Acoustic emission occurrence induced from a NbTi superconductingcoil under alternating current operation

Acoustic emission (AE) induced from an alternating current (ac) superconducting coil was studied during operation in liquid helium. The operating current of the coil was increased from zero with a constant ramp rate at a commercial frequency of 50 Hz until quenching in the coil. The AE signals induced from the coil around the time of the quenching initiation were compared with the operating current, the coil voltage, and the phase difference between the current and the voltage in order to estimate the changes in those signals which resulted from the quenching process. The AE signals continued almost at very low levels before the quenching, At the moment of the quenching initiation, the AE signals clearly and drastically rose approximately 10-15 ms earlier than the decrease in the operating current or the phase difference. The AE signals induced by the wire motion during 50-Hz ac operation were also compared with the operating current     

Expression of DCC protein in colorectal tumors and its relationship to tumor progression and metastasis

The strains BALB/cHeA (BALB/c) and STS/A (STS) differ in production of IL-4 and IL-10, two Th2 cytokines, after stimulation of spleen cells with Concanavalin A, STS being a low and BALB/c a high producer. We analyzed the genetic basis of this strain difference using the recombinant congenic (RC) strains of the BALB/c-c-STS/Dem (CcS/Dem) series. This series comprises 20 homozygous strains. Each CcS/Dem strain contains a different, random set of approximately 12. 5% genes of the "donor" strain STS and approximately 87.5% of the "background" strain BALB/c. We selected for further analysis the RC strain production intermediate between BALB/c and STS. In (CcS-20xBALB/c)F2 hybrids we found that different loci control expression of IL-4 and IL-10. Cypr1 (cytokine production 1) on chromosome 16 near D16Mit15 controls IL-4 production, whereas the production of IL-10 is influenced by loci Cypr2 near D1Mit14 and D1Mit227 on chromosome 1 and Cypr3 marked by D5Mit20 on chromosome 5. In addition, the relationship between the level of these two cytokines depends on the genotype of the F2 hybrids at a locus cora1 (correlation 1) on chromosome 5. This differential genetic regulation may be relevant for the understanding of biological effects of T-helper cells in mice of different genotypes.     

Characterization of monofunctional catalase KatA from radioresistant bacterium Deinococcus radiodurans

Catalase plays a key role in protecting cells against toxic reactive oxygen species. Here we report on the cloning, purification and characterization of a catalase (KatA, DR1998) from the extremely radioresistant bacterium Deinococcus radiodurans. The size of purified D. radiodurans KatA monomer was 65 kDa while gel filtration revealed that the size of the enzyme was 240 kDa, suggesting that KatA formed a homotetramer in solution. Purified KatA displayed a final specific activity of 68,800 U/mg of protein. The catalase activity of KatA was inhibited by sodium azide, sodium cyanide and 3-amino-1,2,4-triazole. The absorption spectrum of KatA exhibited a Soret band at 408 nm. The position of the spectral peak remained unchanged following reduction of KatA with dithionite. No peroxidase activity was found for KatA. These results demonstrate that D. radiodurans KatA is a typical monofunctional heme-containing catalase. The stability of KatA with respect to H2O2 stress was superior to that of commercially available Aspergillus niger and bovine liver catalases. The relative abundance of KatA in cells in addition to the H2O2 resistance property may play a role in the survival strategy of D. radiodurans against oxidative damage.     

Surface-modified mesoporous silicas as recyclable adsorbents of an endocrine disrupter, bisphenol A

Surface-modified mesoporous silicas (MSs) were investigated for recyclable adsorption of an endocrine disrupter, bisphenol A (BPA). Surface-modified MSs were prepared by (i) post-synthesis surface modification of MSs using surface hydroxyl groups and organosilanes (m-MS) and by (ii) co-condensation of tetraethoxysilane and the corresponding organosilanes (d-MS). Infrared measurements indicated that organic groups mainly existed on the surface of m-MS, which resulted in a surface characterized by high hydrophobicity. Both organic groups and isolated hydroxyl groups existed on the surface of d-MS, resulting in both hydrophobicity and hydrophilicity on the surface. The amount of BPA adsorbed on surface-modified MSs per organic group was similar for m-MS and d-MS, however, the d-MS established equilibrium for BPA adsorption faster than m-MS, as measured by UV-vis spectra. A larger amount of BPA per surface area could be adsorbed on carbon materials than on the surface-modified MSs, however, the regeneration of carbon materials by washing could not be done easily. The surface-modified MSs retain adsorption capacity for BPA after several regeneration cycles, demonstrating that the surface-modified MSs are effective recyclable adsorbents of the endocrine disrupter, bisphenol A.     

