Study of cation distribution for Cu–Co nanoferrites synthesized by the sol–gel method

Nano sized polycrystalline soft ferrite particles with composition Cu_1−xCo_xFe₂O₄ (x =0.1, 0.3, 0.5, 0.7, 0.9) were synthesized by the sol–gel technique. The existence of well-defined single cubic spinel structure was confirmed in all the samples by X-ray diffraction. The crystallite size found by XRD varied from 14.8 to 34.0 nm. The microstructure was also characterized by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). Slight expansion of the unit cell was detected with the increase of Cobalt concentration, which may be attributed due to larger ionic radius of Co²⁺. Lattice parameter ranged from 8.34 Å to 8.37 Å for Co²⁺ from 0.1–0.9. The distribution of cations amongst A- and B-sites of the lattice was estimated by X-ray diffraction by using the R-factor technique. The results showed that both Cu²⁺ and Co²⁺ ions occupy mainly the B-site while Fe³⁺ ions were equally distributed among A- and B-sites. The data obtained from cation distribution analysis was used to determine the magnetic moment for each sample and VSM studies were also carried out to validate these calculations. Magnetic measurements showed that the saturation magnetization (Ms) and coercivity (Hc) increased with increasing cobalt content.     

Structural modeling of petroleum fractions based on mixture viscosity and Watson K factor

Two procedures have been developed for structural modeling of petroleum fractions based on mixture viscosity and Watson K factor. The representative molecules of paraffinic, naphthenic and aromatic hydrocarbons, based upon Ruzicka’s structural model, have been determined for lube-oil cut SAE 10 from Tehran oil refinery. Unlike previous methods, the newly developed procedures do not require time-consuming and costly laboratory data such as true boiling point profile. Good agreement between predictions of the new models and experimental results has been observed. Moreover, the proposed methods take less run-time than previous models due to less experimental and computational complexities. The results indicate that Ruzicka’s procedure, based on vapor pressure, is only applicable for light hydrocarbon mixtures, while the new methods can be applied for structural modeling of a wide range of petroleum fractions. Furthermore, as a result of this study, the application of a vapor pressure constraint leads to a higher degree of accuracy than the earlier suggested constraint, partial pressure, by Ruzicka.     

On the dispersion of CNTs in polyamide 6 matrix via solution methods: assessment through electrical, rheological, thermal and morphological analyses

In this study, polyamide 6 (PA 6)/multi-walled carbon nanotube (MWCNT) nanocomposites were prepared by different solution methods based on phase inversion, drop-casting and simple evaporation processes. Optical microscopy and field emission scanning electron microscopy techniques were used to investigate the dispersion states of the nanotubes in PA 6 matrix. The results indicated that the dispersion state of MWCNTs in the nanocomposites prepared by the phase inversion-based method was better than those in the nanocomposites prepared by the other two methods. Electrical, rheological, differential scanning calorimetry and thermo-gravimetric analysis measurements showed that the PA 6/MWCNTs nanocomposites prepared by the phase inversion-based method had higher electrical conductivity, storage modulus, crystallization temperature and thermal stability in comparison with those prepared by the other two methods, attributed to the better dispersion state of MWCNTs. These results confirmed achievement of a good dispersion state of MWCNTs within PA 6 matrix by the phase inversion-based efficient approach.     

Flexible polymer composite electromagnetic crystals

The dielectric properties of a ceramic powder (BaTiO₃) filled thermoplastic elastomer (EPDM TPE) were investigated for use in a flexible electromagnetic crystal. Materials were produced that had a high dielectric constant (approximately 9) and low loss tangent (less than 0.01). Materials were extruded and injection molded so as to povide low‐cost processing. Mechanical and electromagnetic test results showed the effect of processing conditions on the final quality of the composite. The shear rate during processing and the number of mixing cycles were found to affect the final material characteristics significantly. An electromagnetic crystal woven from extruded rods showed good reflectivity in the 10–15 GHz region.     

Genome-Wide Investigation of Multifocal and Unifocal Prostate Cancer—Are They Genetically Different?

Prostate cancer is widely observed to be biologically heterogeneous. Its heterogeneity is manifested histologically as multifocal prostate cancer, which is observed more frequently than unifocal prostate cancer. The clinical and prognostic significance of either focal cancer type is not fully established. To investigate prostate cancer heterogeneity, the genetic profiles of multifocal and unifocal prostate cancers were compared. Here, we report observations deduced from tumor-tumor comparison of copy number alteration data of both focal categories. Forty-one fresh frozen prostate cancer foci from 14 multifocal prostate cancers and eight unifocal prostate cancers were subjected to copy number variation analysis with the Affymetrix SNP 6.0 microarray tool. With the investigated cases, tumors obtained from a single prostate exhibited different genetic profiles of variable degrees. Further comparison identified no distinct genetic pattern or signatures specific to multifocal or unifocal prostate cancer. Our findings suggest that samples obtained from multiple sites of a single unifocal prostate cancer show as much genetic heterogeneity and variability as separate tumors obtained from a single multifocal prostate cancer.     

