Combustion of oil palm stone in a pilot-scale fluidised bed reactor

Biomass is being generated in vast amounts from oil palm plantations particularly in developing countries such as Malaysia, Thailand and Indonesia. Oil palm stone (OPS) is currently considered a waste material and has not previously been considered for energy purposes. The main objective of this study was to investigate the thermochemical conversion of OPS in a pilot-scale fluidised bed combustor. The net heating value of OPS was 24.93 MJ/kg. The effect of primary air flowrate and initial bed temperature were the main parameters investigated. The bed and bed's surface temperature were found to decrease as the primary air flowrate increased. In all tests CO emissions were less than 0.2%. The emissions of SO₂ and HCl ranged from 0.02 ppm to 0.05 ppm, significantly below the permitted levels set by legislation. Stable combustion was observed at a bed temperature of 950 °C. The most abundant elements found in the ash were Al, Ca, Fe, K, Mg, Mn, P, S and Si. However, due to the temperature regime used in the study fouling would not be an issue.     

Structural,optical and magnetic properties of nanocrystalline Zn0.9Co0.1O-based diluted magnetic semiconductors

With a view to understand the influence of nano size on various properties of cobalt-doped ZnO-based diluted magnetic semiconductors, a series of materials were prepared by the citrate gel route. The phase and morphology studies have been carried out by X-ray diffraction and transmission electron microscopy, respectively. All the samples of the present investigation are found to have hexagonal wurtzite structure and crystallite sizes are found to vary from 25 nm to 65 nm. From the optical absorption measurements it has been observed that upon doping with cobalt, the energy band gap is found to shift towards lower energy side (red shift) while it shifts towards higher energy side (blue shift) when the crystallite size is increased continuously. It has been observed from the XPS results that oxidation state of Cobalt is +2 and that the difference in binding energies of Co 2p_3/2 and Co 2p_1/2 is found to increase continuously with increasing crystallite size. Finally, all the samples are found to exhibit room temperature ferromagnetism and the specific magnetization decreases with increasing crystallite size.     

Tribometrology of Skin

The quantitative assessment of both skin health and skin care products is suggested based on skin tribological properties. Simultaneous multi-sensor measurements of both coefficient of friction and contact electrical impedance allow for fast and quantitative evaluation of skin conditions such as dryness and moisturization, and early diagnosis of skin diseases or of the deterioration in skin functions at a stage that may not be easily discernable visibly. It may be instrumental in developing and testing skin cosmetics and medicine.     

A new strain hardening model for rate-dependent crystal plasticity

This paper presents a crystal plasticity based finite element analysis employing the new microstructure-based strain hardening model recently presented by Saimoto and Van Houtte (2011) [7] to simulate formability and texture evolution in the commercial aluminum alloy 5754. Simulations are performed to compare the predictive capability of the new hardening model against the common work hardening models using a rate-dependent plasticity formulation. The parameters in the numerical models are calibrated using the X-ray data published by Iadicola et al. (2008) [9] for the aluminum sheet alloy 5754. The predictions of the model for balanced biaxial tension and in-plane plane-strain tests are compared against experimental observations presented in Iadicola et al. (2008) [9]. It is concluded that the new model provides the best predictions of the large strain behavior of Aluminum sheet alloy 5754 subjected to various strain paths.     

Microstructural Aspects of Damage and Fracture in AZ31 Sheet Materials

There are considerable data in the literature dealing with deformation mechanisms in AZ31 sheets. However, there is little information on the damage and fracture processes in this material. In this contribution, digital image correlation is used to follow deformation patterns occurring during tensile and v-bending tests at room temperature. A variety of surface analysis techniques and three-dimensional x-ray tomography have been used to examine the relationship between deformation, damage initiation, and the final fracture processes. The results show that premature diffuse necking occurs in the tensile tests without transit into localized necking. Deformation twins cluster by an autocatalytic process to form shear bands serving as preferential sites for strain localization and crack initiation. Damage appears in the form of microcracks within the shear bands at a late stage of necking and lead to the final fracture. The presence and the distribution of second-phase particles and their distributions help accelerate the final fracture processes.     

