mixtures of Japanese subbituminous Taiheiyo coal and Athabasca oil sand bitumen (AOB) with various coal concentrations (0–100 wt%) was coprocessed in a 70 ml autoclave at 420°C for 1 h in the presence of H₂ (50 kg/cm² at room temperature) and sulfided Ni---Mo/Al₂O₂ catalyst. The mixture containing 2 wt% coal produced the largest amount of hexane soluble fraction (HS) and the smallest amount of benzene insoluble fraction (BI). Thus, a synergistic liquid production occurred for this mixture with 2 wt% coal by suppressing the retrogressive reactions which proceeded for pure AOB. The HS obtained from mixtures with 2–30 wt% showed higher H/C ratios and lower heteroatom contents than those obtained from pure AOB and the mixtures with more than 30 wt% coal. The amounts of transferable hydrogen contained in the mixtures were estimated using anthracene as a hydrogen acceptor. The mixtures with 2–10 wt% coal contained higher amounts of donor hydrogen than pure AOB. The HS yield from the various mixtures was correlated with the amount of donor hydrogens contained in the mixtures, except for the mixture with 10 wt% coal. Thus, the important factor which results in synergism is suggested to be the amount of donor hydrogens contained in the feed mixtures.     

Evaluating Liquefaction Strength of Partially Saturated Sand

A method is presented for evaluating the liquefaction strength of partially saturated sand using the compression wave velocity (P-wave velocity), a new indicator of saturation. Based on laboratory test results, an empirical correlation that relates the liquefaction strength with the pore pressure coefficient B is firstly proposed. The strength is defined as the cyclic stress ratio required to cause liquefaction at a specified number of cycles. With the aid of a theoretical relation between B and the P-wave velocity, an explicit correlation of more interest is then established between the liquefaction strength of sand and its P-wave velocity. A comparison of the predictions using this explicit correlation with laboratory measurements shows a satisfactory agreement. The significance of this method lies in that it makes it possible to evaluate the liquefaction strength of sand as affected by saturation through the measurement of P-wave velocity, which can be made not only in the laboratory but particularly in the field.