Enhanced Catalytic,Antibacterial and Anti-cancer Activities of Erythromycin Capped Gold Nanoparticles

Journal of Inorganic and Organometallic Polymers and Materials - In this study, the nanosized spherical erythromycin capped gold nanoparticles (eryth-Au(0)NPs) were fabricated for the first time....     

Photocatalytic degradation of Basic Blue 41 dye under visible light over SrTiO3/Ag3PO4 hetero-nanostructures

In an attempt to develop nanostructured photocatalysts with high performance, SrTiO₃/Ag₃PO₄ hetero-nanostructures were successfully fabricated. The formed binary heterojunctions were composed of SrTiO₃ nanotubes prepared using liquid-phase deposition, and Ag₃PO₄ nanoparticles prepared using a sol–gel method. Synthesis details, including morphology, structure, and optical properties of the prepared photocatalysts, were characterized and comparatively discussed. The results showed that at an optimal ratio of SrTiO₃ to Ag₃PO₄ (20–80), the photocatalytic degradation of Basic Blue 41 under 80-min visible light irradiation is the maximum amount of 99%, which is about 4.4 and 1.5 times higher than that of pristine SrTiO₃ nanorods and Ag₃PO₄ nanoparticles, respectively. It can be due to the synergistic effect of two materials that provide high light absorption and charge carriers’ separation. Finally, a detailed possible mechanism for enhancing the photocatalytic activity of the SrTiO₃/Ag₃PO₄ hetero-nanostructures was proposed.     

Thermodynamic Equilibrium Analysis of Propane Dehydrogenation with Carbon Dioxide and Side Reactions

A thermodynamic analysis of propane dehydrogenation with carbon dioxide was performed using constrained Gibbs free energy minimization method. Different reaction networks corresponding to different catalytic systems, including non-redox and redox oxide catalysts, were simulated. The influences of CO₂/C₃H₈ molar ratio (1–10), temperature (700–1000 K), and pressure (0.5–5 bar) on equilibrium conversion and product composition were studied. In the presence of CO₂ with a molar ratio of CO₂/C₃H₈ = 1, the temperature of dehydrogenation can be 30 K lower than that of dehydrogenation in the presence of steam (H₂O/C₃H₈ = 1) and about 50 K lower than that of simple dehydrogenation without dilution to achieve 60% propane conversion. It was found that the occurrence of dry reforming of propane and coke-forming side reactions could strongly impact the equilibrium product composition of the multireaction system and, therefore, these reactions should be kinetically controlled. Comparison of the simulated reactant conversions with those reported in the literatures revealed that the experimental conversion levels of propane are far below the corresponding equilibrium values due to rapid catalyst deactivation by coke, implying that research efforts should be directed toward formulation of more active and selective catalysts.     

STRUCTURAL DETERMINATION OF TITANIUM-OXIDE NANOPARTICLES BY X-RAY ABSORPTION SPECTROSCOPY

As a potential application of titanium-oxide nanoparticles, it is extremely important to investigate a detailed picture of the surface and interior structural properties of nanocrystalline materials, such as rutile and anatase with diameters 7.0 and 4.5nm, respectively. X-ray absorption spectroscopy has been used to identify the local Ti environment and related electronic structure. We combine the experimental results at the Ti edge in both bulk and nano-crystals to determine the lattice distortion in terms of differently characteristic preedge features and the variation in the multiple-scattering region of X-ray absorption near-edge structure (XANES) spectra. The relationship between the transition peaks and the surface-to volume ratio is also discussed.     

Preliminary Structural Data Revealed That the SARS-CoV-2 B.1.617 Variant's RBD Binds to ACE2 Receptor Stronger Than the Wild Type to Enhance the Infectivity

The evolution of new SARS-CoV-2 variants around the globe has made the COVID-19 pandemic more worrisome, further pressuring the health care system and immunity. Novel variations that are unique to the receptor-binding motif (RBM) of the receptor-binding domain (RBD) spike glycoprotein, i. e. L452R-E484Q, may play a different role in the B.1.617 (also known as G/452R.V3) variant's pathogenicity and better survival compared to the wild type. Therefore, a thorough analysis is needed to understand the impact of these mutations on binding with host receptor (RBD) and to guide new therapeutics development. In this study, we used structural and biomolecular simulation techniques to explore the impact of specific mutations (L452R-E484Q) in the B.1.617 variant on the binding of RBD to the host receptor ACE2. Our analysis revealed that the B.1.617 variant possesses different dynamic behaviours by altering dynamic-stability, residual flexibility and structural compactness. Moreover, the new variant had altered the bonding network and structural-dynamics properties significantly. MM/GBSA technique was used, which further established the binding differences between the wild type and B.1.617 variant. In conclusion, this study provides a strong impetus to develop novel drugs against the new SARS-CoV-2 variants.