Apparatus and procedure for measuring release rates from formulations of lepidopteran semiochemicals

An apparatus was developed wherein a vacuum source was used to pull air across a controlled-release-formulation dispenser or a planchet containing a known quantity of a semiochemical and into a collector filled with a polymeric adsorbent. After a set time, the semiochemical was eluted with solvent and was quantified by gas-liquid chromatography (GLC). High percentages of known quantities of the lepidopteran semiochemicals (Z)-7-dodecen-l -ol acetate (Z7DDA), boiling point (bp) 275 ° C/1 atm, (Z)-9-tetradecen-1-ol formate (Z9TDF), bp 289 °C/1 atm, and (Z,Z)-3,13-octadecadien-1-ol acetate (ZZODDA), bp 490 °C/1 atm, were recovered. The semiochemicals did not oxidize and were recovered quantitatively from the adsorbent. The release rates of Z9TDF from a controlled-release dispenser were found to be directly proportional to the airflow rates. Release rate measurements on the Z9TDF dispensers were made for the purpose of estimating the method's precision. The method was shown to give internally consistent results by measurements on another Z9TDF formulation. The accuracy of the method is discussed.Mention of a commercial or proprietary product in this paper does not constitute an endorsement by the USDA.     

Necrodols: Anti-insectan terpenes from defensive secretion of carrion beetle (Necrodes surinamensis)

Two compounds recently isolated from the defensive gland ofNecrodes surinamensis, -and -necrodol, first representatives of a new category of monoterpenes (the necrodanes), are shown to be repellent to ants and other insects and irritating to cockroaches and flies. The compounds doubtless play a defensive role inNecrodes. The possible long-range applied significance of research on insect repellents is discussed.Paper No. 80 of the seriesDefense Mechanisms of Arthropods. Paper No. 79 is T. Eisner et al., Experientia 42:204–207 (1986).     

Strain-Induced Deformation in Magnesia–Alumina Layered Composites

Ceramic beams are induced in situ to form complex shapes at elevated temperature without the application of an external stress. This process has been demonstrated for thin alumina substrates coated with a layer of magnesia. The internal strain causing the substrates to deform at elevated temperature arises as a consequence of strain mismatch accompanying the penetration of the coating into the substrate. The magnitude of the deformation depends on the amount of coating applied, on the thickness of the substrate, on the density of the substrate, and on the temperature. During exposure of the beams to elevated temperature, the magnesia coating reacts with the alumina substrate to form the spinel phase; the resulting volume change accompanying the phase transformation is likely the predominant driving force for deformation.     

Surface properties of commercial polymer films following various gas plasma treatments

Surface properties of a number of commercial thermoplastic polymer films were investigated before and after brief exposures to RF induced, low temperature gas plasmas. Water wettability and adhesion of vapor deposited aluminum to thin films (8–12 micron) of polyethylene, polypropylene, polyester, polysulfone, polycarbonate, and polyvinylidene fluoride films were studied before and after treatments with oxygen, 96% CF₄/4% O₂, and helium plasmas. Treatment with oxygen plasmas showed the greatest change in water wettability for polyvinylidene fluoride and polypropylene films, while treatment with 96% CF₄/4% O₂ showed dramatic changes in wettability of polycarbonate, polysulfone, and polystyrene. Excellent adhesion of aluminium was found for polymers that had been previously exposed to gas plasmas.     

Laser Specular Reflectance and the Optical rms Roughness of Alumina

Using laser specular reflectance, the optical rms roughnesses (σ₀'S) of 42 polycrystalline aluminas (PCA's) were determined. From these conventional experimental results, a nomogram was constructed so that single grazing angle (α) measurements could be used to predict σ₀. Subsequently, the nomogram was reassessed using five commercially important PCA's and one single-crystal sapphire (SC). The outcomes were twofold: that this nomogram was valid for PCA's over the range of 0.28 σ₀ 0.10 μm, but that the nomogram was invalid for SC sapphire. When the conventional experimental method was compared with the nomogram method at three different single-angle values, a 1:1 correspondence was observed for α= 78°, 80°, and 82°. The present noncontact method is advocated for speed and cleanliness, particularly when a quality assurance method is desired.     

