Preliminary Results of IS Plasma Focus as a Breeder of Short-Lived Radioisotopes 12C(d,n)13N

Modified IS (Iranian Sun) plasma focus (10 kJ,15 kV, 94 ??F, 0.1 Hz) has been used to produce the short-lived radioisotope ¹³N (half-life of 9.97 min) through ¹²C(d,n)¹³N nuclear reaction. The filling gas was 1.5?C3 torr of hydrogen (60%) deuterium (40%) mixture. The target was solid nuclear grade graphite with 5 mm thick, 9 cm width and 13 in length. The activations of the exogenous target on average of 20 shots (only one-third acceptable) through 10?C13 kV produced the 511 keV gamma rays. Another peak found at the 570 keV gamma of which both was measured by a NaI portable gamma spectrometer calibrated by a ¹³⁷Cs 0.25 ??Ci sealed reference source with its single line at 661.65 keV and ²²Na 0.1 ??Ci at 511 keV. To measure the gamma rays, the graphite target converts to three different phases; solid graphite, powder graphite, and powder graphite in water solution. The later phase approximately has a doubled activity with respect to the solid graphite target up to 0.5 ??Ci of 511 keV and 1.1 ??Ci of 570 keV gamma lines were produced. This increment in activity was perhaps due to structural transformation of graphite powder to nano-particles characteristic in liquid water.     

Magnetic field analysis of a 9–6 without permanent magnet brushless DC motor by using 3-D finite element method

This paper presents characteristic analysis of without permanent magnet brushless DC (WPMBLDC) motor by using three-dimensional (3-D) finite element method (FEM). The paper describes the complex magnetic structure and principle of the presented WPMBLDC motor in detail. The magnetic field distribution of the presented motor is numerically computed by 3-D FEM. The primary characteristics of the motor including magnetic flux density, flux linkage and inductance profile are obtained. A prototype WPMBLDC machine has also been built and tested; additionally, the accuracy of 3-D FE analysis is verified by comparing the calculated results with the experimental measured values.     

Preparation of voltammetric biosensor for tryptophan using multi-walled carbon nanotubes

Multi-walled carbon nanotubes (MWCNTs) were grown by chemical vapor deposition. The effect of the composition of carbon paste electrode on its voltammograms was evaluated in basic solution with 5.0×10⁻⁵ M tryptophan (Trp). It was found that addition of MWCNTs to the carbon paste would generate the peak current of Trp because of its catalytic effect on the redox process. The pH strongly affects the peak potential of Trp. The best analytical response was obtained at pH 13.0. The anodic peak currents were proportional to Trp concentrations in the range of 1.0×10⁻⁹−1.0×10⁻⁴ M under the optimized experimental conditions. The detection limit was 2.2×10⁻¹⁰ M. The effect of potential scan rate on the peak potential and peak current of tryptophan was investigated. The correlation of the peak currents against v^1/2 (v is the scan rate) is linear, which is very similar to a diffusion-controlled process. The proposed biosensor was applied to the determination of Trp in pharmaceuticals formulations successfully.     

Kinetics of Dehydration of Green Alfalfa

ABSTRACT

Artificial drying is an important step in processing of green crops in order to preserve their freshness and nutrients for longer time at relatively lower costs. Forage crops, tea and tobacco are the major green crops where the commercial drying is a major operation in their processing. Fresh green alfalfa at about 75 to 80% moisture is subjected to drying in different types of dryers.ln the case of alfalfa, the raw material consists of leaves, stems, chops and fine stems, each varying distinctly in their physical and structural characteristics. The moisture content is reduced from initial level to about 10%. The drying air temperatures range from 40 b 800°C; the lower temperatures are used inconveyor dryers whereas high temperatures are used in rotary drum drycn.The results on drying behavior, and changes in physico-chemical propedes during drying for components of green alfalfa over the temperature range of 40 m 800°C are presented in this paper. The optimum temperature for drying from the stand point of color and protein solubility was found to be 175°C.     

The Design and Preparation of a Simulator for the Water Coning Phenomenon Applying in Fractured Reservoirs

Abstract

The problem of water production is one of the major technical, environmental, and economical issues associated with oil and gas production. The main goal of this study is to prepare a reservoir numerical simulator with emphasis on water coning. The study mostly involves the numerical simulation of water coning and includes proposed correlations in the literature. The computer program included four distinct modules to calculate: critical or maximum allowable oil rate, water breakthrough time, well performance after water coning take palaces, and water coning simulation. Flow equations of water and oil were discretized and numerically solved for two-dimensional coordinates. The implicit scheme was used to calculate unknown pressures of any grid block. For calculation of water saturation, explicit scheme was used. Real field data of a well in southwest Iran was put into the program and critical rate, water breakthrough time, well performance after water coning, and water coning simulation of reservoir were determined. The authors found that the results of correlations are very far from the reality. On the other hand, numerical simulation shows good agreement with real production data. In addition, it was observed that the present production rate of this well would result in rapid water coning.     

