Magnetically coupled oscillators applicable to high-sensitivity mass detection

Microsystem Technologies - In this paper, a system of magnetically coupled oscillators consisting of a Π-shaped horizontal cantilever and a rectangular vertical cantilever with a frequency...     

Characteristics of sol-gel derived PZT thin films with lead oxide cover layers and lead titanate interlayers

The sol-gel derived PbZr_0.53Ti_0.47O₃ (PZT) films were fabricated on the bare Pt/Ti/SiO₂/Si substrates or the same substrates coated by the PbTiO₃ (PT) interlayers. The post-deposition annealing temperature and time were optimized when the PbO cover layers and PbO vapour-containing atmosphere were compared with each other and adopted as the method to diminish the lead-loss problem during the high-temperature post-deposition annealing. The X-ray diffraction patterns, microstructures, and electrical properties such as relative permittivity, _r, remanent polarization, P _r, and coercive electrical field, E _c, were investigated in relation to the annealing conditions. The PZT films deposited on the bare Pt/Ti/SiO₂/Si substrates under the PbO vapour-containing atmosphere showed better electrical properties. This indicates that the PbO vapour-containing atmosphere may be the better method of lead-loss-prevention to process the lead-containing films rather than the PbO cover layer method. The electrical characteristics of the PZT films, _r=1150, a dissipation factor of 0.039, P _r=26 C cm^–2, and E _c=40.5 kV cm^–1 were measured at 1 kHz. When PZT films were deposited on substrates coated by the PT layers, PZT-PT films with single perovskite phase were derived by post-deposition annealing at 500 °C for 1 h. However, the relative electrical properties are very poor, i.e. E _r=160, P _r=2.0 C cm^–2 and E _c=75 kVcm^–1. The optimum combination for preparing PZT-PT films is a 40 nm PbTiO₃ interlayer and annealing conditions of 6 h at 550 °C in a PbO vapour-containing atmosphere; the derived films exhibit electrical properties of E _r=885, P _r=21.5 C cm^–2 and E _c=64 kV cm^–1. The combination of inserting a PT interlayer and annealing in a PbO vapour-containing atmosphere can prevent the formation of electrical short paths. In this case, nearly pin-hole-free PZT films can be grown on the PT (interlayer) /Pt/Ti/SiO₂/Si substrates. It is believed that it is possible to prepare the PZT films with nano-scale uniformity, reproducible quality, which may be worth considering for commercial applications.     

Production of IL-6 by T cells from the femoral head of patients with rapidly destructive coxopathy (RDC)

We developed a method to improve the quantitative precision of FDG-PET scans in cancer patients. The total-lesion evaluation method generates a correlation coefficient (r) constrained Patlak parametric image of the lesion together with three calculated glucose metabolic indices: (a) the total-lesion metabolic index ("KT-tle", ml/min/lesion); (b) the total-lesion voxel index ("VT-tle", voxels/lesion); and (c) the global average metabolic index ("KV-tle", ml/min/voxel). METHODS: The glucose metabolic indices obtained from conventional region of interest (ROI) and multiplane evaluation were used as standards to evaluate the accuracy of the total-lesion evaluation method. Computer simulations and four patients with metastatic melanoma before and after chemotherapy were studied. RESULTS: Computer simulations showed that the total-lesion evaluation method has improved precision (% s.d. < 0.6%) and accuracy (approximately 10% error) compared with the conventional ROI method (% s.d. approximately 5%; approximately 25% error). The KT-tle and VT-tle indices from human FDG-PET studies using the total-lesion evaluation method showed excellent correlations with the corresponding values obtained from the conventional ROI methods and multiplane evaluation (r approximately 1.0) and CT lesion volume measurements. CONCLUSION: This method is a simple but reliable way to quantitatively monitor tumor FDG uptake. The method has several advantages over the conventional ROI method: (a) less sensitive to the ROI definition, (b) no need for image registration of serial scan data and (c) includes tumor volume changes in the global tumor metabolism.     

A Two-Step Filtering approach for detecting maize and soybean phenology with time-series MODIS data

The crop developmental stage represents essential information for irrigation scheduling/fertilizer management, understanding seasonal ecosystem carbon dioxide (CO₂) exchange, and evaluating crop productivity. In this study, we devised an approach called the Two-Step Filtering (TSF) for detecting the phenological stages of maize and soybean from time-series Wide Dynamic Range Vegetation Index (WDRVI) data derived from Moderate Resolution Imaging Spectroradiometer (MODIS) 250-m observations. The TSF method consists of a Two-Step Filtering scheme that includes: (i) smoothing the temporal WDRVI data with a wavelet-based filter and (ii) deriving the optimum scaling parameters from shape-model fitting procedure. The date of key crop development stages are then estimated by using the optimum scaling parameters and an initial value of the specific phenological date on the shape model, which are preliminary defined in reference to ground-based crop growth stage observations. The shape model is a crop-specific WDRVI curve with typical seasonal features, which were defined by averaging smoothed, multi-year WDRVI profiles from MODIS 250-m data collected over irrigated maize and soybean study sites.In this study, the TSF method was applied to MODIS-derived WDRVI data over a 6-year period (2003 to 2008) for two irrigated sites and one rainfed site planted to either maize or soybean as part of the Carbon Sequestration Program (CSP) at the University of Nebraska-Lincoln. A comparison of satellite-based retrievals with ground-based crop growth stage observations collected by the CSP over the six growing seasons for these three sites showed that the TSF method can accurately estimate the date of four key phenological stages of maize (V2.5: early vegetative stage, R1: silking stage, R5: dent stage and R6: maturity) and soybean (V1: early vegetative stage, R5: beginning seed, R6: full seed and R7: beginning maturity). The root mean square error (RMSE) of phenological-stage estimation for maize ranged from 2.9 [R1] to 7.0 [R5] days and from 3.2 [R6] to 6.9 [R7] days for soybean, respectively. In addition, the TSF method was also applied for two years (2001 and 2002) over eastern Nebraska to test its ability to characterize the spatio-temporal patterns of these key phenological stages over a larger geographic area. The MODIS-derived crop phenological stage dates agreed well with the statistical crop progress data reported by the United State Department of Agriculture (USDA) National Agricultural Statistics Service (NASS) for eastern Nebraska's three crop agricultural statistic districts (ASDs). At the ASD-level, the RMSE of phenological-stage estimation ranged from 1.6 [R1] to 5.6 [R5] days for maize and from 2.5 [R7] to 5.3 [R5] days for soybean.     