Determination of water in cooked cottonseed meats by a modified indirect conductivity method

Summary The modified indirect conductivities and oven-dry moisture percentages were determined on mine Samples of cooked cottonseed meats (1.8 to 13.9% water). Statistical treatment of the data yields the following results: (1) equation of the regression line, {fx177-1} (2) correlation coefficient, 0.998; (3) standard deviation from the regression line, 0.27% water. Ten replicate determinations made on each of two samples containing 2.7 and 7.7% water showed standard deviations of 0.07 and 0.08% water. These results show that the accuracy and precision of the modified indirect conductivity method are satisfactory for practical applications. For a consecutive series of determinations the average time required per determination was about 9 min. This time could be reduced to about 5 min. by using duplicate sets of stirring apparatus. Describes data obtained in research conducted cooperatively by the Cotton Research Committee of Texas and the Texas Engineering Experiment Station.     

Thermal degradation studies of several pyrrone films

The thermal degradation of several polyimidazopyrrolone (pyrrone) films was studied in air and in vacuum over the range of 100–1000°C. by thermogravimetric analysis (TGA), with the use of both isothermal heating and programmed heating rates of 2, 3, 5, and 7.5°C./min. At pressures of 10^?6 torr or less, maximum weight losses average 30% at 800°C. Rates of volatilization and activation energies were derived to provide comparison between these ladder-type polymers. Mass spectrometric analysis of the pyrolysis gases evolved under vacuum conditions showed that CO, CO₂, and H₂O were the primary volatile products and that they were formed throughout the period of weight loss. Approximate correlation between changes in weight and changes in the total pressure for the vacuum tests indicates that mass spectrometric results could provide quantitative as well as qualitative data. The importance of sample history prior to heating and of sample geometry in developing meaningful and reproducible TGA results is aptly demonstrated. The ability of these materials to absorb readily 5–7 wt.-% of water under ambient conditions and the effect of this property upon weight loss measurements are shown.     

Characteristics of the lipase from the mold,Geotrichum candidum: A review

The moldGeotrichum candidum produces an extracellular lipase, readily concentrated by removal of the culture medium in which the microorganism is grown. The lipase is characterized by a unique, but not absolute, specificity for fatty acids containingcis-9 orcis,cis-9, 12 unsaturation, hydrolyzing both regardless of position within the triglyceride molecule. The enzyme also hydrolyzescis-9-16∶1,cis,trans-9,12-18∶2,trans,cis-9,12-18∶2, palmitoyl oleate and cholesteryl oleate. Digested at comparatively slow rates are:trans,trans-9,12-18∶2, double bond positional isomers of 18∶1 (other thancis-9), stearolic acid, oleoylpalmitate, dilinoleoyl phosphatidyl choline, and saturated acids. The enzyme has an optimum pH of 8.2, and the lyophilized powder is extremely stable, retaining activity for at least eight years when stored at-20 C. A purification of 81-fold has been achieved. One of five papers presented in the Symposium “Microbial Lipolytic Enzymes,” AOCS Spring Meeting, New Orleans, April 1973. Scientific contribution 556, Agricultural Experiment Station, University of Connecticut, Storrs, Conn. 06268.     

High temperature swelling of coal/tetralin mixtures in a high pressure microdilatometer

High pressure microdilatometer experiments were performed on a subbituminous (Wyodak) and a bituminous (Illinois no. 6) coal in helium and hydrogen atmospheres with and without added tetralin. Wyodak coal samples showed no swelling but contractions ranging between 24 and 40 vol% upon heating at 20 and 100 °C min^{− 1} under helium or hydrogen pressures between 150 and 1000 psig (˜1.0–6.9 MPa). Under the same conditions, Illinois no. 6 coals displayed contractions (25–60 vol%) prior to swelling up to 117 vol%. Upon tetralin addition (at 35–190 wt% of the coal), Wyodak coal samples did not swell but showed an increasing contraction with increasing helium or hydrogen pressure due to a slight softening and fusion of the coal particles. In contrast, addition of tetralin at much lower concentrations (5–35 wt%) had a marked effect on the contraction and swelling behaviour of Illinois no. 6. A maximum swelling of 200 vol% was obtained at a tetralin addition of 30 wt%. The increased swelling results from more extensive softening and fusion of coal particles in the presence of tetralin. Both coals showed a decreasing char yield with increasing tetralin concentration. The substantially lower extent of interaction observed between Wyodak coal samples and tetralin compared to Illinois no. 6 coal can be attributed to the differences in pore structure and/or chemical constitution of the two coal samples. Examination of the resultant solids by optical microscopy revealed the microstructural changes produced by thermal treatment in dilatometer experiments.