Study of cation distribution for Cu–Co nanoferrites synthesized by the sol–gel method

Nano sized polycrystalline soft ferrite particles with composition Cu_1−xCo_xFe₂O₄ (x =0.1, 0.3, 0.5, 0.7, 0.9) were synthesized by the sol–gel technique. The existence of well-defined single cubic spinel structure was confirmed in all the samples by X-ray diffraction. The crystallite size found by XRD varied from 14.8 to 34.0 nm. The microstructure was also characterized by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). Slight expansion of the unit cell was detected with the increase of Cobalt concentration, which may be attributed due to larger ionic radius of Co²⁺. Lattice parameter ranged from 8.34 Å to 8.37 Å for Co²⁺ from 0.1–0.9. The distribution of cations amongst A- and B-sites of the lattice was estimated by X-ray diffraction by using the R-factor technique. The results showed that both Cu²⁺ and Co²⁺ ions occupy mainly the B-site while Fe³⁺ ions were equally distributed among A- and B-sites. The data obtained from cation distribution analysis was used to determine the magnetic moment for each sample and VSM studies were also carried out to validate these calculations. Magnetic measurements showed that the saturation magnetization (Ms) and coercivity (Hc) increased with increasing cobalt content.     

Determining the mechanical properties of epoxy resin (DGEBA) composites by ultrasonic velocity measurement

In this study, the composites of diglycidyl ether of bisphenol A (DGEBA) epoxy resin that have been formed by mixing epoxy resin with allyl glycidyl ether (AGE) and 2,3‐epoxypropyl methacrylate [glycidyl methacrylate (GMA)] were prepared in weight % ratios of 90 : 10, 80 : 20, and 70 : 30. A computer controlled analyzer with 35 MHz and a digital oscilloscope with 60 MHz were used for measuring the velocities of ultrasonic wave. The measurement of ultrasonic velocity carried out by pulse echo method at frequencies of 2.25 and 3.5 MHz at room temperature. The values of acoustic impedance (Z), Poisson ratio (μ), and coefficients of elasticity (L, G, K, E) of composites were calculated by values of densities and velocities that obtained. Thus, the effect of modificating epoxy resin (DGEBA) by AGE and GMA on mechanical properties of DGEBA was investigated using the ultrasonic method. Atomic force microscopy has been used for determining the microstructure of composites. By the results obtained from the investigation, it have been established that the longitudinal and shear ultrasonic wave velocities, and the values of all the elasticity constants of DGEBA were increased by modification with AGE and GMA. Also the most suitable combination ratio for the compound of DGEBA : AGE and DGEBA : GMA has been found as 80 : 20. © 2012 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2013     

(R/S)‐BINOL‐α‐Phosphoryloxy Enecarbamate‐Mediated and (R/S)‐Titanium(IV) BINOLates‐Catalyzed Enantioselective Intramolecular Heck/Aza‐Diels–Alder Cycloaddition (IHADA): An Expedient Methodology

An (R/S)‐titanium(IV) BINOLate‐catalyzed highly enantioselective intramolecular Heck/aza‐Diels–Alder cycloaddition (IHADA) cascade was developed to prepare tetrahydropyridoindoles (tHPs) and octahydropyrazinopyridoindoles (oHPPs) from in situ generated (R/S)‐BINOL α‐phosphoryloxy carbamate ( αPPC2 ) in one pot. Chiral cooperativity between (R/S)‐αPPC2 and (R/S)‐titanium(IV) BINOLate was observed and successfully utilized for the construction of various tHPs (7 examples) and oHPPs (17 examples).

     

Compositional studies: antioxidant and antidiabetic activities of Capparis decidua (Forsk.) Edgew

Capparis decidua is one of the traditional remedies used for various medicinal treatments in Pakistan. This study presents the determination of proximate composition, amino acids, fatty acids, tocopherols, sterols, glucosinolate and phenolic content in extracts obtained from different aerial parts of C. decidua, as well as their antidiabetic and antioxidant activity. All examined extracts were prominently rich in phenolics and glucosinates, and they showed potent antidiabetic and antihemolytic activity. The present study could be helpful in developing medicinal preparations for the treatment of diabetes and related symptoms.     

Integrated design of diesel hydrotreating processes

This work presents an integrated approach for the design of diesel hydrotreating processes employing a simulated annealing optimisation algorithm. The modelling of reactor, separation and heat recovery system for diesel hydrotreating processes is discussed, and a novel optimisation framework is developed for the design of complex refinery processes. A comparison with conventional approach to process design, i.e. sequential evolution of design, is given to illustrate the ability of proposed approach to obtain overall hydrotreating process designs with minimum total annualised costs. The proposed integrated approach takes into account the trade-offs between capital and operating costs, as well as interactions between the hydrotreater, distillation column, and the associated heat exchanger network.     