Thermodynamic evaluation of Cu– system based on newly determined Gibbs energy of formation of

Thermodynamic evaluation of Cu–Cu₃P system has been conducted by applying subregular solution model with Gibbs energy of Cu₃P formation that was newly determined by means of triple Knudsen cell mass spectrometry. Both the calculated vapor pressure of phosphorus and phase diagram of Cu–P system are excellently consistent with the literature data in the composition range of Cu–Cu₃P, indicating that there is no significant thermodynamic inconsistency between the present work based on the Gibbs energy of Cu₃P formation determined and the literature data.     

Molecular dynamics simulations of diffusion of submonolayer polar liquid lubricant films on solid surfaces

A fundamental understanding of the diffusion phenomena of submonolayer polar liquid films is important for achieving reliable lubrication between moving mechanical parts separated by a nanometer-sized gap. To acquire this understanding, we conducted molecular dynamics (MD) simulations of diffusion phenomena of submonolayer polar perfluoropolyether (PFPE) Zdol films on solid surfaces. To improve the accuracy of these simulations, we developed an all-atom model that includes hydrogen-bond potential and refined atomic charges for Zdol molecules and tested it through MD simulations of spreading of step-shaped submonolayer PFPE films. Our MD simulations reproduced the experimentally observed effects of polar end groups on the diffusion speed and molecular conformation of Zdol. We then conducted MD simulations of self-diffusion of submonolayer Zdol films; these simulations demonstrated that as the thickness of the submonolayer Zdol films decreases, molecular conformation becomes flatter and the self-diffusion coefficient decreases. These changes in molecular conformation partially explain our experimental finding that the spreading of step-shaped submonolayer polar PFPE films slows down with decreasing initial thickness.     

Slow eye movement as a possible predictor of reaction delays to auditory warning alarms in a drowsy state

In recently developed intelligent vehicles, warning alarms are often used to prompt avoidance behaviours from drivers facing imminent hazardous situations. However, when critical reaction delays to auditory stimulation are anticipated, the alarm should be activated earlier to compensate for such delays. It was found that reaction times to an auditory stimulus significantly increased in the presence of slow eye movement (SEM), which is known to occur frequently during the wake-sleep transition. The reaction delay could not be attributed to temporal effects such as fatigue and was invariant regardless of response effectors (finger or foot). Moreover, it was found that applied pedal force decreased immediately after an auditory stimulus interrupted SEM. Consequently, it was concluded that SEM can be a good predictor of reaction delays to auditory warning alarms when drivers are in a drowsy state. STATEMENT OF RELEVANCE: The present study demonstrated that simple auditory reaction time significantly increased when SEM emerged. In the design of vehicle safety systems using warning alarms to prompt avoidance behaviours from drivers, such reaction delays during SEM must be taken into account.     

Accumulation of triosephosphate isomerase, with sequence homology to Beta amyloid peptides, in vessel walls of the newborn piglet hippocampus

We investigated whether beta-amyloid (Abeta)-like immunoreactivity was seen in the brains of newborn piglets. The immunoreactivity for Abeta(1-42) and Abeta(1-40) proteins, but not Abeta precursor protein, was present in CD68-positive perivascular cells of the hippocampus and in parts of the meninges. It was colocalized with immunoreactivity for receptor for advanced glycation end product and tumor necrosis factor-alpha. The protein with a molecular mass of 27 kDa, which was recognized by the Abeta antibodies, was identified as triosephosphate isomerase (TPI) with sequence homology to Abeta peptides by N-terminal amino acid sequencing, mass fingerprint analysis using matrix-associated laser desorption/ionization mass spectrometry, and Western blotting. Western blotting assay also revealed that detectable expression of Abeta proteins were not seen in the piglet brains. These findings indicate that TPI with sequence homology to Abeta peptides accumulates in perivascular cells of the microglia/macrophage lineage located around arterial vessels of the newborn piglet hippocampus.     

Patient views of adverse events: comparisons of self-reported healthcare staff attitudes with disclosure of accident information

In the present paper, we report results of surveys in 2003 in Japan and Denmark about patients' views about adverse events, focusing on the actions of healthcare staff involved in a medical accident. Results show that patients were more likely to indicate negative expectations to a doctor's reactions after a medical accident when asked in general terms than when asked in relation to concrete case stories. When asked in general terms, 66% (47%) of Japanese (Danish) respondents expected that doctors sometimes hold back on providing information to patients about a medical accident, while 37% (7%) did so when asked about a concrete, mild-outcome case. We examine some possible reasons for the relatively high level of distrust of Japanese patients, and we discuss whether the seemingly lower level of disclosure in Japan than in Denmark and the negative stories in the Japanese press may have an impact. We also suggest some implications for introducing a patient-centred or customer-centred approach to risk management in healthcare and other domains.