Beam test of the CsI(Tl) calorimeter for the BELLE detector at the KEK-B factory

We studied the performance of a prototype electromagnetic calorimeter for the BELLE detector at the KEK proton synchrotron for an energy range of 0.25–3.5 GeV. The prototype consisted of an array of 6 × 5 CsI(Tl) crystals with 30 cm length (16.2 radiation lengths) and about 6 cm × 6 cm cross section. The scintillation light of each CsI(Tl) crystal was read out by two large-area PIN photodiodes and charge-sensitive preamplifiers attached at the rear face of the crystal. We measured the energy and position resolution for electrons and the e/π separation for two sets of matrix configurations: one corresponded to the center and the other to the edge of the barrel calorimeter. The overall performance measured by the test proves that the prototype calorimeter is satisfactory for the use in the BELLE detector.     

稀土Si_3N_4陶瓷材料中铝的络合滴定法测定

提出了强碱介质沉淀钇及有关杂质元素而与铝进行分离的方法。试液酸化后采用ＮａＦ析出法络合滴定测定铝。     

黄河中游多沙粗沙区水沙控制途径的探讨

根据黄河中游多沙粗区暴雨洪水及产流产沙特点，提出了为控制水沙危害，黄河中游治理应分两步走的战略。第一步解决近期水沙控制和耕地问题，主要措施是建设淤地坝和骨干坝。研究表明，在现状坝地，梯田条件下，为满足粮食生产需要，每平方公里需新增坝地３．１８ｈａ，且能港口控制水沙的要求。第二步是进行坡面治理，改善生态环境，以达到根治水沙的目的。     

Influences of artificial pre-stressing on ply stresses and tensile properties of Vinylon fibre-reinforced aluminium laminates (VIRALL)

A simple micromechanical model based primarily upon the rule-of-mixtures is developed which allows prediction of the effects of fibre preload on the ply stresses (i.e., the initial residual stresses of fibre, adhesive and matrix) induced within VIRALL laminates, and the tensile stress-strain curves and mechanical properties of VIRALL laminates. The analysis of the ply stresses of VIRALL laminates indicates that pre-stressing will dramatically influence the ply stresses. The predicted tensile stress-strain curves of VIRALL laminates are in good agreement with the experimental curves and the results show that the stress-strain curves of VIRALL laminates move upwards when the prestress increases. The predicted tensile mechanical properties of VIRALL laminates at room temperature show good agreement with those obtained experimentally; both show that prestress can improve the tensile properties (i.e., elastic limit strength, 0.2% yield strength and failure strength) of VIRALL laminates.     

在（311）面上所生长的Al_xGa_（1－x）As／GaAs单量子阱特性

文章报道了用分子束外延（ＭＢＥ）法在６００℃和６５０℃下，在Ｓｉ掺杂的ＧａＡｓ衬底的（３１１）Ａ和（３１１）Ｂ面上成功地生长了高质量的ＡｌｘＧａ１－Ａｓ／ＧａＡｓ单量子阱材料。计算了光荧光（ＰＬ）峰值能量，并与实验作了比较。讨论了（３１１）Ａ和（３１１）Ｂ面上的不同生长特性。     

超辐射发光二极管的结构特性及其应用

近几年来,由于超辐射发光二极管在光纤陀螺和光时域反射仪等方面的重要应用,已引起了人们的极大关注,许多国家都在竞相研制和开发.本文综述了目前超辐射发光二极管的主要结构和特性及其应用前景.     

The effects of plasma etching induced gate oxide degradation onMOSFET's 1/f noise

The effects of the plasma etching process induced gate oxide damages on device's low frequency noise behavior are investigated on MOSFET's fabricated with different field plate perimeter to gate area ratio antennas. Abnormal 1/f noise spectrum with a shoulder centered in the frequency range of 100 and to 1 kHz was frequently observed in small geometry devices, and it is attributable to a nonuniform distribution of oxide traps induced by plasma etching process     

HT－7托卡马克的八管弹丸注入器

介绍了用于ＨＴ－７托卡马克的的八管弹丸注入器的物理、工程设计原理和结构特点及配置的各种诊断手段。注入器采用气动发射技术，弹丸为１ｍｍ×１ｍｍ，１．２ｍｍ×１．２ｍｍ，１．５ｍｍ×ｌ．５ｍｍ圆柱体氢丸，丸速０．８～１．５ｋｍ／ｓ工作频率１～８Ｈｚ。