Effects of extraction solvents,cooking procedures and storage conditions on the contents of ergothioneine and phenolic compounds and antioxidative capacity of the cultivated mushroom Flammulina velutipes

Edible mushrooms contain considerable amounts of the potent natural antioxidant 2‐thiol‐l ‐histidine‐betaine (l ‐ergothioneine, ESH). The objective of this study was to evaluate the effects of extraction solvents, common cooking methods and storage conditions on the ESH content, total phenols (TPs) and antioxidant capacity of the edible mushroom Flammulina velutipes fruiting body and its hot water extract that had been stored at different temperatures. Regarding cooking procedures, boiling in water resulted in the highest losses of antioxidant activity of both ESH and TPs. Most of the losses of ESH and TPs were detected in the cooking water. The ESH contents in the raw mushroom fruiting bodies significantly decreased after 8 days of refrigerated storage under both dark and fluorescent lighting conditions. However, the TP content in the raw mushroom stored under fluorescent lighting significantly increased during 10 days of refrigeration. In contrast, the ESH and TP contents as well as DPPH radical scavenging ability of the fruiting bodies remained unchanged for up to 15 days of frozen storage at ?18 °C. The same behaviour was obtained with the mushroom extract packed in plastic tubes. The correlation between DPPH radical scavenging activity and ESH contents was higher than that for TP compounds.     

The efficient lignocellulose-based sorbent for oil spill treatment from polyurethane and agricultural residue of Vietnam

In this study, new and efficient sorbent with density 0.2 g/cm³ was fabricated by incorporating rice straw into polyurethane matrix to get an open cell structure material with high oil uptake capacity. The influences of various important factors such as amount of adding rice straw, size of rice straw particles, and adsorption time on oil adsorption capacity of new sorbent material were investigated. The results showed that the oil absorption rate occurred fast in first 15–30 min, then slowed down and reached saturation level after about 2 h of treatment. Oil adsorption capacity of the new sorbent material was relatively high, up to 12.0 g/g. In comparison with pristine polyurethane or lignocellulosic materials, the new sorbents had higher oil adsorption capacity. Some characteristics of the as-obtained sorbent, such as surface shapes and porosity, were also studied by SEM analysis.     

Oxidation of ZC63 Mg alloys reinforced with SiC particles between 390 °C and 500 °C in air

The ZC63 magnesium alloys reinforced with 10 wt.% of SiC particles with an average particle size of 50 μm were cast. The fabricated SiC_p/ZC63 composite consisted of an α-Mg matrix, unreacted α-SiC particles, and an intergranularly formed CuMgZn compound. It was oxidized at 390 °C to 500 °C up to 5 h in air. The oxide scales were thin and compact below 430 °C, but became porous and loose above 450 °C. They consisted primarily of MgO and a small amount of Mg₃N₂. SiC particles were stable over the temperature range explored.     

Investigation of Isotherm Polymer Adsorption in Porous Media

The injection of chemical solutions plays an important role in increasing the recovery factor of mature fields. Chemical flooding is considered as an attractive alternative to conventional waterflooding; it can improve the area sweep efficiency not only at the macroscale but also in the microscale by control mobility of displaced fluid. Adsorption of polymer in reservoir rock is an extremely important parameter for chemical flooding. Adsorption represents a loss of chemical agent from solution and, consequently, a net reduction in the surfactant–polymer slug. Therefore, the efficiency of polymer flooding is significantly diminished both technically and economically. However, numerical simulation of multicomponent adsorption is still limited and adsorption processes in a polymer–rock system have not yet been well developed, especially for highly heterogeneous reservoirs. In this article, adsorption was modeled by the Langmuir isotherm theory. The simulation results indicated that polymer adsorption strongly depends on polymer concentration, shear rate, pH, salt concentration, and reservoir heterogeneity. Effective control of such parameters can reduce the effect of polymer adsorption to minimize chemical loss and improve the economic efficiency of chemical flooding processes.     

Adsorption and surface tension analysis of concentrated alkali halide brine solutions

In this study, the equilibrium and dynamic surface tensions of sodium chloride and potassium chloride solutions have been measured as a function of concentration up to saturation (5.2 M for NaCl and 4.1 M for KCl) using sessile bubble tensiometry. The experimental results show that the surface tension of these and other salts significantly increases with increasing concentration due to negative adsorption of ions at the air/brine interface, regardless of their structure maker and breaker nature. Furthermore, the effect of these salts on the surface tension of aqueous solutions of sodium dodecyl sulfate (SDS) and methyl isobutyl carbinol (MIBC) was also studied. These results show that the salts increased the surface activity of SDS and MIBC. In the case of SDS, KCl increased the surface activity of SDS more significantly than NaCl did. In the case of MIBC, the effect of NaCl on MIBC surface activity was more significant than that of KCl.     

Biomechanical properties of single chondrocytes and chondrons determined by micromanipulation and finite-element modelling

A chondrocyte and its surrounding pericellular matrix (PCM) are defined as a chondron. Single chondrocytes and chondrons isolated from bovine articular cartilage were compressed by micromanipulation between two parallel surfaces in order to investigate their biomechanical properties and to discover the mechanical significance of the PCM. The force imposed on the cells was measured directly during compression to various deformations and then holding. When the nominal strain at the end of compression was 50 per cent, force relaxation showed that the cells were viscoelastic, but this viscoelasticity was generally insignificant when the nominal strain was 30 per cent or lower. The viscoelastic behaviour might be due to the mechanical response of the cell cytoskeleton and/or nucleus at higher deformations. A finite-element analysis was applied to simulate the experimental force-displacement/time data and to obtain mechanical property parameters of the chondrocytes and chondrons. Because of the large strains in the cells, a nonlinear elastic model was used for simulations of compression to 30 per cent nominal strain and a nonlinear viscoelastic model for 50 per cent. The elastic model yielded a Young''s modulus of 14 ± 1 kPa (mean ± s.e.) for chondrocytes and 19 ± 2 kPa for chondrons, respectively. The viscoelastic model generated an instantaneous elastic modulus of 21 ± 3 and 27 ± 4 kPa, a long-term modulus of 9.3 ± 0.8 and 12 ± 1 kPa and an apparent viscosity of 2.8 ± 0.5 and 3.4 ± 0.6 kPa s for chondrocytes and chondrons, respectively. It was concluded that chondrons were generally stiffer and showed less viscoelastic behaviour than chondrocytes, and that the PCM significantly influenced the mechanical properties of the cells.     

Modular argumentation for modelling legal doctrines in common law of contract

To create a programming environment for contract dispute resolution, we propose an extension of assumption-based argumentation into modular assumption-based argumentation in which different modules of argumentation representing different knowledge bases for reasoning about beliefs and facts and for representation and reasoning with the legal doctrines could be built and assembled together. A distinct novel feature of modular argumentation in compare with other modular logic-based systems like Prolog is that it allows references to different semantics in the same module at the same time, a feature critically important for application of argumentation in legal domains like contract dispute resolution where the outcomes of court cases often depend on whether credulous or skeptical modes of reasoning were applied by the contract parties. We apply the new framework to model the doctrines of contract breach and mutual mistake.