Interference estimation with applications to blind multiple-accesscommunication over fading channels

We consider the detection of nonorthogonal multipulse signals on multiple-access fading channels. The generalized maximum-likelihood rule is employed to decode users whose complex fading gains are unknown. We develop geometrical interpretations for the resulting detectors and their corresponding asymptotic efficiencies. The generalized maximum-likelihood detection rule is then applied to find a matched subspace detector for the frequency-selective fading channel, under the assumption of a short coherence time (or long coherence time without the computational power to track the fading parameters). We propose blind implementations of these detectors for nonorthogonal multipulse signaling on both frequency-nonselective and frequency-selective multiple-access fading channels. These blind detectors extend the results of Wang and Poor (see ibid., vol.44, p.677-89, 1998) to multipulse modulation and fast frequency selective fading. For comparison, the minimum mean-squared error decision rules for these channels are derived and blind implementations of their corresponding detectors are developed     

Results from the operation of a semi-technical test plant for brown coal hydrogasification

The Rheinische Braunkohlenwerke AG has built and has been operating a semi-technical pilot plant for hydrogasification of coal in fluidized bed. The objective is to develop a coal gasification process with hydrogen for producing directly substitute natural gas. Between 1976 and 1982, the semi-technical pilot plant was operated for about 27000 h under test conditions, more than 12000 h of which were under gasification conditions. During this time, approximately 1800 metric tons of dry coal were gasified. The longest coherent operational phase under gasification conditions was 748 h in which 86.4 metric tons of dry lignite were gasified. Carbon gasification rates up to 82% and methane contents in the dry raw gas (free of N₂) up to 48 vol% were obtained. A detailed evaluation of the test results provided extensive information on the influence of operational parameters on the efficiency dates of the gasifier. Moreover, several components were tested for which no operational experience had previously been gained; these were newly developed devices, e.g. the inclined tube for feeding coal into the fluidized bed. Within the framework of scale-up to large-scale coal gasification plants, a pilot plant having a capacity of about 10 metric tons of dry brown coal per hour was commissioned in late 1982. On May 30, 1983, coal was for the first time fed into the plant. The present test planning provides for tests with brown coal till the end of 1985. This could be followed by the use of other coals, such as hard coal.     

Electron transfer proteins from the haloalkaliphilic archaeon Natronobacterium pharaonis: possible components of the respiratory chain include cytochrome bc and a terminal oxidase cytochrome ba3

Natronobacterium pharaonis, an aerobic haloalkaliphilic archaebacterium, expresses high concentrations of redox proteins as do alkaliphilic eubacteria. The first redox protein characterized from N. pharaonis was halocyanin [Scharf, B., & Engelhard, M. (1993) Biochemistry 32, 12894-12900], a small blue copper protein. It is a peripheral membrane protein and is conjectured to function in a manner similar to plastocyanin. In the present work, the respiratory chain is further elucidated and the purification and characterization of the most abundant components cytochrome bc and cytochrome ba3 from the membrane fraction are described. The cytochrome bc complex consists of a 14 and an 18 kDa subunit in a 1:1 ratio, with heme c bound to the larger polypeptide. An Fe-S subunit similar to that found in eukaryotic bc complexes has not yet been identified. The second membrane complex carries two different heme groups of the ba3-type as well as copper. It contains two subunits of 36 and 40 kDa. This cytochrome ba3 binds carbon monoxide, a feature common to terminal oxidases. There is no spectroscopic evidence for a second terminal oxidase; hence, under the growth conditions chosen the respiratory chain of N. pharaonis appears to be unbranched. In addition to these cytochromes, a succinate dehydrogenase which is solubilized from the membrane by detergents was isolated. A cytochrome c which was isolated from the cytosol has an unusually high molecular weight and a redox potential of -142 mV. A second cytosolic protein, ferredoxin, was purified to homogeneity. A comparison of the redox potentials of the isolated proteins with those obtained from the native membrane allows the construction of a possible electron transfer chain.     

On the role of the olivocochlear bundle in hearing: 16 case studies

Earlier we presented data (Scharf et al. (1994) Hear. Res. 75, 11-26) from a young patient (S.B.) who had undergone a vestibular neurotomy, during which the olivocochlear bundle (OCB) was severed. Those data are complemented by measurements on 15 other patients-some like S.B. with normal audiometric thresholds, none with a loss greater than 35 dB at experimental frequencies. Comparisons of performance for the same ear before and after surgery or between the operated and healthy ears do not provide evidence that the lack of OCB input impairs the following psychoacoustical functions: (1) detection of tonal signals, (2) intensity discrimination, (3) frequency selectivity, (4) loudness adaptation, (5) frequency discrimination within a tonal series, (6) in-head lateralization. Data on single-tone frequency discrimination are equivocal. These mostly negative results apply to listening both in the quiet and, where relevant, in noise. The only clear change in hearing after a vestibular neurotomy is that most patients detect signals at unexpected frequencies better than before. This change suggests an impaired ability to focus attention in the frequency domain. Although limited in scope, our finding that human hearing without OCB input is essentially normal agrees with much of the relevant literature on animal behavior and with the patients' self-reports.     