Proportional hazards models with random effects to examine centre effects in multicentre cancer clinical trials

In randomized clinical trials comparing treatment effects on diseases such as cancer, a multicentre trial is usually conducted to accrue the required number of patients within a reasonable period of time. The fundamental point of conducting a multicentre trial is that all participating investigators must agree to follow the common study protocol. However, even with every attempt having been made to standardize the methods for diagnosing severity of disease and evaluating response to treatment, for example, they might be applied differently at different centres, and these may vary from comprehensive cancer centres to university hospitals to community hospitals. Therefore, in multicentre trials there is likely to be some degree of variation (heterogeneity) among centres in both the baseline risks and the treatment effects. While we estimate the overall treatment effect using a summary measure such as hazard ratio and usually interpret it as an average treatment effect over the centre, it is necessary to examine the homogeneity of the observed treatment effects across centres, that is, treatment-by-centre interaction. If the data are reasonably consistent with homogeneity of the observed treatment effects across centres, a single summary measure is adequate to describe the trial results and those results will contribute to the scientific generalization, the process of synthesizing knowledge from observations. On the other hand, if heterogeneity of treatment effects is found, we should carefully interpret the trial results and investigate the reason why the variation is seen. In the analyses of multicentre trials, a random effects approach is often used to model the centre effects. In this article, we focus on the proportional hazards models with random effects to examine centre variation in the treatment effects as well as the baseline risks, and review the parameter estimation procedures, frequentist approach-penalized maximum likelihood method--and Bayesian approach--Gibbs sampling method. We also briefly review the models for bivariate responses. We present a few real data examples from the biometrical literature to highlight the issues.     

Microdosimetric distribution of protons,Ep = 19-65 MeV,measured with a low pressure proportional counter

Microdosimetric measurements of 19, 32, 43, 55, and 65 MeV protons were carried out with the A-150-walled low pressure proportional counter (LPPC). The spectra are deconvoluted into three components, which are energy loss by directly incident protons, secondary electrons, and scattered protons and heavy charged particle (including protons) produced by proton nuclear reactions with the TE wall. Dose-mean lineal energies of protons are large as usual, because larger lineal energies by proton reaction events are affected.     

Self-assembly of a silica-surfactant nanocomposite in a porous alumina membrane

A mesoporous membrane composed of nanochannels with a uniform diameter has a potential use for precise size-exclusive separation of molecules. Here, we report a novel method to form a hybrid membrane composed of silica-surfactant nanocomposite and a porous alumina membrane, by which size-selective transport of molecules across the membrane becomes possible. The nanocomposite formed inside each columnar alumina pore was an assembly of surfactant-templated silica-nanochannels with a channel diameter of 3.4 nm; the channel direction being predominantly oriented along the wall of the columnar alumina pore. Molecules could be transported across the membrane including the silica-surfactant nanocomposite with a capability of nanometre-order size-exclusive separation. Our proposed membrane system has a potential use not only for separation science, but also catalysis and chip technologies.     

Segmentation of whole cells and cell nuclei from 3-D optical microscope images using dynamic programming

Communications between cells in large part drive tissue development and function, as well as disease-related processes such as tumorigenesis. Understanding the mechanistic bases of these processes necessitates quantifying specific molecules in adjacent cells or cell nuclei of intact tissue. However, a major restriction on such analyses is the lack of an efficient method that correctly segments each object (cell or nucleus) from 3-D images of an intact tissue specimen. We report a highly reliable and accurate semi-automatic algorithmic method for segmenting fluorescence-labeled cells or nuclei from 3-D tissue images. Segmentation begins with semi-automatic, 2-D object delineation in a user-selected plane, using dynamic programming (DP) to locate the border with an accumulated intensity per unit length greater that any other possible border around the same object. Then the two surfaces of the object in planes above and below the selected plane are found using an algorithm that combines DP and combinatorial searching. Following segmentation, any perceived errors can be interactively corrected. Segmentation accuracy is not significantly affected by intermittent labeling of object surfaces, diffuse surfaces, or spurious signals away from surfaces. The unique strength of the segmentation method was demonstrated on a variety of biological tissue samples where all cells, including irregularly shaped cells, were accurately segmented based on visual inspection.     

Generation of hydroxyapatite patterns by electrophoretic deposition

Hydroxyapatite (HAp) patterns with distinct boundaries were generated by electrophoretic deposition (EPD) utilizing an insulating mask that partially blocks the electric field. For the EPD process, we selected two types of mask: a polytetrafluoroethylene (PTFE) board with holes and a resist pattern. A porous PTFE film, which differed from the mask PTFE, was employed as a substrate and attached to the mask. EPD was performed with a suspension of wollastonite particles in acetone, which were deposited on the substrate in the form of the patterned mask. The deposited wollastonite particles induced HAp patterns during a soak in simulated body fluid (SBF). As a result, minute HAp patterns, such as dots, lines, and corners were fabricated on the porous PTFE substrate with a minimum line width of about 100 μm.