FSK heterodyne transmission experiments at 560 Mbit/s and 1 Gbit/s

Optical frequency-shift-keying (FSK) signals are obtained from directly modulated distributed feedback (DFB) semiconductor lasers. Experimental studies of the direct frequency modulation (FM) characteristics of the DFB lasers show a nonuniform FM response due to the competing effects of thermal modulation of the laser active region and carrier density modulation. Equalization of the signal current to the laser is employed to produce a flat FM response from 30 kHz to 1 GHz. Optical FSK transmission and heterodyne detection experiments at 560-Mbit/s and 1-Gbit/s are conducted at a wavelength of 1497 nm. Receiver sensitivities of -39 dBm at 560 Mbit/s and -37 dBm at 1 Gbit/s are obtained. Transmission through 100 km of single-mode fiber at 1 Gbit/s is achieved with no degradation in receiver sensitivity.     

A novel fungal endo-beta-N-acetylglucosaminidase that specifically acts on plant glycoproteins

An endo-beta-N-acetylglucosaminidase specific for plant glycoprotein oligosaccharides was purified from the culture fluid of a fungus. The Mr of the purified enzyme was 89,000. This enzyme was stable at pH 5.5-7.0, up to 30 degrees C, and showed the highest activity at pH 6.0. Among sugar chains tested, xylose-containing sugar chains (M3X, M3FX, and M2FX) were the most favored substrates. Oligomannose type (M3, M5, and M9) and hybrid type (GNM3) sugar chains were hydrolyzed much more slowly than xylose-containing sugar chains, and a complex type sugar chain (GN2M3) was not hydrolyzed at all by the enzyme. Moreover, the enzyme released sugar chains from native horseradish peroxidase and stem bromelain, which were not hydrolyzed by other endo-beta-N-acetylglucosaminidases (Endo H, D, and F). The enzyme could transfer the xylose-containing sugar chain from bromelain to DNS-Asn-GlcNAc-Fuc.     

Failure analysis of ULSI circuits using photon emission

A real-time failure analysis technique for ULSI circuits using photon emission is proposed. This technique utilizes a photon detection system combined with a circuit tester. Improved failure detection is achieved because the tester can bias arbitrary blocks in the ULSI chip. Detecting and correct process defects and design errors improves the reliability of the ULSI chip     

Electrochemical noise analysis for estimation of corrosion rate of carbon steel in bicarbonate solution

We have investigated the electrochemical noise behavior of carbon steel in fully deaerated aqueous bicarbonate solutions, and discussed the optimum conditions of the noise analysis for estimating corrosion rate of the steel. Noise of the potential difference and of the short-circuit current between two identical steel coupons were successfully measured. The time-series noise patterns were transformed into frequency domain by fast Fourier transformation, and then their power spectrum densities (PSDs) at a frequency were determined to be compared with the corrosion rate. The PSDs of the potential and of the current varied with changing environmental factors of bicarbonate concentration, pH, and immersion time. The factors also controlled the corrosion rate of the steel. The PSDs were associated with the corrosion rate, and then it was found that the PSDs of the potential and of the current showed linear correlation with the corrosion rate in log-log scale. There was also linear relationship between the corrosion rate and a spectral noise resistance obtained from the PSDs of the potential and the current. The linearities of the three correlations were better at a lower analyzed frequency. Furthermore, the PSDs of the current and the noise resistance indicated more linear correlation with the corrosion rate than that of the potential. As the simplicity of the measurement system is additionally considered, it is concluded that the PSD of the current noise at an analyzed frequency of 3 mHz is the optimum conditions for estimating the corrosion rate from 10⁻² to 10⁰ A m⁻² in this study.     

A versatile leaky-wave antenna based on stub-loaded rectangularwaveguide .I. Theory

A new leaky-wave antenna is presented that possesses many desirable features and is suitable for application to both the millimeter-wave and microwave ranges. These desirable features, some of which are unusual, include a simple configuration, a wide flexibility in the range of available beamwidths, the ability to control the beamwidth and the direction of the beam essentially independently, and negligible cross polarization at all scan angles. The antenna structure consists of a parallel-plate stub guide of small height, less than a half wavelength, located off center on the top of rectangular waveguide. The beamwidth is easily controlled from very wide to very narrow by adjusting the stub width or location. The article presents the principle of operation and the theory, employing a new transverse equivalent network that is accurate, but also simple, so that it permits rapid and inexpensive numerical calculations     

Activation of the alternative pathway of human complement by apoptotic human umbilical vein endothelial cells

Complement activation generally does not occur on homologous cells. We observed C3 deposition on cultured human umbilical vein endothelial cells (HUVEC) when those which had died of apoptosis were treated with human serum. The C3 deposition on apoptotic HUVEC required Mg2+ but not Ca2+. In addition, the incubation of apoptotic HUVEC with purified C3, B, and D in the presence of Mg2+ resulted in C3 deposition. These results indicated that the C3 deposition on apoptotic HUVEC is mediated by the activation of the alternative complement pathway. C3 contains an intrachain thioester bond in the alpha chain (110 kDa) and upon activation to C3b, binds with membrane molecules by forming an ester or amide bond. Western blotting of reduced C3b-membrane molecule complexes, isolated from serum-treated apoptotic HUVEC by immunoprecipitation with anti-C3, revealed the covalent binding of C3b to several membrane molecules. Most of the C3b-membrane molecule complexes were cleaved by hydroxylamine, suggesting covalent binding via an ester bond. The molecular mass of the major alpha chain fragment released by hydroxylamine treatment was not 105 kDa but 68 kDa, which corresponds to the alpha 1 fragment of iC3b. These results indicate that most of the C3b on HUVEC was cleaved at its alpha' chain to yield iC3b, which consists of three disulfide-linked polypeptide chains and is a ligand of the complement receptor type 3 (CR3) of phagocytes. These results suggest that apoptotic HUVEC can activate the alternative pathway of the homologous complement and that the complement is related to the clearance of apoptotic cells by phagocytes.     

Novel B-ring modified combretastatin analogues: syntheses and antineoplastic activity

A series of B-ring modified combretastatin analogues were synthesized and their inhibitory activity against microtubule assembly, cytotoxic activity against Colon 26 adenocarcinoma cancer cell line were evaluated. Among these, pyridone derivative (19) showed strong antimitotic activity and cytotoxicity, along with excellent water-solubility.     

Bottom-up multi-agent reinforcement learning by reward shaping for cooperative-competitive tasks

Applied Intelligence - A multi-agent system (MAS) is expected to be applied to various real-world problems where a single agent cannot accomplish given tasks. Due to the inherent complexity in the...     

Particle velocity and solids circulation rate in a jet-spouted bed

Radial distribution of particle velocities, solids circulation rate and radial variation in bed voidage in a jet-spouted bed were investigated in a 0.2 m diameter conical-cylindrical column. The upward particle velocity is strongly dependent on gas velocity and its radial profile is the Gaussian. The solids circulation rates are of the same order of magnitude as those in a conventional spouted bed and are proportional to the gas velocity. Estimation of the variation in bed voidage in the radial direction revealed that the annulus voidage of about 0.90 was greater than the spout voidage of around 0.70. This tendency is contrary to that in a conventional spouted bed.