Effect of beta-carboline-3-carboxoylate-t-butyl ester on ventilatory control

beta-carboline-3-carboxylate-t-butyl ester (beta CCT) is the most selective antagonist for the alpha 1 beta 2 gamma 2 benzodiazepine (BZ) receptor subtype which blocks anticonvulsant and antipunishment (anxiolytic) but not sedative and myorelaxant effects of diazepam. We sought to determine whether the alpha 1 beta 2 gamma 2 BZ receptor subtype modulates ventilation and whether beta CCT antagonizes respiratory depressant effects of BZ's. Room air (RA) ventilation and the ventilatory response to 6% & 12% CO2 were non-invasively assessed by barometric plethysmography in 30 gm mice, n = 11. Plethysmograph signal amplitude (AMP), respiratory rate (RR) and minute ventilatory effort (MVE = AMP*RR), were measured. Runs were performed pre-drug & after IP injection of saline, vehicle for beta CCT, beta CCT (60mg/kg), midazolam (10mg/kg), and midazolam followed by beta CCT. Compared with pre-drug value, midazolam depressed MVE during RA and CO2 stimulation (% of pre-drug value: RA:57.7 +/- 17.4%, 6% CO2:53.73 +/- 14.3%, 12% CO2:69.1 +/- 26.1%, p < .0001, ANOVA). Subsequent beta CCT partially reversed this depression during RA conditions (72.8 +/- 25.7% of pre-drug value, p < .03 compared with midazolam) and 6% CO2 stimulation (67.1 +/- 10.7% of pre-drug value, p < .006 compared with midazolam) but not with 12% CO2. Thus, the alpha 1 beta 2 gamma 2 BZ receptor subtype modulates ventilation and beta CCT partially antagonizes respiratory depressant effects of BZ's.     

Beamforming, diversity, and interference rejection for multiuser communication over fading channels with a receive antenna array

We consider M-ary communication with K users over a space diversity channel, consisting of a single transmit antenna for each user and multiple receive antennas. We examine two different flat fading models, namely, phase coherent wavefront fading and noncoherent element-to-element fading. In the case of wavefront fading, the fade is constant across the face of the receive antenna and we can associate an angle of arrival to the signal. We present a variation of the MUSIC algorithm for estimating this parameter and use it to form a spatial beam. In the case of noncoherent element-to-element fading, the fading path to each sensor is different (although possibly correlated) and no angle of arrival can be exploited for conventional beamforming. For each channel model, we develop several detection strategies which assume various amounts of prior information about the fading. We then consider blind extensions of these detectors based on subspace tracking, which do not require a prior model for the interfering users' signals.     

Two-dimensional modal analysis based on maximum likelihood

The authors present a method for estimating the parameters of 2-D damped harmonic (modal) signals in additive Gaussian noise. This method applies in the cases of single or multiexperiment data and incoherent or coherent signals. Both synthesis and analysis models for the data are developed. Central to these models are the signal and orthogonal subspaces. Under the assumption of distinct modes in one of the two dimensions, there exists an invertible function between the parameters of these two subspaces. This function can be used to express the optimization problem given by maximum likelihood in terms of the orthogonal subspace. The resulting problem can be solved by any of several methods, including total least squares and iterative quadratic maximum likelihood (IQML)     

Sources and behaviour of bismuth active substances (BiAS) in a municipal sewage treatment plant

Non-ionic surfactants are widely used for household and industrial purposes. For different reasons the metabolites, e.g. 4-nonylphenol, nonylphenol monoethoxylate, nonylphenol diethoxylate and 4-tert-octylphenol, are especially considered to be endocrine disruptive and thus potentially harmful for the environment. In this study, field samples of raw wastewater from different point sources, including industrial effluents, household effluents, the influent and secondary effluent of a wastewater treatment plant that treats this wastewater were monitored simultaneously. Composite samples were taken five times over periods of 1 week at nine sample sites. The results showed that the concentrations and fluxes were varying. In addition industrial, influent and effluent samples were investigated for nonylphenol (NP). The highest concentrations of bismuth active substances (BiAS) were obtained by wastewater samples from a chemical and a cloth washing company ranging from 10,200 to 65,600 microg/l and 14,600 to 33,900 microg/l BiAS, respectively. Although the concentration of BiAS in the wastewater of the paper production was only between 460 and 1200 microg/l BiAS, the NP/BiAS ratio of 0.51% was considerably higher than in other industrial effluents. The BiAS concentration in wastewater samples from households ranged from 2200 to 7900 microg/l BiAS, but the NP concentration was quite low, 0.01% of BiAS. This could be due to the effort within the EU to phase out nonylphenol polyethoxylates in household detergents. Influent concentrations between 700 and 2200 microg/l BiAS with removal rates in the WWTP ranging from 70.7 to 99.4% with an average of 92.2% could be measured.     

A process and load adjusted coating system for metallic inserts in hybrid composites

According to the concept of an intrinsic hybrid composite, adhesive bonding is designed for generating the connection between the applied fiber reinforced polymer and a metallic insert. To induce adhesive bonding, a metallic insert, made of aluminum, is coated. This contribution focusses on the development of a suitable coating system. To this end, the coating system must meet certain requirements. On one hand, demands on the coating like ductility can be deduced from analyzing the manufacturing process. On the other hand, requirements like corrosion protection as well as high static and dynamic strength arise from specific applications under considerations. The utilized coating system is based on organically modified silicate layers (Ormosil) applied using a sol–gel process. To prove that this coating system fulfils the requirements, the corrosion protection is analysed by impedance spectroscopy. Furthermore, different mechanical experimental investigations are performed to verify the ductility of the coating as well as the strength of the resulting interface. Hence, it is shown that the considered coating system can be applied for the analysed intrinsic hybrid composite manufactured in series.