An efficient technique for detecting catastrophic convolutional codes

Catastrophic convolutional codes (CC) cause an infinite number of decoded data bit errors when decoding a finite number of code symbols. A CC displays a catastrophic error propagation if the generating polynomials have a common factor. An efficient algorithm for polynomial factorization in GF(2^m) is used for detecting catastrophic CC for any rate n/m and constraint length k. A general formula is derived to calculate the number of catastrophic codes in any (m, n, k) CC.     

Magnetometer spacing criterion for biomagnetic source currentimaging

A criterion for determining the maximum spacing between magnetometers for measuring the magnetic field is derived. A two-dimensional (2-D) filter model is employed to determine the maximum spatial frequency component present in the magnetic field that is above the spectral noise level. This maximum frequency component is then sampled at a rate greater than twice per period as indicated by the Nyquist criterion, yielding the required magnetometer spacing. It is shown that the rule-of-thumb employed in current clinical biomagnetic array systems, that the spacing between the coils should be approximately equal to the depth of the source, is adequate when the signal-to-noise power ratio is less than 28.4 (14.5 dB). The analysis also quantitatively demonstrates that reducing the separation between the measurement and source planes has a greater effect on the resolution than decreasing the noise level by the same factor. This result is important for employing high T_c superconductor magnetometers that allow thinner thermal insulating layers at the cost of higher thermal noise     

Polymer networks based on α,ω-methacrylate-terminated poly(1,3-dioxolane)

α,ω-Methacrylate-terminated poly(1,3-dioxolane)s (polyDXL) were synthesized by cationic ring-opening polymerization of DXL in the presence of methylene-bis(oxyethylmethacrylate) as transfer agent. If the initiator concentration is small compared with the transfer agent concentration, the molecular weights of the polymers are governed by the ratio of the reacted monomer to the reacted transfer agent. The α,ω-methacrylate-terminated polyDXLs obtained undergo free radical polymerization with formation of polyacetal networks. The properties of the networks as function of the molecular weight of the corresponding prepolymers are reported.     

Sequence capture-PCR improves detection of mycobacterial DNA in clinical specimens

The rapid identification of mycobacterial DNA in clinical samples by PCR can be useful in the diagnosis of tuberculous infections, but several large studies have found that the sensitivity of this approach is not better than that of culture. In order to improve the sensitivity of detection of mycobacterial DNA in clinical specimens from patients with paucibacillary forms of tuberculosis, we have developed a procedure permitting the specific capture of mycobacterial DNA in crude samples prior to amplification, thereby concentrating the target sequences and removing irrelevant DNA and other potential inhibitors of the amplification reaction (sequence capture-PCR). By using this approach to capture and amplify two different sequences specific for organisms of the Mycobacterium tuberculosis complex (IS6110 and the direct repeat region), it was possible to detect as little as one genome of mycobacterial DNA in samples containing up to 750 micrograms of total DNA, representing a 10- to 100-fold increase in sensitivity compared with that obtained by purifying total DNA prior to amplification. Detection of the IS6110 sequence in pleural fluid samples from patients with tuberculous pleurisy by sequence capture-PCR gave positive results in 13 of 17 cases, including 3 of 3 culture-positive samples and 10 of 14 culture-negative samples. In contrast, when total DNA was purified from these samples by adsorption to a silica matrix prior to amplification, only the three culture-positive samples were positive by PCR. The sensitivity of detection of the direct repeat sequence in these samples by sequence capture-PCR was similar to that of IS6110 and, in addition, permitted immediate typing of the strains from some patients. We conclude that sequence capture-PCR improves the sensitivity of detection of mycobacterial DNA in paucibacillary samples. This approach should be useful in detecting rare target sequences from organisms implicated in other pathologic processes.     

Direct and indirect assessment of skeletal muscle blood flow in patients with congestive heart failure

Techniques which are currently used to measure skeletal muscle blood flow (SMBF) in patients with congestive heart failure (CHF) are neither convenient nor accurate. They have led to discrepant results in patients with congestive heart failure and are, in part, responsible for the ongoing debate regarding the factors which limit the rise in body oxygen consumption during exercise in these patients. However, direct measurement of SMBF may not be needed during exercise in patients with severe CHF. Their skeletal muscles maximally extract oxygen. Consequently, increase in oxygen consumption by the skeletal muscles is only mediated by a concomitant increase in SMBF. In patients with severe CHF, peak body oxygen consumption attained during maximal exercise closely depends on the rise in SMBF, and thus provides an indirect measurement of SMBF.     