Smart utilization of renewable energy sources in a microgrid system integrated with plug‐in hybrid electric vehicles

Mass roll‐out of plug‐in hybrid electric vehicles (PHEVs) and significant penetration of renewable energy sources in distribution system play a major role in delivering low carbon environment. However, placing and utilizing these units randomly result in overloading, increased power loss, and reduced voltage profile. This paper responds to these technical challenges by using a strategic placement method for locating the distributed generation (DG) and the charging station (CS) of PHEVs in a multi‐zone distribution system. For simultaneously scheduling of these units in each zone, the smart energy management framework is proposed in this paper. Apart from usual energy management constraints, this paper also incorporates the real‐time constraints involving the capacity of PHEV batteries, the mobility pattern, and the power level of the charging infrastructure. The simulation studies are carried out for each hour of a day. To cope with this time constraint execution, particle swarm optimization algorithm‐based approach is used. The proposed framework is tested in IEEE 33 and IEEE 69 bus radial distribution system. The obtained results imply that the presented energy management framework provides maximum profits for the vehicle owner, and meanwhile it fulfills preferences of the user in each zone simultaneously.     

Fluorimetric Nerve Gas Sensing Based on Pyrene Imines Incorporated into Films and Sub‐Micrometer Fibers

The chemical sensing of nerve gas agents has become an increasingly important goal due to the 1995 terrorist attack in a Tokyo subway as well as national security concerns in regard to world affairs. Chemical detection needs to be sensitive and selective while being facile, portable, and timely. In this paper, a sensing approach using a pyrene imine molecule is presented that is fluorimetric in response. The detection of a chloro‐Sarin surrogate is measured at 5 ppmv in less than 1 second and is highly selective towards halogenated organophosphates. The pyrene imine molecule is incorporated into polystyrene films as well as micrometer and sub‐micrometer fibers. Using both a direct drawing approach and electrospinning, micrometer and nanofibers can be easily manufactured. Applications for functional sensing micrometer and nanofibers are envisioned for optical devices and photonics in addition to solution and airflow sensing devices.     

Nonliposomal approach--a study of preparation of egg albumin nanospheres containing amphotericin-B

The stability of liposomes after introduction into the body is presently being discussed and needs thorough understanding. Hence, as a nonliposomal approach, egg albumin nanospheres were prepared by the pH-coacervation method, and a preliminary study was carried out of the influence of process variables on the size and shape of nanospheres by changing the pH of the albumin solution, concentration of albumin solution, and volume of cross-linking agent. The batch prepared with an albumin medium of pH 9, 2% concentration, and 100 μl of 4% glutaraldehyde-ethanol solution was found to have a spherical uniform shape with an average size of 497.6 nm. The ideal batch was loaded with the systemic antifungal drug amphotericin-B. Drug-loaded nanospheres were evaluated to study their in vitro release. They were found to exhibit a biphasic pattern with a cumulative percentage release of 97.7%.     

Effect of ash on maximum thickness of plastic layer of coals

A study of the effect of ash yield on the maximum thickness of the plastic layer (MTPL) of some coking coals (as measured by the Sapozhnikov plastometer) has revealed that with an increase in the former the latter in general decre?es. A rectilinear relation approximately exists between the ash percentage (dry basis) and log MTPL values of coals. For the samples studied, a multiple correlation incorporating the rank factor was found to be unnecessary. Higher Fe₂O₃ and SO₃ contents from the coal were found to be associated with higher MTPL values.     

Polarization-based compensation of astigmatism

One approach to aberration compensation of an imaging system is to introduce a suitable phase mask at the aperture plane of an imaging system. We utilize this principle for the compensation of astigmatism. A suitable polarization mask used on the aperture plane together with a polarizer-retarder combination at the input of the imaging system provides the compensating polarization-induced phase steps at different quadrants of the apertures masked by different polarizers. The aberrant phase can be considerably compensated by the proper choice of a polarization mask and suitable selection of the polarization parameters involved. The results presented here bear out our theoretical expectation.