Enhanced extraction of isoflavones from Korean soybean by ultrasonic wave

The amounts of isoflavones extracted from Korean soybean by various ultrasonic waves were compared using 60% aqueous ethanol solution. The effect on extraction yield of variations in solvent composition, temperature, and extraction time was investigated. The experimental results confirmed that ultrasonic waves are a desirable method to extract isoflavones from Korean soybean. The highest yield of aglycone isoflavones was obtained by ultrasonic waves with a frequency of 20 KHz and an extraction time of 10 min, which produced yields of glycoside and aglycone isoflavones three-fold greater than those by dipping method.     

Catalytic Combustion of Methane over Rare Earth Stannate Pyrochlore

Well-defined Ln₂Sn₂O₇ powders (Ln = La, Sm and Gd) with a phase-pure pyrochlore structure were synthesized by hydrothermal reaction. The catalytic activities of Ln₂Sn₂O₇ powders for methane combustion were measured. Methane oxidation started at 500 °C and increased with oxidation temperature. Catalytic methane combustion is strongly influenced by the presence of oxygen vacancies that form by breaking Sn–O lattice bonds as the temperature increases. Addition of manganese to the rare earth pyrochlores improved methane oxidation activity. Manganese-doped samarium stannate pyrochlore (Sm₂Sn_1.8Mn_0.2O₇) shows highest the catalytic activity. Light-off and complete oxidation temperatures were measured at about 400 and 650 °C, respectively.     

六铝酸钙材料的合成及其显微结构研究

分别采用轻质碳酸钙和活性氧化铝 ,或纯铝酸钙水泥和活性氧化铝为初始原料 ,反应烧结合成了六铝酸钙 (CA6)材料 ,研究了原料和成型压力对合成材料的烧结性能和显微结构的影响 ,同时借助于XRD、TG -DSC、SEM和EDAX等测试手段对其反应过程、物相变化和显微结构进行了分析和观察。研究结果表明 :(1) 130 0℃时 ,合成材料的主晶相为刚玉相和CA2 ,并开始有CA6形成 ;温度升至14 0 0℃ ,CA6大量生成 ;15 0 0℃时反应完成 ,产物全部为CA6相。 130 0～ 15 0 0℃时 ,上述反应表现为体积膨胀过程 ,试样的体积密度和径向线收缩率随温度的变化不大 ;而高于 15 0 0℃时 ,试样明显趋向烧结 ,体积密度升高 ,线收缩率加大。采用纯铝酸钙水泥和活性氧化铝合成的试样的体积密度均高于采用轻质CaCO3 和活性氧化铝的 ,尤其在烧成温度高于 15 0 0℃时。坯体的成型压力对这两种合成试样的烧结性能均没有显著影响。 (2 )合成六铝酸钙材料的晶粒形貌与合成工艺有关 ,制备片状晶粒的六铝酸钙材料需满足两个条件 :一是晶核有足够的发育空间 ,二是从晶核生长形成片状结构需足够的物质扩散。采用纯铝酸钙水泥和活性氧化铝为原料的试样 ,其CA6晶核很容易发育成片状晶形 ,且随着坯体成型压力的增加 ,片状CA6有向等轴状发展的趋势 ;采用     

纳米TiO2复合铁钛防锈颜料的研制及产业化进展

介绍了纳米TiO2复合铁钛防锈颜料的制备原理、工艺、技术指标;描述了铁钛防锈涂料的配方、性能检验和产业化进展情况.     

In-situ studies of electron field emission of single carbon nanotubes inside the TEM

Electron field emission characteristics of individual multi-walled carbon nanotubes (MWCNTs) were investigated in situ inside the transmission electron microscope (TEM). For a single MWCNT it was found that while field-emission can hardly occur from the side of the nanotube, a curved nanotube may result in finite side emission and the best emission geometry is the top emission geometry. Current-voltage (I-V) measurements made at different vacuum conditions and voltage sweeps emphasize the importance of the adsorbates on the electron field emission of MWCNTs. For a contaminated MWCNT, although the field emission current was reduced, the stability of its emission was improved. A current of up to several tens of μA was observed for a single MWCNT, but it was found that long time emission usually results in drastic structure damage that may lead to sudden emission failure.     

Effect of temperature on polymer migration II: Concentration equation

Polymer migration is a generally well-known phenomenon in a flow field, and it has been verified that the sources of such phenomena are nonhomogeneity of the flow, concentration effects and hydrodynamic interactions between the polymer molecules. In addition, temperature effects were found to be another source of polymer migration. The Langevin equation for a polymer molecule was first derived from single chain dynamics using a kinetic theory for the bead-spring elastic harmonic dumbbell model, as described in part I (reference [1]). In this paper the diffusion equation and concentration profile of the polymer molecules induced by a temperature gradient are obtained from the Fokker-Planck equation. A new differential operator is also introduced to calculate the concentration profile. From the concentration equation obtained in the general flow geometry, we find that in dilute polymer solution there are significant effects on the polymer migration not only due to the nonhomogeneity of the flow field but also due to temperature gradients.     

Dependence of properties of liquid crystalline aromatic copolyesters on monomer sequence-copolyesters derived from terephthalic acid, 2,7-naphthalenediol and p-hydroxybenzoic acid

Summary An aromatic copolyester with the ordered sequence of terephthalic acid (TA)-p-hydroxybenzoic acid (HB)-2,7-naphthalenediol (ND)-p-hydroxybenzoic acid (HB) was prepared and its properties were compared with those of the corresponding random copolyester having the same overall monomer composition. Thermal and crystallizing properties of the two polymers are quite different. The former exhibits significantly higher glass transition and melting temperatures than the latter. The former's degree of crystallinity also is much higher than the latter's. Both polymers are thermotropic and form nematic melts.     

模拟三相流化床中颗粒尺寸对单气泡传质系数的影响

本文在模拟三相流化床中,测量了单气泡的传质系数,实验结果表明颗粒直径对气-液传质系数影响显著。颗粒直径较大时,传质系数有明显提高。     

功能性建筑涂料照亮市场

功能性建筑涂料除了具备普通建筑涂料的装饰作用外，还能起到某种功能性作用。随着国民经济的快速发展，其应用也越来越普遍，可以预期，功能性建筑涂料的实用性，拓宽建筑涂料的应用范围。本文作者庚晋介绍了几种功能性建筑涂料的特点、主要用途、最新研究动态、施工方法、市场前景等。