Chemistry of the pyrrolo[1,2-alpha]benzimidazole antitumor agents: influence of the 7-substituent on the ability to alkylate DNA and inhibit topoisomerase II

This study addresses the influence the 7-substituent on the cytotoxicity of pyrrolo[1,2-alpha]-benzimidazole quinones possessing a 6-aziridinyl group (PBIs) and a 6-acetamido group (APBIs). Reduction of a PBI to the aziridinyl hydroquinone results in both nucleophile trapping (alkylation) and 1,5-sigmatropic shift reactions. The latter process is essentially an internal redox reaction wherein the hydroquinone causes reductive opening of the aziridinyl ring. The 7-substituent controls the fate of the aziridinyl ring by means of steric and electronic effects. An electron-rich 7-substituent favors the 1,5-sigmatropic shift reaction. If the 7-substituent distorts the 6-aziridinyl group from the conformation required for the 1,5-sigmatropic shift, then nucleophile trapping occurs. The 7-methyl substituent results in significant nucleophilic trapping, and the 7-unsubstituted and 7-methoxy substituents favor the 1,5-sigmatropic reaction. Thus, the 7-methyl PBIs show the most cytotoxicity of the analogues studied. The APBIs are cytotoxic only as quinones, and reduction to the hydroquinone results in loss of activity. Consistent with this observation, the change from 7-methyl to the more electron-rich 7-methoxy results in a substantial loss of APBI cytotoxicity as well as decreased topoisomerase II inhibition. The mechanism of inhibition is thought to involve the interacalation of only electron deficient APBIs into DNA.     

The effects of growth hormone in children with a GH deficiency: a report of 5 cases

The authors describe 5 cases, 3 boys and 2 girls, with idiopathic growth hormone deficiency in prepubertal age, treated with human growth hormone. In four of five cases the response to treatment with GH was relevant. Only in one case (F1) the response was negative. The results of this study confirm that rhGH is a safe and effective therapy in children with GHD.     

Low-temperature phase transformation in Li-10 at. % Mg

It is not known whether impaired hematopoiesis noted during human immunodeficiency virus (HIV) infection results from infection of stem/progenitor cells or of cells of the bone marrow microenvironment. Normal adherent primary stromal layers were exposed to HIV to determine which of this mixture of endothelial cells, fibroblasts, and macrophages are susceptible to the virus. Viral p24 in supernatants was noted with monocytotropic HIV-1Ada, HIV-1Ba-L, and HIV-1JR-FL but not with lymphotropic HIV-1LAI nor HIV-1MN strain, and only stromal macrophages expressed the viral antigens. Coculture of the layers with PHA-activated normal lymphocytes failed to rescue lymphotropic virus. No p24 was produced when macrophage-depleted stromal cells were exposed to either HIV-1Ba-L or HIV-1LAI; proviral DNA was then amplified by PCR in cells exposed to either virus, though coculture with lymphocytes rescued only HIV-1Ba-L. Altogether, these data indicate that macrophages are the major targets of HIV in cultured stromal layers. As virus replication in macrophages did not affect the profile of major cytokines involved in regulating hematopoiesis, HIV infection could alter hematopoiesis by other as yet unspecified mechanisms.     

Influence of interfacial microcracks on the elastic properties of composites

A model is established to quantify the influence of interfacial microcracks on the elastic properties of a particulate composite using a combination of theoretical and finite element analysis. A unique way to construct physical models which could accommodate both crack size and crack density is proposed. Based on energy principles, the influence of a dilute concentration of interfacial microcracks is first studied. The case of a finite concentration of microcracks is solved subsequently by combining the dilute concentration solutions and the differential scheme. Both cases agreed well with existing composite theories for the limiting condition of complete decohesion. The final model predicts the effective elastic properties as functions of both crack size and microcrack density.     

Diffusion bonding of ferritic oxide dispersion strengthened alloys to austenitic superalloys

The superior high temperature mechanical strength and oxidation resistance of ferritic oxide dispersion strengthened (ODS) tubular alloys are compromised by the difficulties encountered in joining. Conventional fusion welding techniques generate a weld fusion zone which is devoid of the mechanical strength exhibited by the base material. Therefore, more sophisticated solid state joining techniques, such as diffusion bonding, must be employed when joining ODS materials. This paper describes a series of solid state diffusion bonding experiments carried out between two tubular ferritic ODS alloys and two high temperature austenitic alloys. Careful control of bonding conditions produced pressure retaining joints between one of the tubular ODS alloys and both austenitic alloys. The successful joint design was incorporated into the manufacture of a tubular creep component, which enabled a series of internally pressurized creep tests to be carried out. The microstructure developed at the bond interface of each of the four separate material couples is described and the high temperature performance of the pressure retaining joints is discussed.