Performance of a solar liquid desiccant air conditioner – An experimental and theoretical approach

In this paper the results of testing a solar liquid desiccant air conditioner (LDAC) in the tropical climate of Queensland, Australia have been presented. The system uses polymer plate heat exchanger (PPHE) for dehumidification/indirect evaporative cooling, and a cooling pad as the direct evaporative cooler for the dry air leaving the PPHE. Lithium chloride, which is an effective desiccant in air dehumidification, was used in the experiments and a scavenger air regenerator concentrates the dilute solution from the dehumidifier using hot water from flat plate solar collectors. The data obtained from performance monitoring of the solar LDAC operating on a commercial site in Brisbane was compared with a previously developed model for the PPHE. The comparison reveals that good agreement exists between the experiments and model predictions. The inaccuracies are well within the measuring errors of the temperature, humidity and the air and solution flow rates. The above tests further indicate a satisfactory performance of the unit by independently controlling the air temperature and humidity inside the conditioned space.

In order to prevent carryover of the solution particles into the environment, eliminators are used at outlet of the absorber unit and the regenerator. An alternative method in preventing the carryover is the use of indirect cooling, in which the supply air does not contact the solution. The method can be used to produce potable water from the atmospheric air in remote areas.

The liquid desiccant system can be used in the HVAC industry, either as a packaged roof-top air conditioner, or as an air handler unit for commercial applications. The system could also be used for space heating in winter due to the property of desiccants to provide heat when wetted.     

Masculine gender roles and counseling-related variables: Links with and mediation by personality.

The authors examined the overlap of masculine gender-role conflict and stress with personality, as organized in the 5-factor model (FFM), in a sample of 300 college men. Using a subset (n?=?173) of the total sample, the authors also revisited previously established relations of masculine gender-role conflict and stress with several counseling-related variables; there was a specific focus on the mediational role of personality in these relations. Results indicated that personality and masculine gender-role variables had 60% overlapping variance and that personality mediated 94% of the significant relations between masculinity and counseling-related variables. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Multi-pressure absorption cycles in solar refrigeration:: A technical and economical study

A technical and economical study of regenerative absorption chillers with multi-pressure cycle has been undertaken as solar operated refrigeration systems. Referred to as advanced absorption chillers they represent one of the new technology options that are under development. Advanced absorption cooling technology offers the possibility of chillers with thermal COPs of 1.5 or greater at driving temperatures of 140°C, which reduces the collector area and the heat rejection requirements compared to current absorption cooling technology. Two different absorption systems have been considered. The first is an advanced, double-effect regenerative absorption cooling system, driven at 140°C, whose efficiency is about 55% of the Carnot efficiency. The second is an ideal, single-effect regenerative absorption system that achieves 70% of the Carnot efficiency driven at 140°C or 200°C. To evaluate the solar performance of a thermally driven chiller requires a separate analysis of the solar availability for a given location compared to the required monthly average solar input. In this analysis different systems, including the vapour compression chillers, have been compared in terms of the thermal and electrical energy input. An effective electrical COP may be computed assuming that the ratio of electrical energy cost to thermal energy cost is four, which is typical of today’s fossil fuel costs. The effective electrical COPs of different technical options can then be compared. Those systems with higher electrical COPs will have lower energy costs. If solar is to be competitive, then the cost of delivered solar thermal energy should be less than the cost of delivered fossil thermal energy.     

Electrical, structural and optical properties of fluorine-doped zinc oxide thin films: Effect of the solution aging time

In this paper ageing effects of the solution used to prepare fluorine-doped ZnO films by the spray pyrolysis technique were investigated, concerning its role on the structure, the electrical and optical properties of films produced. The data reveal that the sheet resistance of the ZnO:F thin film decreases with the age of the solution used, reaching a minimum of 24 Ω/□, after 15 days. On the other hand the optical transmittance increases for films deposited using 6 days aging solution, decreasing afterwards as the aging time increases, being the optical transmittance in the visible range below 55%, for films deposited from solutions 36 days in age. The X-ray diffraction spectra show that the aged films are polycrystalline in nature with a [100] predominant orientation. The data also show that the intensity of (100) peak increases as the time of solution age increases, which is related to an improvement of the film crystallinity.