FTIR-ATR studies of diffusion and perturbation of water in polyelectrolyte thin films. Part 4. Diffusion, perturbation and swelling processes for ionic solutions in SPEES/PES membranes

We report diffusion rates and equilibrium concentrations of water in a polyelectrolyte SPEES/PES film using ATR/FTIR spectroscopy. The data for water obtained by fitting spectral intensities to a dual mode diffusion model in the presence of different counter ions (at 0.2 mol dm⁻³) follow the order Li⁺>Cs⁺>Na⁺>Ca²⁺>K⁺. Diffusion is progressively slower for higher concentrations of NaCl (0.2-0.85 mol dm⁻³) and the NO₃⁻ counter anion leads to a faster diffusion rate than for Cl⁻ at the same concentration. Both water uptake and diffusion rates are broadly consistent with expectations based on the differential degrees of swelling, caused by changes in the SO₃⁻/SO₃⁻ interpolymer chain repulsive forces leading to a decrease in volume diffusion compared with the value for pure water. Direct spectral measurements of the degree of swelling confirm that the process does occur, although the order of the swelling amounts does not map directly onto that of the diffusion rates. This is probably because the interfacial dissociation processes are hydration dependent.     

十六烷基三甲基季铵阳离子改良二氧化硅对酸性染料的吸着

The sorption behavior of acid dyes onto cetyltrimethylammonium bromide (CTAB)-modified silica as a function of pH in the aqueous medium was studied. Single-and multi-solute sorption equilibria of orange Ⅱ（OR), phenol red (PR) and Eriochrome Black T (EBT) were studied at pH 3, unbuffered water pH and pH 11. Sorption behavior of EBT could not be conducted at pH3 due to its aggregation in acidic medium. All the reaction conditions, experimental protocols and techniques remained the same throughout the sorption process. Sorption isotherms for single-solute system were fitted by the Langmuir model, while Langmuir competitive model (LCM) and the ideal adsorbed solution theory (IAST) coupled with Langmuir model (IAST/Langmuir) were used for the prediction of multisolute competitive sorption. Sorption affinities influenced by the factors like physical interactive forces between the molecules of CTA on silica and sorbate, structural limitations of the dyes based on their geometrical arrangement were investigated. Sorption affinity of OR was found to be higher than that of EBT and PR at all the pH values investigated. Magnitude of the sorption capacities was observed to be higher in acidic medium but lower in alkaline medium. Trends of the sorption affinities in multisolute system were simlar to those in single-solute system but magnitude of the sorption capacities was significantly reduced due to the prevailing competition among the sorbates.     

Studies on batch adsorptive removal of cadmium and nickel from synthetic waste water using silty clay originated from Balochistan–Pakistan

The potentials of silty clay(SC), acquired from Chaman, Balochistan, were investigated as adsorbent for Ni(Ⅱ)and Cd(Ⅱ) removal from contaminated media. The influence of different operating factors like dose, pH, temperature, and time of contact was explored, and optimum values were noted under batch adsorption method. Isothermal study was conducted with varying concentrations of solutions on optimized conditions and different adsorption models i.e., Langmuir, Freundlich, Temkin and Dubinin–Radushkevich(D–R) isotherm, which were employed to interpret the process. The isothermal data of both Ni(Ⅱ) and Cd(Ⅱ) were well fitted to Langmuir isotherm suggesting the formation of monolayer of metal ions on silty clay. The values of adsorption capacity noted for Ni(Ⅱ) and Cd(Ⅱ) were 3.603 mg·g~(-1) and 5.480 mg·g~(-)1, respectively. Kinetic studies affirmed that pseudo second order(PSO) kinetics was being obeyed by the removal of Ni(Ⅱ) and Cd(Ⅱ). Thermodynamic variables like free energy change(ΔG°), enthalpy change(ΔH°) and entropy change(ΔS°) were calculated. The negative value of ΔG° and the positive values of ΔH° and ΔS° unfolded that the removal process of both metal ions of by SC was spontaneous, endothermic and feasible.     

Synthesis and Characterization of Sulfanilamide-Based Nonionic Surfactants and Evaluation of Their Nano-Vesicular Drug Loading Application

Nonionic surfactants are highly stable and cost-effective and receiving acceptance for applications in many diverse fields including drug delivery, due to their distinctive properties. Here, we report on the synthesis and characterization of sulfanilamide-based nonionic surfactants for nanoscale vesicular drug loading applications. Nonionic surfactants were synthesized through alkylation of sulfanilamide with alkyl halides that possessed diverse degrees of lipophilicity. They were explored for their nanovesicular drug loading with Cefixime as a hydrophobic model drug. Drug-loaded nanovesicles were characterized for surface morphologies, size, size distribution, surface charge, and drug loading efficiency using atomic force microscopy (AFM), dynamic light scattering (DLS), and UV–visible spectrophotometry. All of the synthesized nonionic surfactants revealed their CMC values in 0.055–0.035 mM range depending upon the lipophilic chain length of surfactants. They caused a decreased hemoglobin release and low toxicity against cell culture. They self-assembled and loaded an increased amount of drug in the form of nanorange spherical shape niosomal vesicles. Results of the current study verify these synthesized nonionic surfactants are hemocompatible, nontoxic, and capable of self-assembling into nanorange niosomal vesicles. These niosomal vesicles can be suggested as safe and highly efficient nanocarriers for hydrophobic drug loading and delivery.