PC／TPU共混物的流变性能

用毛细管流变仪研究了聚碳酸酯（ＰＣ）及聚碳酸酯／热塑性聚氨酯弹性体（ＰＣ／ＴＰＵ）共混物的流变性能。实验结果表明：ＰＣ熔体粘度对剪切速率（γ）不敏感，而对温度（Ｔ）敏感。温度升高，ＰＣ粘度降低。加入ＴＰＵ大大改善了共混物的流动性能，使共混物的成型加工变得容易进行。当ＴＰＵ含量为４０份时，共混物的熔体粘度出现一极小值。加入不同第三组分对于降低共混物的熔体粘度效果不同，第三组分Ｅ对共混物有增粘作用     

腐植酸类物质凝聚及沉淀特性的研究

通过对不同产地，不同提取方法获得的煤炭腐植酸和经过生物发酵人工合成的生化黄腐酸分别进行铝离子絮凝实验和酸化沉淀实验，发现煤炭腐植酸、腐植酸盐、棕惰酸、黄腐酸都同时具有被铝离子定量絮凝和在酸性条件下定量沉淀的特性，这类物质具有极其相近的化学特性。生化黄腐酸在上述两方面显示出与煤炭腐植酸十分不同的特性。     

The partition coefficients of ethylene between hydrate and vapor for methane + ethylene + water and methane + ethylene + SDS + water systems

The hydrate formation of CH₄+C₂H₄ mixture was studied experimentally in two different cases, with and without the presence of sodium dodecyl sulfate (SDS) in water. The results manifested that the presence of SDS could not only accelerate the hydrate formation process, but also increase the partition coefficient of ethylene between hydrate and vapor drastically. The partition coefficients of ethylene between hydrate and vapor for methane + ethylene + water with the presence of 500 ppm SDS in water were then systematically measured. The experimental temperature ranged from 273.15 to 278.15 K, the pressure ranged from 2.5 to 5.5 MPa, the initial gas-liquid volume ratio ranged from 95 to 240 standard volumes of gas per volume of liquid, and the mole percentage of ethylene in feed gas mixture ranged from 5.28% to 79.36%. The results demonstrated that ethylene could be enriched in hydrate phase and partition coefficients were increased with the presence of SDS in water. This conclusion is of industrial significance; it implies that it is feasible to recover ethylene from gas mixture, e.g., various kinds of refinery gases or cracking gases in ethylene plant, by forming hydrate.     

船用涂料的检测及所存在的局限性

简要介绍了我国船用涂料的检验标准和船检的认可程序,通过对多种船用涂料的性能检测,发现现采用的船用涂料国家标准存在一定的局限性和不适应性;对一些存在缺陷的指标进一步进行了分析,提出了一些合理化的建议,以督促有关部门对现有的标准进行修改,适应和满足我国船舶涂料发展的需要。     

Morphology and properties of blends of polypropylene with ethylene-propylene rubber

Great attention has been paid to the toughening of isotactic polypropylene (PP) in recent years in order to make full use of this plastic. This paper presents the results of our study on the compatibility of PP with ethylene-propylene-diene rubber (EPT), polybutadiene rubber (PB) or styrene-butadiene rubber (SBR) through characterization of the blends' morphology, and on. the morphology and properties of binary blends of PP with EPT (EPT/PP) and ternary blends of PP, EPT, and polyethylene (PE) (EPT/PE/PP). Morphological structure of solution blends and the great improvement in low-temperature impact strength and other properties of the mechanical blends have shown the difference among EPT, PB, and SBR in compatibility with PP, the effectiveness of using EPT as PP's toughening agent, and the effect of EPT on EPT/PP blend as both toughening agent and compatibilizer. Addition of EPT to EPT/PP made interesting changes in morphology but no effect on properties was observed.     

