Thermophysical properties of dielectric cermets of the Al2O3-Mo, -W, -Nb system

The thermophysical properties of dielectric cermets of the Al₂O₃-Mo, -W, -Nb system in the temperature range 50–1900°C were investigated. A semiempirical relation is used to correlate the experimental data.     

Radiological and angiocardiographical aspects of primary endocardial fibroelastosis in children (author's transl)

In this article we try to show the value of radiography and angiocardiography in primary endocardial fibroelastosis. The 20 CASEs studied in this report, were angiocardiographically and/or necropsically proved. In spite of different opinions, we think that it is possible to reach an approximate diagnosis of this condition if we use the clinical and angiohemodinamic examinations. On the other hand, it is necessary to point out that pathology is characteristic. The most important radiological signs were cardiomegaly, together with venocapilar congestion, both of variable magnitude, and dependent on the degree of cardiac insufficiency. By means of angiocardiography we could appreciate a great dilatation and hypertrophy of the left ventricle and a reduction of the mobility and distensibility of this cavity along the cardiac cycle.     

Herstellung und Charakterisierung von eiweißarmem zellstrukturiertem Material

Materials with cellular structure and a low protein content but a high pectin content have been prepared from apple parenchyma by simple procedures with only a few steps using small amounts of solvents. Materials with cellular structure from apple and a protein content less than 4% and a water-binding capacity higher than 80 g/g were obtained from the pressing residues of apple parenchyma by extraction at pH 8,4 to 9,1 and temperatures from 30 to 40° C, blanching in an aqueous environment, dehydration by ethanol and careful final thermal drying. Futhermore, additonal steps of alkaline deesterification and washing with acid were carried out for the preparation of samples with a low degree of esterification of the pectin component and a small content of ash. Such materials have a high content of free carboxyl groups (more than 1 mmol/g), but a reduced water-binding capacity.     

Zinc isotopic composition of particulate matter generated during the combustion of coal and coal + tire-derived fuels

Atmospheric Zn emissions from the burning of coal and tire-derived fuel (TDF) for power generation can be considerable. In an effort to lay the foundation for tracking these contributions, we evaluated the Zn isotopes of coal, a mixture of 95 wt % coal + 5 wt % TDF, and the particulate matter (PM) derived from their combustion in a power-generating plant. The average Zn concentrations and δ(66)Zn were 36 mg/kg and 183 mg/kg and +0.24‰ and +0.13‰ for the coal and coal + TDF, respectively. The δ(66)Zn of the PM sequestered in the cyclone-type mechanical separator was the lightest measured, -0.48‰ for coal and -0.81‰ for coal+TDF. The δ(66)Zn of the PM from the electrostatic precipitator showed a slight enrichment in the heavier Zn isotopes relative to the starting material. PM collected from the stack had the heaviest δ(66)Zn in the system, +0.63‰ and +0.50‰ for the coal and coal + TDF, respectively. Initial fractionation during the generation of a Zn-rich vapor is followed by temperature-dependent fractionation as Zn condenses onto the PM. The isotopic changes of the two fuel types are similar, suggesting that their inherent chemical differences have only a secondary impact on the isotopic fractionation process.     

Tensile performance and crack propagation of coated woven fabrics under multiaxial loads

The tensile performance of coated woven fabrics under multiaxial loads is examined in the present study. Two groups of experiments were conducted to investigate the influences of the configuration of the fabric specimen and the loading speed on the multiaxial tensile properties of the fabrics. The configuration of the specimen for the multiaxial tensile tests is identified as gear‐shape with large arm widths. A loading speed of lower than 20 mm/min is suggested to obtain the tensile properties of the coated woven fabrics under multiaxial loads. The tensile performances of coated woven fabrics under uni‐, bi‐, and multiaxial loads were compared. We found that the tensile performances under bi‐ and multiaxial loads are much better than those under uniaxial loads. Therefore, for the application of the coated woven fabrics in lightweight structures, biaxial or multiaxial loading conditions will be necessary. Experiments on the specimens with an initial crack in the center under multiaxial loads show that, by comparison with other loading directions, the tensile properties in warp direction of the coated woven fabrics play an important role in the failure performance and crack propagation under multiaxial loads. To eliminate the dependence on the mechanical properties in warp direction, the balance of the two principle directions of coated woven fabrics should be improved. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2009     

Optimization of stormwater filtration at the urban/watershed interface

Environmental pollution from cities is a major ecological problem attributed to contaminated runoff from nonpoint sources. The U.S. Environmental Protection Agency's guidance on implementation of total maximum daily loads (TMDL) does not adequately cover methods to improve waters impaired by nonpoint sources. To comply with TMDLs, cities may install filters in curb inlets, or use other Best Management Practices (BMPs). We tested 10 different filters and found their effectiveness in retaining pollutants ranged from 0 to >90%, depending on combinations of pollutant types (metals, pathogens, and total suspended sediments (TSS)) and filter materials. Hence, the decision to deploy filters into curb inlets must consider land use patterns associated with specific categories of pollutants generated within cities. We developed a geographic information system (GIS)-enabled model for estimating and mitigating emissions of pollutants from urban regions into watersheds. The model uses land use categories and pollutant loadings to optimize strategic placement of filters to accommodate TMDLs. For example, in a city where the landuse pattern generates 4 x 10(6) kg of TSS, 55 kg of Cd, and 2 x 10(3) kg of Zn per year into 498 curb inlets that discharge into a sensitive watershed, the optimized placement of 137, 92, and 148 filters can achieve TMDL endpoints for each pollutant, respectively. We show further that 158 strategically placed filters effectively meet the requirements simultaneously for all three pollutants, a result at least 5 times more effective than random placement of filters.     

Mitotic, but not meiotic, oriented cell divisions in rat spermatogenesis

The process of mammalian spermatogenesis involves both mitosis and meiosis at the same developmental age. Most previous studies have focused on mitotic spindle orientation during development, but not during meiotic division. Therefore, we asked whether there is a difference between mitotic and meiotic germ cell spindle orientation during rat spermatogenesis. Our results showed that mitotic spindles of spermatogonia were mainly oriented with angles ranging from 60 to 90 degrees, perpendicular in relation to the basement membrane of the seminiferous tubules. On the other hand, meiotic spindles showed a random orientation. Nocodazole treatment (at a concentration that depolymerizes only astral microtubules) induced a significant increase in cells with an angle between 0 and 30 degrees (parallel) in relation to the basement membrane. Meiotic spindles did not show a significant change in their orientation after the Nocodazole treatment. Therefore, our results suggest differences between the mechanisms controlling positioning and orientation of mitotic and meiotic spindles during rat spermatogenesis. It seems that a phylogenetically conserved programme controls the mitotic spindle orientation in organisms ranging from worms to mammals.