Microstructure Development and Dielectric Properties of Potassium Strontium Niobate Ceramics

Sintering of a KSr₂Nb₅O₁₅ powder compact at 1350°C resulted in a duplex structure. Prefiring of the compact between 1200° and 1300°C inhibited the abnormal grain growth responsible for the duplex structure. The Curie temperature and dielectric constant were dependent on the microstructure.     

Superconducting Coupling Nature at Grain Boundaries in Bi2Sr2CaCu2Ox Glass-Ceramics

Superconducting coupling nature at grain boundaries in Bi₂Sr₂CaCu₂O _x glass-ceramics consisting mainly of the low- T _c phase was first examined by measuring superconducting properties and temperature or ac field dependence of ac complex susceptibility. It was found from the ac loss peaks that superconducting coupling at grain boundaries was basically characterized by three types of weak links. The weak-link behaviors at grain boundaries depended strongly on cooling conditions after annealing and annealing time and temperature. Particularly, it was found that the weak links at grain boundaries were improved by prolonged annealing at 840°C. The furnace-cooled glass-ceramics obtained by annealing at 820° or 840°C for about 200 h exhibited a critical transport current density (77 K, zero magnetic field) of about 200 A/cm².     

Error grid analysis of noninvasive glucose monitoring via gingival cerevicular fluid

In order to realize a noninvasive blood glucose monitor, we monitored the gingival cerevicular fluid (GCF). In this paper, the clinical evaluations were performed on not only normal subjects but also diabetic subjects using a GCF-glucose monitor to determine blood glucose levels. Meal load tests were carried out and the time-course changes in blood glucose level and GCF glucose level were measured continuously. A positive correlation of more than 0.9 was found between blood glucose level and GCF glucose level, necessitating the calibration of individual correlations for every subject. Finally, the performance of the GCF-glucose monitor was evaluated using Error Grid Analysis. As the results, significant information for the glucose level decision was obtained not only for normal subjects, but also for diabetic subjects.     

Observation of iron silicide formation by plan-view transmission electron microscopy

The formation and the phase transitions of iron silicide by solid-phase epitaxy have been investigated by means of plan-view transmission electron microscopy, which enables us to observe a clean interface between Fe and Si. Layers of Fe were deposited on Si (100) at room temperature in an ultrahigh vacuum chamber. The sample was annealed in the electron microscope at a temperature between 673 and 1073 K. After annealing at 673 K, FeSi crystallites were formed with various orientations. When the annealing temperature was increased to 973 K, we found that the crystallites suddenly started to coalesce into grains of several hundreds of nanometers in size and polycrystalline beta-FeSi2 was formed. These phase transitions were also confirmed with electron energy-loss spectroscopy.     

Modulator integrated DFB lasers with more than 600-km transmission capability at 2.5 Gb/s

The modulator integrated DFB laser diodes with more than 600-km transmission capability over normal fiber at 2.5 Gb/s, have been reproducibly achieved. The longest transmission length obtained in the experiment is as long as 800 km.     

Energy transmission transformer for a wireless capsule endoscope: analysis of specific absorption rate and current density in biological tissue

This paper reports on the electromagnetic influences on the analysis of biological tissue surrounding a prototype energy transmission system for a wireless capsule endoscope. Specific absorption rate (SAR) and current density were analyzed by electromagnetic simulator in a model consisting of primary coil and a human trunk including the skin, fat, muscle, small intestine, backbone, and blood. First, electric and magnetic strength in the same conditions as the analytical model were measured and compared to the analytical values to confirm the validity of the analysis. Then, SAR and current density as a function of frequency and output power were analyzed. The validity of the analysis was confirmed by comparing the analytical values with the measured ones. The SAR was below the basic restrictions of the International Commission on Nonionizing Radiation Protection (ICNIRP). At the same time, the results for current density show that the influence on biological tissue was lowest in the 300-400 kHz range, indicating that it was possible to transmit energy safely up to 160 mW. In addition, we confirmed that the current density has decreased by reducing the primary coil's current.     

Reduction of wave propagation loss by mesh in rectangular tunnels

The reduction of radio wave attenuation in rectangular tunnels is discussed. The attenuation of the dominant mode due to its field penetration into a lossy dielectric wall is reduced by means of the attachment of wire netting (mesh). First, a reflection coefficient from a mesh screen over a lossy surface is analytically evaluated. Then, based on a geometrical optical approach to the propagation model in tunnels, the attenuation of the dominant mode in a rectangular tunnel is derived using the reflection coefficient. The calculated attenuation constants are in good agreement with experimental ones obtained in a laboratory. Finally, the efficiency of attenuation reduction rate by the mesh shielding method is summarized as a function of spatial ratio of the mesh wire interval divided by the wavelength. It is shown that the efficiency of reduction rate by mesh is significant     

CAD-compatible high-speed CMOS/SIMOX gate array using field-shieldisolation

A specific 0.5 μm CMOS/SIMOX technology was developed for a gate array/sea of gate (SOG) using field-shield (FS) isolation to overcome a pending problem of source-to-drain breakdown voltage (BV_ds) lowering. FS isolation is capable of improving BV_ds because surplus holes generated by impact ionization at the drain region are collected through the body region under the FS gate. BV_ds was maintained at a level of junction breakdown before reaching the punchthrough limitation at a gate length of around 0.3 μm using the FS isolation. The FS isolation technique was successfully applied to an SOG gate array on a SIMOX substrate. The gate array has the same area as that on the bulk-Si and is compatible to a conventional bulk-Si CAD system because the layout is basically the same. A 53-stage ring oscillator fabricated on the FS isolated SOG gate array exhibited 1.7 times higher speed operation than that on a bulk-Si counterpart, keeping low power consumption characteristics up to a drain voltage of 3 V     

Error grid analysis of noninvasive glucose monitoring via gingival crevicular fluid.

In order to realize a noninvasive blood glucose monitor, we monitored the gingival crevicular fluid (GCF). In this paper, the clinical evaluations were performed on not only normal subjects but also diabetic subjects using a GCF-glucose monitor to determine blood glucose levels. Meal load tests were carried out and the time-course changes in blood glucose level and GCF glucose level were measured continuously. A positive correlation of more than 0.9 was found between blood glucose level and GCF glucose level, necessitating the calibration of individual correlations for every subject. Finally, the performance of the GCF-glucose monitor was evaluated using Error Grid Analysis. As the results, significant information for the glucose level decision was obtained not only for normal subjects, but also for diabetic subjects.