平衡硫化体系硫化天然橡胶的性能研究

对平衡硫化（ＥＣ）体系硫化天然橡胶（ＮＲ）的性能进行了研究，并与半有效硫化（ＳＥＶ）体系和传统硫化（ＣＶ）体系硫化ＮＲ进行了对比。结果表明，ＥＣ体系返原作用略高于ＳＥＶ体系，明显低于ＣＶ体系，硫化６ｈ时的返原率依次为７．７％，０．４％和３４．０％；与ＳＥＶ和ＣＶ体系相比，ＥＣ体系ＮＲ硫化胶拉伸强度、撕裂强度和３００％定伸应力高，生热低，耐磨性和耐屈挠性好。ＥＣ体系ＮＲ硫化胶的耐热氧老化性能优于ＳＥＶ体系，更优于ＣＶ体系。     

A water‐developable negative photoresist based on the photocrosslinking of N‐phenylamide groups with reduced environmental impact

A water‐developable negative photoresist based on the photocrosslinking of N‐phenylamide groups was prepared by the copolymerization of 4‐styrenesulfonic acid sodium salts (SSS) with N‐phenylmethacrylamide (copolymer A) or p‐hydroxy‐N‐phenylmethacrylamide (copolymer B), and its properties such as solubility changes, photochemical reaction, and photoresist characteristics were studied. The copolymer containing a relatively higher amount of SSS units was soluble in water. Solubility changes of the copolymers in the various buffer solutions of pH 4 ～ 11 and in water upon irradiation were observed by the measurement of insoluble fraction. The copolymers were soluble in water before irradiation, whereas they became insoluble upon irradiation with the UV light of 254 nm. The photochemical reaction of the copolymer studied by the UV and IR absorption spectroscopies indicated that a photo‐Fries rearrangement was favored for copolymer A, whereas a photocrosslinking reaction was predominate for copolymer B. Resist properties of the copolymers were studied by measurement of the normalized thickness and by development of the micropattern. Negative tone images with a resolution of 1 μm were obtained with these materials that have a sensitivity (D) of ～ 1100 mJ/cm² with an aqueous developing process.© 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 1172–1180, 2002     

活性端基聚氨酯橡胶改性不饱和聚酯树脂的研究(Ⅱ)

通过在不饱和聚酯树脂中加入活性端基聚氨酯橡胶来降低树脂的体积收缩.树脂固化前,橡胶与不饱和聚酯树脂相溶性好;树脂固化时橡胶中的不饱和双键反应可参与反应,并呈一定粒径的胶粒析出.本文研究了几种活性端基聚氨酯橡胶对不饱和聚酯树脂收缩控制的影响.     

Engineering a pharmacologically superior form of leptin for the treatment of obesity

Leptin plays a central role in the homeostasis of body weight through its regulatory effects on appetite and energy expenditure, yet in trials as a therapeutic agent for the treatment of obesity in humans it has been disappointing. The poor clinical efficacy of leptin results from its short circulating half-life, low potency and poor solubility, necessitating large and frequent doses to obtain even modest clinical benefit. Engineered Fc-leptin immunofusins, consisting of the Fc fragment of an immunoglobulin gamma chain followed by leptin, exhibit improved pharmacological properties with very consistent and potent biological activities. Furthermore, in extending the circulating half-life of the protein in vivo from a few minutes for leptin to many hours for Fc-leptin, these proteins have the potential to reduce drastically the dosage and frequency of administration required to obtain clinical benefit. The results of this study show that the engineered leptin immunofusins described here have significantly enhanced pharmacological properties in comparison with the recombinant leptin that was used in clinical trials. As such, they could represent an important step towards a therapeutically superior form of leptin if the disappointing performance of leptin in early clinical trials was due to its poor pharmacological properties rather than any conceptual weakness in the strategy of using leptin for the treatment of obesity and its related disorders.     

治理铬渣的两个关键

铬渣中存在的酸溶性六价铬是解毒效果能否持久的关键，而铬渣中游离氧化镁消化是利用铬渣作建筑材料时必须高度重视的问题，论述了湿法解毒、高温解毒和非熔融的综合利用法等方法，对铬盐行业的铬渣治理有指导作用。