A dynamic linear programming approach to market allocation of renewable resources in the italian energy system: The case of solar thermal and biogas technologies

In Italy solar thermal energy and energy from biogas are two possible means of reducing dependence on energy imports. Using a multiperiod LP model (MARKAL) the authors assessed the likely potential of both technologies under various circumstances. The study covered the period 1980–2005, in five segments of five years. It focused only on the subsystem of the energy end-uses which can be substituted for by solar thermal and biogas technologies. The overall non-renewable sources which can be saved in 20 years by these technologies total 450 PJ (1 PJ = 10^{1 5} J) if the fuel prices rise at 0 per cent average annual, 1450 PJ if the fuel prices rise at 4.2 per cent average annual, 1860 PJ if the fuel prices rise at 7.2 per cent average annual and 3780 PJ if the fuel prices rise at 15 per cent average annual. However the most competitive technologies appear to be solar water heaters used mainly in the private and commercial sectors and biogas systems used mainly in the agricultural sector. The study was carried out by APRE under ENEA (formerly CNEN) contract and was intended to serve as an analytical basis for establishing an overall development and demonstration strategy for end-use renewable technologies in Italy.     

Organochlorine Contaminants of Wintering Ducks Foraging on Detroit River Sediments

Organochlorine analysis was performed on carcasses of 13 diving ducks from a 1981 wintering population that foraged on contaminated sediments in the lower Detroit River. Mean total PCB concentrations were 10 mg/kg for seven lesser scaups (Aythya affinis), 11 mg/kg for three greater scaups (A. marila), and 7.6 mg/kg for three goldeneyes (Bucephala clangula). Highest mean levels of other residues were measured for hexachlorobenzene (1.7 mg/kg) in goldeneyes, and transnonachlor (0.33 mg/kg) and 4,4’-DDE (1.3 mg/kg) in greater scaup. Quantitative analysis of 72 PCB congeners also was applied to water, seston, sediment, benthie oligochaetes, and carp from the same site. Principal congeners in most of the samples included some of the more toxic and persistent PCBs. Results of a multivariate analysis indicated that ratios of more conservative to less conservative PCBs did not vary significantly among ducks (α = .05), but differed from those in carp, oligochaetes, and sediment. For the February through March period of fat mobilization, concentrations of total PCB in lipid were inversely correlated with percent lipid (r = 0.76) in ducks. The percentage of conservative PCBs increased slightly. The distribution and partitioning of organochlorines, including toxic PCB congeners, varied considerably within this water column-sediment-fauna ecosystem. Estimates of toxic exposure based on total PCB values may be unreliable.     

The application of multivariat mathematical-statistical methods to the solution of problems in nutrition theory,nutritional economics and food technology Part 4. Optimization with n ≥ 2 effect variables

The milling industry faces the task of saving energy without impairing the quantity and quality of the products. By applying experimental plans for the optimization of several effect variables, approximations (compromise solutions) between the cause variables (conditioning parameters) and the effect variables (quantity and quality parameters) are sought, which satisfy the aims laid down.     

Analysis of conduction heat transfer problems in steady, 2D regions with circular holes using a special boundary integral method

A special boundary integral method developed for two-dimensional regions containing circular holes is used to calculate temperature and heat transfer on the boundaries of several selected regions. The geometrical configuration of the region is arbitrary and convective boundary conditions are assumed. An important feature of the method is analytic representation of temperature and its normal derivative on the interior circular holes in the form of a harmonic series. This makes the application of the boundary integral method convenient and free from conditioning problems associated with small interior boundaries. Heat transfer from circular isothermal interior holes are calculated for several illustrative examples using three terms of the harmonic series representation for heat transfer at each of the circular boundaries. The results are presented and discussed.     

A note on the use of conductimetry in brewery microbiological control

The growth in beer of 15 brewery strains of Lactobacillus was detected using the automatic conductance measuring technique afforded by the Malthus 8 Growth Analyser. 0·15% ammonium chloride was added to the beer as an electrolyte and sodium acetate was used to raise the pH from ca 4·0 to 4·2 or above. No measurable responses were obtained using unmodified beer. The value of the method for development in routine brewery microbiological control is briefly discussed.     

Characterization of the activated sludge and of the operating conditions of six SBR treating dairy effluent and operated at industrial scale.

The sludge from six SBRs treating dairy effluent and located at same geographical location, in North East of France, were collected to study their characteristic behavior. The six plants were designed and constructed by the same manufacturer and are working under quite similar operating conditions. The objective of the study was to observe if any similarity existed in the characteristics of the sludge collected from the SBRs. The sludge was characterized for morphological properties (filament index, floc size), settling, compressibility, suspended solids (SS) concentration. The sludge from each plant was different from the others in most of the characteristics. One sludge out of six (sludge G) was completely different from the others with a very degraded structure and low discrete settling and compression. This reactor was not working fully satisfactorily with a too high COD at outlet, probably because this SBR was undergoing repetitive overloading linked to a very bad recovery of the whey by the cheese maker. The five other SBRs were working fully satisfactorily but the characteristics of the five sludges were quite different from one sludge to another. The size of the flocs seemed to be the only parameter measured which could be correlated to the settling characteristics of the sludge. The sludge characteristics and the parameter correlations were also compared with that of municipal activated sludge and were found to be very different.     

Satellite SAR Remote Sensing of Great Lakes Ice Cover,Part 2. Ice Classification and Mapping

During the 1997 winter season, shipborne polarimetric backscatter measurements of Great Lakes (freshwater) ice types using the Jet Propulsion Laboratory C-band scatterometer, together with surface-based ice physical characterization measurements and environmental parameters, were acquired concurrently with Earth Resource Satellite 2 (ERS-2) and RADARSAT Synthetic Aperture Radar (SAR) data. This polarimetric data set, composed of over 20 variations of different ice types measured at incident angles from 0° to 60° for all polarizations, was processed to radar cross-section to establish a library of signatures (look-up table) for different ice types. The library is used in the computer classification of calibrated satellite SAR data. Computer analysis of ERS-2 and RADARSAT ScanSAR images of Great Lakes ice cover using a supervised classification technique indicates that different ice types in the ice cover can be identified and mapped, and that wind speed and direction can have an influence on the classification of water as ice based on single frequency, single polarization data. Once satellite SAR data are classified into ice types, the ice map provides important and necessary input for environmental protection and management, ice control and ice breaking operations, and ice forecasting and modeling efforts.     

Change in computer hardware and software paradigms

The change in the paradigm of the development of processors and software for the processors is considered. This change is caused by the continuous progress in the technology of semiconductor microchips that is described by Moore’s law.